Engineering topics

Dudko, G.

Publications and source records attributed to Dudko, G..

3 records

DOE OSTI2018

Nonreciprocity of backward volume spin wave beams excited by the curved focusing transducer

The focusing effect for spin waves excited by a curved micrometer-sized coplanar waveguide transducer on top of a 5-μm-thick epitaxial yttrium iron garnet film is studied by means of the micro-focused Mandelstam-Brillouin light scattering technique and micromagnetic simulations. The curvilinear transducer is designed to focus the backward volume spin waves on the in-plane bias magnetic field applied along the symmetry axis of the transducer. We show that two-dimensional maps of spin wave intensity exhibit nonreciprocal properties without mirror symmetry with respect to the magnetic field direction and the focusing effect. The observed effects are the consequence of nonreciprocity of the backward volume spin waves travelling at an angle toward the bias field direction.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2017

Effects of the magnetic field variation on the spin wave interference in a magnetic cross junction

This article reports results of the investigation of the effect of the external magnetic field variation on the spin wave interference in a magnetic cross junction. The experiments were performed using a micrometer scale Y 3 Fe 5 O 12 cross structure with a set of micro-antennas fabricated on the edges of the cross arms. Two of the antennas were used for the spin wave excitation while a third antenna was used for detecting the inductive voltage produced by the interfering spin waves. It was found that a small variation of the bias magnetic field may result in a significant change of the output inductive voltage. The effect is most prominent under the destructive interference condition. The maximum response exceeds 30 dB per 0.1 Oe at room temperature. It takes a relatively small bias magnetic field variation of about 1 Oe to drive the system from the destructive to the constructive interference conditions. The switching is accompanied by a significant, up to 50 dB, change in the output voltage. The obtained results demonstrate a feasibility of the efficient spin wave interference control by an external magnetic field, which may be utilized for engineering novel type of magnetometers and magnonic logic devices.

36 MATERIALS SCIENCE↗

DOE OSTI2017

A Magnetometer Based on a Spin Wave Interferometer

Here, we describe a magnetic field sensor based on a spin wave interferometer. Its sensing element consists of a magnetic cross junction with four micro-antennas fabricated at the edges. Two of these antennas are used for spin wave excitation while two other antennas are used for detection of the inductive voltage produced by the interfering spin waves. Two waves propagating in the orthogonal arms of the cross may accumulate significantly different phase shifts depending on the magnitude and direction of the external magnetic field. This phenomenon is utilized for magnetic field sensing. The sensitivity attains its maximum under the destructive interference condition, where a small change in the external magnetic field results in a drastic increase of the inductive voltage, as well as in the change of the output phase. We report experimental data obtained for a micrometer scale Y 3 Fe 2 (FeO 4 ) 3 cross structure. The change of the inductive voltage near the destructive interference point exceeds 40 dB per 1 Oe. The phase of the output signal exhibits a π-phase shift within 1 Oe. The data are collected at room temperature. Taking into account the low thermal noise in ferrite structures, we estimate that the maximum sensitivity of the spin wave magnetometer may exceed attotesla.

47 OTHER INSTRUMENTATION↗