Search NASA⌕ Search

Engineering topics

Dresel, P Evan

Publications and source records attributed to Dresel, P Evan.

Review: Technical and Policy Challenges in Deep Vadose Zone Remediation of Metals and Radionuclides

Remediation of contamination in the deep vadose zone is complicated by heterogeneous contaminant distribution and the difficulty of accessing the contaminant zone and delivering amendments. It is difficult to predict future contaminant movement with sufficient certainty for regulatory decisions, when contamination is left in place. This paper reviews major processes viable for deep vadose zone remediation. Chemical delivery technologies and hybrids combining several remediation mechanisms are considered valuable areas for research and development.

54 ENVIRONMENTAL SCIENCES↗

Geochemical Characterization of Chromate Contamination in the 100 Area Vadose Zone at the Hanford Site - Part 2

At the Hanford Site, chromate was used throughout the 100 Areas (100-B, 100-C, 100-D/DR, 100-F, 100-H, and 100 K) as a corrosion inhibitor in reactor cooling water. Chromate was delivered in rail cars, tanker trucks, barrels, and local pipelines as dichromate granular solid or stock solution. In many occasions, chromate was inevitably discharged to surface or near-surface ground through spills during handling, pipeline leaks, or during disposal to cribs. The composition of the liquids that were discharged is not known and it is quite possible that Cr(VI) fate and transport in the contaminated sediments would be a function of the chemical composition of the waste fluids. The major objectives of this investigation which was limited in scope by the financial resources available, were to 1) determine the leaching characteristics of hexavalent chromium [Cr(VI)] from contaminated sediments collected from 100-D Area spill sites; 2) elucidate possible Cr(VI) mineral and/or chemical associations that may be responsible for Cr(VI) retention in the Hanford Site 100 Areas through the use of macroscopic leaching studies, and microscale characterization of contaminated sediments; and 3) provide information to construct a conceptual model of Cr(VI) geochemistry in the Hanford 100 Area vadose zone that can be used for developing options for environmental remediation. The information gathered from this research effort will help to further improve our understanding of Cr(VI) behavior in the vadose zone and will also help in accelerating the 100 Area Columbia River Corridor cleanup by providing valuable information to develop remedial action based on a fundamental understanding of Cr(VI) vadose zone geochemistry. A series of column experiments were conducted with contaminated sediments to study Cr(VI) desorption patterns. Column experiments used the field size fraction of the sediment samples and a simulated Hanford Site groundwater solution. Periodic stop flow events were applied to evaluate the change in elemental concentration during time periods of no flow and greater fluid residence time. Sediments were characterized for the spatial and mineralogical associations of the contamination using some microscale techniques such as X-ray diffraction, scanning electron microscopy, energy dispersive spectroscopy, X-ray photoelectron spectroscopy, and Mössbauer spectroscopy.

54 ENVIRONMENTAL SCIENCES↗

Isotopic Tracking of Hanford 300 Area Derived Uranium in the Columbia River

A portion of the subsurface contamination at the Hanford Site, the former plutonium production facility in Washington State, affects the Columbia River. A component of this contamination, uranium (U), has variable isotopic composition due to nuclear industrial processes carried out at the site. This characteristic makes it possible to use high-precision isotopic measurements of U in environmental samples to identify even trace levels of contaminant U, determine its sources, and estimate discharge rates. Our data on river water samples indicate that as much as 3.2 kg/day can enter the Columbia River from the 300 Area of the Hanford Site, which is only a small fraction of the total load of dissolved natural background U carried by the Columbia River. This very low–level contamination can be discerned, despite further dilution to <1% of natural background U, as far as 350 km downstream from the Hanford Site. These results indicate that isotopic methods can allow the amounts of U contamination from the Hanford Site to be measured accurately enough to ascertain where they are an environmental concern, and where they are insignificant.

Christensen, John N.↗

Chromium transport in an acidic waste contaminated subsurface medium: The role of reduction

A series of wet chemical extractions and column experiments, combined with electron microprobe analysis (EMPA) and X-ray photoelectron spectroscopy (XPS) measurements, were conducted to estimate the extent of contaminant Cr(VI) desorption and determine the mechanism(s) of Cr(VI) attenuation in contaminated and naturally aged (decades) Hanford sediments which were exposed to dichromate and acidic waste solutions. Results from wet extractions demonstrated that contaminated sediments contained a large fraction of tightly-bound Cr. Results from column experiments showed that effluent Cr(VI) concentrations were low and only a small percentage of the total Cr inventory was released from the contaminated sediments, demonstrating again low Cr mobility. EMPA inspections showed that Cr contamination was spread throughout sediment matrix and high-concentrated Cr spots were not apparently present. XPS analyses showed that most surface Cr was Cr(III). Reduced Cr(III) was spatially associated with Fe, which occurred mostly as Fe(III). Neoprecipitates were most likely Cr(III) oxyhydroxides or [Cr(III) Fe(III)] solid solutions. Extensive reduction to Cr(III) limited dramatically mass flux from this source. The following multiple-step mechanism was most likely operational in the contaminated sediments: acid promoted dissolution of Fe(II)-bearing soil minerals and/or their surface coatings, release of Fe(II) in the aqueous phase, abiotic homogeneous and/or heterogeneous Cr(VI) reduction by aqueous, sorbed and/or structural Fe(II), formation of insoluble Cr(III) phases or [Cr(III) Fe(III)] solid solutions.

