Engineering topics

Dursch, Harry

Publications and source records attributed to Dursch, Harry.

At least 19 records

NASA NTRS1995

Analysis of systems hardware flown on LDEF: New findings and comparison to other retrieved spacecraft hardware

The Long Duration Exposure Facility (LDEF) was retrieved in 1990 after spending 69 months in low-earth-orbit (LEO). A wide variety of mechanical, electrical, thermal, and optical systems, subsystems, and components were flown on LDEF. The Systems Special Investigation Group (Systems SIG) was formed by NASA to investigate the effects of the 69 month exposure on systems related hardware and to coordinate and collate all systems analysis of LDEF hardware. This report is the Systems SIG final report which updates earlier findings and compares LDEF systems findings to results from other retrieved spacecraft hardware such as Hubble Space Telescope. Also included are sections titled (1) Effects of Long Duration Space Exposure on Optical Scatter, (2) Contamination Survey of LDEF, and (3) Degradation of Optical Materials in Space.

Dursch, Harry↗

NASA NTRS1995

Summary and review of Materials Special Investigation Group evaluations of hardware from the Long Duration Exposure Facility

Major materials findings obtained during LDEF post-flight investigations over the past three and one-half years are reported. The summary of findings to date includes results for thermal control coatings, thin polymeric films, composites, metals, adhesives, contamination, and environments definitions. Reaction rates of selected materials exposed to atomic oxygen are presented. Results useful for model verification and comparison with ground based facility data are specifically highlighted. Potential areas for future work are described. In conclusion, a rationale for a second long term flight experiment is presented.

Whitaker, Ann F.↗

NASA NTRS1995

LDEF systems special investigation group overview

The Systems Special Investigation Group (Systems SIG), formed by the LDEF Project Office to perform post-flight analysis of LDEF systems hardware, was chartered to investigate the effects of the extended LDEF mission on both satellite and experiment systems and to coordinate and integrate all systems related analyses performed during post-flight investigations. The Systems SIG published a summary report in April, 1992 titled 'Analysis of Systems Hardware Flown on LDEF - Results of the Systems Special Investigation Group' that described findings through the end of 1991. The Systems SIG, unfunded in FY 92 and FY93, has been funded in FY 94 to update this report with all new systems related findings. This paper provides a brief summary of the highlights of earlier Systems SIG accomplishments and describes tasks the Systems SIG has been funded to accomplish in FY 94.

Mason, Jim↗

NASA NTRS1995

Space environmental effect on solar cells: LDEF and other flight tests

This paper summarizes results of several experiments flown on the Long Duration Exposure Facility (LDEF) to examine the effects of the space environment on materials and technologies to be used in solar arrays. The various LDEF experiments are compared to each other as well as to other solar cell flight data published in the literature. Data on environmental effects such as atomic oxygen, ultraviolet light, micrometeoroids and debris, and charged particles are discussed in detail. The results from the LDEF experiments allow us to draw several conclusions. Atomic oxygen erodes unprotected silver interconnects, unprotected Kapton, and polymer cell covers, but certain dielectric coatings can protect both silver and Kapton. Cells that had wrap-around silver contacts sometimes showed erosion at the edges, but more recently developed wrap-through cells are not expected to have these problems. Micrometeoroid and debris damage is limited to the area close to the impact, and microsheet covers provide the cells with some protection. Damage from charged particles was as predicted, and the cell covers provided adequate protection. In general, silicon cells with microsheet covers showed very little degradation, and solar modules showed less than 3 percent degradation, except when mechanically damaged. The solar cell choices for the Space Station solar array are supported by the data from LDEF.

Gruenbaum, Peter↗

NASA NTRS1993

Summary of materials and hardware performance on LDEF

A wide variety of materials and experiment support hardware were flown on the Long Duration Exposure Facility (LDEF). Postflight testing has determined the effects of the almost 6 years of low-earth orbit (LEO) exposure on this hardware. An overview of the results are presented. Hardware discussed includes adhesives, fasteners, lubricants, data storage systems, solar cells, seals, and the LDEF structure. Lessons learned from the testing and analysis of LDEF hardware is also presented.

Dursch, Harry↗

NASA NTRS1993

Resin transfer molding of textile composites

The design and manufacture of textile composite panels, tubes, and angle sections that were provided to NASA for testing and evaluation are documented. The textile preform designs and requirements were established by NASA in collaboration with Boeing and several vendors of textile reinforcements. The following four types of preform architectures were used: stitched uniweave, 2D-braids, 3D-braids, and interlock weaves. The preforms consisted primarily of Hercules AS4 carbon fiber; Shell RSL-1895 resin was introduced using a resin transfer molding process. All the finished parts were inspected using ultrasonics.

