HPC-GPT: Integrating Large Language Model for High-Performance Computing
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Du, W.
Explore the source record for details and available documents.
Purpose: Modern IMRT relies on computers to generate treatment plans of varied complexity. A highly complex treatment plan may use a large number of small and irregular beam apertures in order to achieve high dose conformity. However, excessive beam complexity can increase dosimetric uncertainty, prolong treatment time, and increase susceptibility to target or organ motion. In this study we sought to develop metrics to assess the complexity of IMRT beams and plans. Methods: Based the information of leaf positions and MU for each beam segment, we calculated the following beam complexity metrics: aperture area, shape irregularity, and beam modulation. Then these beam complexity metrics were averaged to obtain the corresponding plan complexity metrics, using the beam MUs as weighting factors. We evaluated and compared the beam and plan complexity scores for 65 IMRT plans from 3 sites (prostate, head and neck, and spine). We also studied how the plan complexity scores were affected by adjusting inverse planning parameters. Results: For prostate IMRT, the lateral beams had large MUs and smaller shape irregularity, while the anterior or posterior beams had larger modulation values. On average, the prostate IMRT plans had the smallest shape irregularity and beam modulation; the HN IMRT plans had the largest aperture area, shape irregularity, and beam modulation; and the spine stereotactic IMRT plans often had small aperture area, which may be associated with relatively large discrepancies between calculated and measures doses. The plan complexity increased as the number of optimization iterations and the number of beam segments increased and as the minimum segment area decreased. Conclusion: Complexity of IMRT beams and plans were quantified in terms of aperture area, shape irregularity and beam modulation. The complexity metrics varied among IMRT plans for different disease sites and were affected when the planning parameters were adjusted.
In this study, carbon supported Ir-Ru nanoparticles with average sizes ranging from 2.9 to 3.7 nm were prepared using a polyol method. The combined characterization techniques, that is, scanning transmission electron microscopy equipped with electron energy loss spectroscopy, high resolution transmission electron microscopy, energy dispersive X-ray spectroscopy, and X-ray diffraction, were used to determine an Ir-Ru alloy nanostructure. Both cyclic voltammetry and chronoamperometry (CA) results demonstrate that Ir{sub 77}Ru{sub 23}/C bears superior catalytic activities for the ethanol oxidation reaction compared to Ir/C and commercial Pt/C catalysts. In particular, the Ir{sub 77}Ru{sub 23}/C catalyst shows more than 21 times higher mass current density than that of Pt/C after 2 h reaction at a potential of 0.2 V vs Ag/AgCl in CA measurement. Density functional theory simulations also demonstrate the superiority of Ir-Ru alloys compared to Ir for the ethanol oxidation reaction.
Adopting the SPECTRUM package, which is a stellar spectral synthesis program, we have synthesized a comprehensive set of 2890 near-infrared (NIR) synthetic spectra with a resolution and wavelength sampling similar to the Sloan Digital Sky Survey (SDSS) and the forthcoming Large Sky Area Multi-Object Fiber Spectroscopic Telescope (LAMOST) spectra. During the synthesis, we applied the 'New grids of ATLAS9 Model Atmosphere' to develop a grid of local thermodynamic equilibrium model atmospheres for effective temperatures (T{sub eff}) ranging from 3500 to 7500 K, for surface gravities (log g) from 0.5 to 5.0 dex, for metallicities ([Fe/H]) from -4.0 to 0.5 dex, and for solar ([{alpha}/Fe] = 0.0 dex) and non-solar ([{alpha}/Fe] = +0.4 dex) abundances. This synthetic stellar library is composed of 1350 solar scaled abundance (SSA) and 1530 non-solar scaled abundance (NSSA) spectra, grounding on which we have defined a new set of NIR Ca II triplet indices and an index CaT as the sum of the three. These defined indices were automatically measured on every spectrum of the synthetic stellar library and calibrated with the indices computed on the observational spectra from the INDO-U.S. stellar library. In order to check the effect of {alpha}-element enhancement on the so-defined Ca II indices, we compared indices measured on the SSA spectra with those on the NSSA ones at the same trine of stellar parameters (T{sub eff}, log g, [Fe/H]); luckily, little influences of {alpha}-element enhancement were found. Furthermore, comparisons of our synthetic indices with the observational ones from measurements on the INDO-U.S. stellar library, the SDSS-DR7 and SDSS-DR8 spectroscopic survey are presented, respectively, for dwarfs and giants in specific. For dwarfs, our synthetic indices could well reproduce the behaviors of the observational indices versus stellar parameters, which verifies the validity of our index definitions for dwarfs. For giants, the consistency between our synthetic indices and the observational ones does not appear to be as good. However, a new synthetic library of NIR Ca II indices has been founded for deeper studies on the NIR wave band of stellar spectra, and this library is particularly appropriate for the SDSS and the forthcoming LAMOST stellar spectra. We have regressed the strength of the CaT index as a function of stellar parameters for both dwarfs and giants after a series of experimental investigations into relations of the indices with stellar parameters. For dwarfs, log g has little effect on the indices, while [Fe/H] and T{sub eff} play a role together. The leading factor is probably [Fe/H], which changes the strength of the indices by a positive trend. For giants, log g starts to influence the strength of the indices by a negative trend for the metal-poor, and even impact deeply for the metal-rich; besides, [Fe/H] and T{sub eff} still matter. In addition, we briefly discussed the major differences between our Ca II triplet indices and the CaHK doublet indices. Ultimately, a supplemental experiment was carried out to show that spectral noises do have effects on our set of NIR Ca II indices. However, the influence is not weak enough to be ignored if the signal-to-noise ratio falls below 20.