54 ENVIRONMENTAL SCIENCES↗

Foam Delivery of Calcium Polysulfide to Vadose Zone for Chromium-VI Immobilization: A Laboratory Evaluation

The delivery of calcium polysulfide (CPS) to the vadose zone using foam and the immobilization of hexavalent chromium [Cr(VI)] via reduction by the foam-delivered CPS was studied in a series of batch and column experiments. Batch tests were conducted to select the CPS-surfactant foam-generating solutions, to determine the solution foamibility and the reducing potential of CPS-containing foams, and to study the influence of foam quality, surfactant concentration, and CPS concentration on foam stability. Based on the results of the batch experiments, a foaming surfactant-CPS mixture was selected and a system was designed and constructed to generate and deliver foams with high reducing potential and stable enough to be successfully used Cr(VI) immobilization laboratory tests. Column experiments were conducted to test the delivery of the CPS-foam mixtures under conditions similar to field vadose zone, to determine the transport-controlled rate and extent of Cr(VI) immobilization using this novel technology, and to compare the results with those obtained from water-based CPS delivery. Soil reduction was observed in all column tests where CPS was delivered by foam flushing. The massive mobilization of aqueous Cr(VI) which occurred in water-based CPS delivery column experiments was remarkably minimized in the foam-based CPS delivery column experiments, resulting in significant Cr(VI) in-situ immobilization. The results confirmed that foam injection can be successfully used for CPS delivery and Cr(VI) immobilization via reduction in contaminated vadose zones. Due to its advantage over water-based injection, the foam delivery technology can also be for the delivery of other remedial amendments, such as citrate, acetate, and polyphosphate to promote bio-reduction of redox-sensitive contaminants or contaminant precipitation and co-precipitation.

54 ENVIRONMENTAL SCIENCES↗

Pathways of aqueous Cr(VI) attenuation in a slightly alkaline oxic subsurface

Column experiments combined with geochemical modeling, microscopic inspections and spectroscopic interrogations were conducted with four freshly or naturally aged contaminated sediments with concentrated Cr(VI) waste fluids. The objective was to determine sediment-dependent Cr(VI) desorption extent and rates, Cr(VI) physical location and soil mineral associations, and mechanism(s) of Cr(VI) attenuation under mild alkaline conditions. Results showed that majority of Cr(VI) mass was easily removed from all sediments. Equilibrium site Kd varied from 0 to 0.33 ml g-1 and equilibrium site fraction was greater than 95 %. In addition, long tailings of time-dependent Cr(VI) concentrations above Environmental Protection Agency maximum concentration limit (MCL) of 1.9 µmol L-1, were also observed (kinetic site Kd and desorption reaction half-life varied from 0 to 45 ml g-1, and 76.1 to 126 h, respectively). Aqueous phase pH, particle size distribution and pore water composition contributed to the variability observed among sediments. Microscopic and spectroscopic studies confirmed that Cr was concentrated within fine-grained coatings in small areas rich in phyllosilicates that contained mixed valence [Cr(III)/Cr(VI)]. However, Cr(VI) reduction was neither significant nor complete. The kinetically controlled Cr(VI) desorption may have resulted from the transport (diffusion) of Cr(VI) out of these areas. In summary, at least four pools of Cr(VI) with different leaching behavior might be present in sediments exposed to concentrated waste fluids: i.) The pool of highly mobile and easily removed Cr(VI) (over 95% of total Cr); ii.) The pool of Cr(VI) held in remote sites that provided a long-term continuing source of contaminant Cr; iii.) The pool of reduced immobile Cr(III) which was formed, most likely, by redox reactions of aqueous Cr(VI) and aqueous, sorbed, or structural Fe(II); vi.) The pool of sparingly soluble Cr(VI) phases (e.g., BaCrO4) or solid solutions which did not contribute to the overall Cr(VI) transport under these conditions.

54 ENVIRONMENTAL SCIENCES↗

Remediation of Deep Vadose Zone Radionuclide and Metal Contamination: Status and Issues

This report documents the results of a PNNL literature review to report on the state of maturity of deep vadose zone remediation technologies for metal contaminants including some radionuclides. Its recommendations feed into decisionmakers need for scientific information and cost-effective in situ remediation technlogies needed under DOE's Environmental Management initiative Enhanced Remediation Methods: Scientific & Technical Basis for In Stu Treatment Systems for Metals and Radionuclides.