Falcone, Anthony↗

NASA NTRS1993

Evaluation of seals, lubricants, and adhesives used on LDEF

A wide variety of seals, lubricants, and adhesives were used on the Long Duration Exposure Facility (LDEF). The results, to date, of the Systems Special Investigation Group (SIG) and the Materials SIG investigation into the effect of the long term low Earth orbit (LEO) exposure on these materials is discussed. Results of this investigation show that if the material was shielded from exposure to LDEF's external environment, the 69 month exposure to LEO had minimal effect on the material. However, if the material was on LDEF's exterior surface, a variety of events occurred ranging from no material change, to changes in mechanical or physical properties, to complete disappearance of the material. The results are from the following sources: (1) visual examinations and/or testing of materials performed by various LDEF experimenters, (2) testing done at Boeing in support of the Materials or Systems SIG investigations, (3) testing done at Boeing on Boeing hardware flown on LDEF.

Dursch, Harry↗

NASA NTRS1993

Overview of the Systems Special Investigation Group investigation

The Long Duration Exposure Facility (LDEF) carried a remarkable variety of electrical, mechanical, thermal, and optical systems, subsystems, and components. Nineteen of the fifty-seven experiments flown on LDEF contained functional systems that were active on-orbit. Almost all of the other experiments possessed at least a few specific components of interest to the Systems Special Investigation Group (Systems SIG), such as adhesives, seals, fasteners, optical components, and thermal blankets. Almost all top level functional testing of the active LDEF and experiment systems has been completed. Failure analysis of both LDEF hardware and individual experiments that failed to perform as designed has also been completed. Testing of system components and experimenter hardware of interest to the Systems SIG is ongoing. All available testing and analysis results were collected and integrated by the Systems SIG. An overview of our findings is provided. An LDEF Optical Experiment Database containing information for all 29 optical related experiments is also discussed.

Mason, James B.↗

NASA NTRS1992

Results from the testing and analysis of LDEF batteries

Batteries were used on the Long Duration Exposure Facility (LDEF) to provide power to both the active experiments and the experiment support equipment such as the Experiment Initiative System, Experiment Power and Data System (data acquisition system), and the Environment Exposure Control Canisters. Three different types of batteries were used: lithium sulfur dioxide (LiSO2), lithium carbon monofluoride (LiCF), and nickel cadmium (NiCd). A total of 92 LiSO2, 10 LiCF, and 1 NiCd batteries were flown on the LDEF. In addition, approximately 20 LiSO2 batteries were kept in cold storage at NASA LaRC. The various investigations and post-flight analyses of the flight and control batteries are reviewed. The primary objectives of these studies was to identify degradation modes (if any) of the batteries and to provide information useful to future spacecraft missions. Systems SIG involvement in the post-flight evaluation of LDEF batteries was two-fold: (1) to fund SAFT (original manufacturer of the LiSO2 batteries) to perform characterization of 13 LiSO2 batteries (10 flight and 3 control batteries); and (2) to integrate investigator results.

Spear, Steve↗

NASA NTRS1992

Effects of long-term exposure on LDEF fastener assemblies

This presentation summarizes the Systems Special Investigations Group (SIG) findings from testing and analysis of fastener assemblies used on the Long Duration Exposure Facility (LDEF) structure, the tray mounting clamps, and by the various experimenters. The LDEF deintegration team and several experimenters noted severe fastener damage and hardware removal difficulties during post-flight activities. The System SIG has investigated all reported instances, and in all cases examined to date, the difficulties were attributed to galling during installation or post-flight removal. To date, no evidence of coldwelding was found. Correct selection of materials and lubricants as well as proper mechanical procedures is essential to ensure successful on-orbit or post-flight installation and removal of hardware.