In this paper, we present a study of a series of carbon-supported Pd-Sn binary alloyed catalysts prepared through a modified Polyol method as anode electrocatalysts for direct ethanol fuel cell reactions in an alkaline medium. Transmission electron microscopy, energy-dispersive X-ray spectroscopy, X-ray diffraction, X-ray photoelectron spectroscopy, and aberration-corrected scanning transmission electron microscopy equipped with electron energy loss spectroscopy were used to characterize the Pd-Sn/C catalysts, where homogeneous Pd-Sn alloys were determined to be present with the surface Sn being partially oxidized. Among various Pd-Sn catalysts, Pd{sub 86}Sn{sub 14}/C catalysts showed much enhanced current densities in cyclic voltammetric and chronoamperometric measurements, compared to commercial Pd/C (Johnson Matthey). The overall rate law of ethanol oxidation reaction for both Pd{sub 86}Sn{sub 14}/C and commercial Pd/C were also determined, which clearly showed that Pd{sub 86}Sn{sub 14}/C was more favorable in high ethanol concentration and/or high pH environment. Density functional theory calculations also confirmed Pd-Sn alloy structures would result in lower reaction energies for the dehydrogenation of ethanol, compared to the pure Pd crystal.
Carbon supported ternary Pt{sub 52}Sn{sub (36-x)}Rh{sub 12}-Sn{sub x}O{sub 2x} electrocatalysts with the average diameter of 2.8 {+-} 0.5 nm were synthesized using a Polyol process followed by thermal treatment. Several techniques including high resolution transmission electron microscopy (HRTEM), X-ray diffraction (XRD) and extended X-ray absorption fine structure (EXAFS) were used to identify the coexistence of homogeneously distributed Pt/Sn/Rh random alloy and non-alloyed SnO{sub 2} throughout the catalyst. The Pt{sub 52}Sn{sub (36-x)}Rh{sub 12}-Sn{sub x}O{sub 2x} catalyst showed a superior long-term activity and stability towards ethanol oxidation than the commercial Pt catalyst. Our data of ternary Pt/Sn/Rh catalysts with different chemical compositions and crystalline structures also indicated that the superior performance of Pt{sub 52}Sn{sub (36-x)}Rh{sub 12}-Sn{sub x}O{sub 2x} might result from the electronic effect of the Pt/Sn/Rh random alloy.
Electrocatalytic activities of Pt and their alloys toward small organic molecules oxidation are highly dependent on their morphology, chemical composition, and electronic structure. Here, we report the synthesis of dendrite-like Pt{sub 95}Bi{sub 5}, Pt{sub 83}Bi{sub 17}, and Pt{sub 76}Bi{sub 24} nanowires network with a high aspect ratio (up to 68). The electronic structure and heterogeneous crystalline structure have been studied using combined techniques, including aberration-corrected scanning transmission electron microscopy (STEM) and X-ray absorption near-edge structure (XANES) spectroscopy. Bismuth-oriented attachment growth mechanism has been proposed for the anisotropic growth of Pt/Bi. The electrochemical activities of Pt/Bi nanowires network toward ethanol oxidations have been tested. In particular, the as-made Pt{sub 95}Bi{sub 5} appears to have superior activity toward ethanol oxidation in comparison with the commercial Pt/C catalyst. The reported promotional effect of Bi on the formation of Pt/Bi and electrochemical activities will be important to design effective catalysts for ethanol fuel cell application.
Carbon supported ternary Pt{sub 52}Sn{sub (36-x)}Rh{sub 12}-Sn{sub x}O{sub 2x} electrocatalysts with the average diameter of 2.8 {+-} 0.5 nm were synthesized using a Polyol process followed by thermal treatment. Several techniques including high resolution transmission electron microscopy (HRTEM), X-ray diffraction (XRD) and extended X-ray absorption fine structure (EXAFS) were used to identify the coexistence of homogeneously distributed Pt/Sn/Rh random alloy and non-alloyed SnO{sub 2} throughout the catalyst. The Pt{sub 52}Sn{sub (36-x)}Rh{sub 12}-Sn{sub x}O{sub 2x} catalyst showed a superior long-term activity and stability towards ethanol oxidation than the commercial Pt catalyst. Our data of ternary Pt/Sn/Rh catalysts with different chemical compositions and crystalline structures also indicated that the superior performance of Pt{sub 52}Sn{sub (36-x)}Rh{sub 12}-Sn{sub x}O{sub 2x} might result from the electronic effect of the Pt/Sn/Rh random alloy.
Electrocatalytic activities of Pt and their alloys toward small organic molecules oxidation are highly dependent on their morphology, chemical composition, and electronic structure. Here, we report the synthesis of dendrite-like Pt{sub 95}Bi{sub 5}, Pt{sub 83}Bi{sub 17}, and Pt{sub 76}Bi{sub 24} nanowires network with a high aspect ratio (up to 68). The electronic structure and heterogeneous crystalline structure have been studied using combined techniques, including aberration-corrected scanning transmission electron microscopy (STEM) and X-ray absorption near-edge structure (XANES) spectroscopy. Bismuth-oriented attachment growth mechanism has been proposed for the anisotropic growth of Pt/Bi. The electrochemical activities of Pt/Bi nanowires network toward ethanol oxidations have been tested. In particular, the as-made Pt{sub 95}Bi{sub 5} appears to have superior activity toward ethanol oxidation in comparison with the commercial Pt/C catalyst. The reported promotional effect of Bi on the formation of Pt/Bi and electrochemical activities will be important to design effective catalysts for ethanol fuel cell application.
N/A