54 ENVIRONMENTAL SCIENCES↗

Geochemical Characterization of Chromate Contamination in the 100 Area Vadose Zone at the Hanford Site

The major objectives of the proposed study were to: 1.) determine the leaching characteristics of hexavalent chromium [Cr(VI)] from contaminated sediments collected from 100 Area spill sites; 2.) elucidate possible Cr(VI) mineral and/or chemical associations that may be responsible for Cr(VI) retention in the Hanford Site 100 Areas through the use of i.) macroscopic leaching studies and ii.) microscale characterization of contaminated sediments; and 3.) provide information to construct a conceptual model of Cr(VI) geochemistry in the Hanford 100 Area vadose zone. In addressing these objectives, additional benefits accrued were: (1) a fuller understanding of Cr(VI) entrained in the vadose zone that will that can be utilized in modeling potential Cr(VI) source terms, and (2) accelerating the Columbia River 100 Area corridor cleanup by providing valuable information to develop remedial action based on a fundamental understanding of Cr(VI) vadose zone geochemistry. A series of macroscopic column experiments were conducted with contaminated and uncontaminated sediments to study Cr(VI) desorption patterns in aged and freshly contaminated sediments, evaluate the transport characteristics of dichromate liquid retrieved from old pipelines of the 100 Area; and estimate the effect of strongly reducing liquid on the reduction and transport of Cr(VI). Column experiments used the < 2 mm fraction of the sediment samples and simulated Hanford groundwater solution. Periodic stop-flow events were applied to evaluate the change in elemental concentration during time periods of no flow and greater fluid residence time. The results were fit using a two-site, one dimensional reactive transport model. Sediments were characterized for the spatial and mineralogical associations of the contamination using an array of microscale techniques such as XRD, SEM, EDS, XPS, XMP, and XANES. The following are important conclusions and implications. Results from column experiments indicated that most of contaminant Cr travels fast through the sediments and appears as Cr(VI) in the effluents. The significance of this for groundwater concentrations would, however, depend on the mass flux of recharge to the water table. adsorption of Cr(VI) to sediments from spiked Cr(VI) solution is low; calculated retardation coefficients are close to one. Calcium polysulfide solutions readily reduced Cr(VI) to Cr(III) in column experiments. However a significant amount of the Cr(VI) was mobilized ahead of the polysulfide solution front. This has significant implications for in-situ reductive remediation techniques. The experiments suggest that it would be difficult to design a remedial measure using infiltration of liquid phase reductants without increasing transport of Cr(VI) toward the water table. The microscopic characterization results are consistent with the column studies. Cr(VI) is found as ubiquitous coatings on sediment grain surfaces. Small, higher concentration, chromium sites are associated with secondary clay mineral inclusions, with occasional barium chromate minerals, and reduced to Cr(III) in association with iron oxides that are most likely magnetite primary minerals. Within the restricted access domains of sediment matrix, ferrous iron could also diffuse from in situ, high-surface-area minerals to cause the reductive immobilization of chromate. This process may be favored at microscale geochemical zones where ferrous iron could be supplied. Once nucleated, micrometer-scale precipitates are favored as growing locales for further accumulation, causing the formation of discrete zones of Cr(III).

54 ENVIRONMENTAL SCIENCES↗

Environmental Applications of Stable Xenon and Radioxenon Monitoring

Improved detection capabilities are needed at several Department of Energy sites to make remedial decisions about facilities and landfill cleanup. For facility monitoring air samples can be collected from within a facility and analyzed for short lived radioxenons to estimate inventories of residual plutonium holdup within the facility. For landfill cleanup activities soil gas sampling for xenon isotopes can be used to define the locations of spent fuel and transuranic wastes. Short-lived radioxenon isotopes are continuously produced by spontaneous fission of plutonium-240 in transuranic wastes. Large volume soil-gas samples provide extremely sensitive measurement of radioxenon in the subsurface; a characteristic of transuranic waste. The analysis employs a modified Automated Radioxenon Sampling and Analysis (ARSA) system. Proof of principle measurements at a Hanford Site liquid waste disposal site showed xenon-133 at levels in soil gas are approximately 16,000 times the detection limit and lower levels of xenon-135 from the spontaneous fission of plutonium-240 were also measured. Stable xenon isotopes are also produced by spontaneous fission but are subject to background concentrations in ambient air samples (facilities) but less so in soil gas where free exchange with ambient air is restricted. Rare gas mass spectrometry is used for highly precise stable xenon isotopic measurements. Stable xenon isotopic ratios from fission are distinct from natural xenon background ratios. Neutron capture on xenon-135 produces an excess of xenon-136 above fission ratios and thus provides a means of distinguishing reactor sources (e.g. spent fuel) from separated transuranic materials (plutonium).

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Appendix G: Geochemistry

This appendix discusses the geology of the Hanford Site and singe-shell tank (SST) waste management areas (WMAs). The purpose is to provide the most recent geochemical information available for the SST WMAs and the Integrated Disposal Facility. This appendix summarizes the information in the geochemistry data package for the SST WMAs.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