Spear, Steve↗

NASA NTRS1992

Results from testing and analysis of solar cells flown on LDEF

A brief discussion of the solar cell experiments flown on the Long Duration Exposure Facility (LDEF) is provided. The information presented is a collation of results published by the various experimenters. This process of collation and documentation is an ongoing Systems Special Investigation Group (SIG) effort. There are four LEO environments, operating individually and/or synergistically, that cause performance loss in solar cells: meteoroid and space debris, atomic oxygen, ultraviolet radiation, and charged particle radiation. In addition, the effects of contamination caused by outgassing of materials used on the specific spacecraft play a role in decreasing the light being transmitted through the coverglass and adhesive to the solar cell. From the results presented on the solar cells aboard LDEF, the most extensive degradation of the solar cells came from impacts and the resulting cratering. The extent of the damage to the solar cells was largely dependent upon the size and energy of the meteoroids or space debris. The other cause of degradation was reduced light reaching the solar cell. This was caused by contamination, UV degradation of coverglass adhesive, and/or atomic oxygen/UV degradation of antireflection coatings.

Dursch, Harry↗

NASA NTRS1992

Space environmental effects on LDEF composites: Leading graphite/epoxy panel, selected trailing edge specimens

The composite electronics-module cover for the leading edge (row D9) experiment M0003-8 was fabricated from T300 graphite/934 epoxy unidirectional prepreg tape in a multi-oriented layup. This panel contained thermal control coatings in three of the four quadrants with the fourth quadrant left uncoated as a control. The composite experienced different thermal cycling extremes in each quadrant due to the differing optical properties of the coatings. Results will be presented on microcracking and other Low Earth Orbital (LEO) effects on the coated panel substrate.

Dursch, Harry↗

NASA NTRS1992

Evaluation of seals, lubricants, and adhesives used on LDEF

A wide variety of seals, lubricants, and adhesives were used on LDEF. This paper will discuss the ongoing Materials Special Investigations Group investigation into the effect of the long term exposure of these various materials to the Low Earth Orbit (LEO) environment. This investigation includes the testing of hardware at Boeing, documenting and collating experimenter test results, and deriving 'lessons learned.'

Pippin, H. Gary↗

NASA NTRS1992

Overview of the systems special investigation

The Systems Special Investigation Group (SIG), formed by the Long Duration Exposure Facility (LDEF) Project Office to perform post flight analysis of systems hardware, was chartered to investigate the effects of the extended LDEF mission on both satellite and experiment systems and to coordinate and integrate all systems analysis performed in post flight investigations. Almost all of the top level functional testing of the active experiments has been completed, but many components are still under investigation by either the Systems SIG or individual experimenters. Results reported to date have been collected and integrated by the Systems SIG and an overview of the current results and the status of the Systems Investigation are presented in this paper.

Mason, James B.↗

NASA NTRS1992

Mechanisms flown on LDEF

A wide variety of mechanisms were flown on the Long Duration Exposure Facility (LDEF). These include canisters, valves, gears, drive train assemblies, and motors. This report will provide the status of the Systems SIG effort into documenting, integrating, and developing 'lessons learned' for the variety of mechanisms flown on the LDEF. Results will include both testing data developed by the various experimenters and data acquired by testing of hardware at Boeing.

Dursch, Harry↗

NASA NTRS1992

Survey of results from the Boeing modules on the M0003 experiment on LDEF

The Boeing Company provided specimens to be flown on the Long Duration Exposure Facility (LDEF) as part of the M0003 experiment. This hardware was for the M0003-8 and part of the M003-10 sub-experiments. These specimens were flown on the leading (tray D-9) and trailing (tray D-3) edges, and on trays D-8 (38 degrees from ram) and D-4. Some specimens were mounted in the Experiment Exposure Control Canisters.

Pippin, H. Gary↗

NASA NTRS1992

On-orbit coldwelding: Fact or friction?

A study into the potential of on-orbit coldwelding occurring was completed. No instances of cold welding were found during deintegration and subsequent testing and analysis of LDEF hardware. This finding generated wide interest and indicated the need to review previous on-orbit coldwelding experiments and on-orbit spacecraft anomalies to determine whether the absence of coldwelding on LDEF was to be expected. Results show that even though there have been no documented cases of significant on-orbit coldwelding events occurring, precautions should be taken to ensure that neither coldwelding nor galling occurs in the space or prelaunch environment.

Dursch, Harry↗

NASA NTRS1991

Survey of results from the Boeing modules on the M0003 experiment on LDEF

The Boeing modules on the M0003 experiment included fiber optics, ceramic materials, a variety of electronic piece parts, composites and thermal control paints, fasteners, thin film lubricants, anodized surfaces, and adhesives. These materials were flown on the leading and trailing edge exteriors, and on the interior portion of LDEF M0003 providing exposure under three distinct environments. The condition of each of these material types is described. Results of optical, surface, and mechanical properties are presented.

Pippin, H. Gary↗