Search NASA⌕ Search

Engineering topics

Dyer, J. A.

Publications and source records attributed to Dyer, J. A..

Strategies for Lime Treatment Of D-Area Coal Storage Area (484-17D) Vadose Zone Soil

Sixty years of coal storage operations in the DCSA (484-17D, Figure 1) have resulted in vadose zone soils with a total acidity level typical of acid mine drainage soils. Field measurements from June 2018 show soil pH values ranging from 3 to 4.5 to water-table depth (10 to 12 feet). Best estimates for treatment of the acidic soils with dolomitic (agricultural) limestone suggest a required application rate ranging from 8 to 10 tons per acre per foot of soil depth to raise the soil pH from 3.5 to 5.5. The model predicts a lower bound of 3 tons per acre per foot for high-quality limestone with a particle size less than 60-mesh and an upper bound of 19 tons per acre per foot for lower-quality limestone. This compares to typical residential and agricultural lime application rates of one to four tons per acre per foot of depth.

01 COAL, LIGNITE, AND PEAT↗

Evaluation of The Risk of Solids Formation in the 2H Evaporator System

Savannah River Remediation (SRR) Tank Farm Engineering requested technical assistance from the Savannah River National Laboratory (SRNL) to troubleshoot recent and rapid plugging of the 2H Evaporator gravity drain line (GDL) to the Evaporator Drop Tank (currently Tank 38) with unwanted solids of unknown composition and to evaluate the risk of solids formation in the 2H Evaporator system moving forward. The GDL to Tank 38 recently plugged twice within hours of startup, resulting in a one-month shutdown both times. SRNL was asked to simulate current and historic (2016 to 2017) aqueous feed chemistries in the Evaporator Feed Tank (currently Tank 43) using the OLI Systems software to determine the mass of precipitated salts that would be expected to form under 2H Evaporator operating conditions for a range of concentration factors (i.e., evaporator overhead-to-feed volume ratio). A recommended evaporator concentration factor was determined based on the current Tank 43 feed composition to minimize solids formation and extend the time between shutdowns. Current and historic (2016 to 2017) aqueous chemistries in Tank 38 were also evaluated for completeness.

42 ENGINEERING↗

Software Quality Assurance Plan for the Geochemist’s Workbench®

The Geochemist’s Workbench® (GWB) Release 10.0.10 is a geochemical modeling suite for simulating the reactive fate and transport of radionuclides and other metals in aqueous systems including groundwater, surface water, soil, and sediment. At the Savannah River National Laboratory, GWB plays an important role in the preparation of Performance Assessments involving cementitious materials. The software classification for GWB is Level “C.” GWB was purchased from Aqueous Solutions LLC and came into existence outside of the Software Quality Assurance procedures; therefore, it is considered “existing/acquired” software. This Software Quality Assurance Plan addresses verification techniques and the required life cycle components for Level “C” existing/acquired software (i.e., “Evaluation,”“Configuration Control,” and “Cyber Security Analysis”) with other elements optionally applied using a graded approach.

58 GEOSCIENCES↗

Geochemical Model of E h and pH Transitions in Pore Fluids during Saltstone and SDU Concrete Aging: Saltstone Disposal Facility PA Revision

The chemical and physical properties of the cementitious materials (dry cement, blast furnace slag, and fly ash) used to construct the Saltstone Disposal Units (SDUs) and saltstone waste form play a key role in the design and long-term performance of the Saltstone Disposal Facility. Chemical degradation of the reducing saltstone and concrete over time will impact radionuclide release and transport due to the changing chemical composition of groundwater (GW) percolating through the porous saltstone waste form. An equilibrium reaction path model was developed using The Geochemist’s Workbench® (GWB) software to estimate the timescales (expressed as number of pore volumes) for chemical degradation of the reducing cementitious materials as indicated by changes in redox potential (E h ) and pH.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Infiltration Time Profiles for E-Area LLWF Intact and Subsidence Scenarios

To support future Unreviewed Disposal Question Evaluations (UDQEs), Special Analyses (SAs) and/or Performance Assessments (PAs) for the E-Area Low-Level Waste Facility (LLWF) at the Savannah River Site (SRS), the Hydrologic Evaluation of Landfill Performance (HELP) model and a newly developed, Python-based, probabilistic model employing a Monte Carlo sampling technique were used together to generate infiltration degradation curves over a 10,000-year simulation period for both intact and subsided slit- and engineered-trench closure-cap scenarios. The results will be used in PORFLOW transport model simulations of the E-Area LLWF trench units.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Intact Infiltration Model Design Check for E-Area LLWF

A design check will be performed on the infiltration-rate time profile for the intact case for the proposed E-Area Low-Level Waste Facility (LLWF) final closure cap design.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Subsidence Infiltration Model Design Check for E-Area LLWF

A design check will be performed on the revised Python-based probabilistic subsidence infiltration model for the proposed E-Area Low-Level Waste Facility (LLWF) final closure cap design.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Impact of Different Vegetative Cover Scenarios on Infiltration Rates for the E-Area PA Intact Case

This memorandum addresses the effects of vegetative cover type (bamboo versus Bahia grass) and the timing of pine tree intrusion on intact infiltration rate for the proposed E-Area Low-Level Waste Facility (LLWF) closure cap system. It builds upon earlier reports whose purpose is to lay the foundation for the infiltration data package that will be assembled during the next revision of the E-Area LLWF Performance Assessment (PA).

54 ENVIRONMENTAL SCIENCES↗

E-Area Low-Level Waste Facility Vadose Zone Model: Confirmation of Water Mass Balance for Subsidence Scenarios

In preparation for the next revision of the E-Area Low-Level Waste Facility (LLWF) Performance Assessment (PA), a mass balance model was developed in Microsoft Excel to confirm correct implementation of intact- and subsided-area infiltration profiles for the proposed closure cap in the PORFLOW vadose-zone model. The infiltration profiles are based on the results of Hydrologic Evaluation of Landfill Performance (HELP) model simulations for both intact and subsided cases.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Conceptual Modeling Framework for E-Area PA HELP Infiltration Model Simulations

A conceptual modeling framework based on the proposed E-Area Low-Level Waste Facility (LLWF) closure cap design is presented for conducting Hydrologic Evaluation of Landfill Performance (HELP) model simulations of intact and subsided cap infiltration scenarios for the next E-Area Performance Assessment (PA).

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Air and radon pathways screenings methodologies for the next revision of the E-area PA

The strategic plan for the next E-Area Low-Level Waste Facility Performance Assessment includes recommended changes to the screening criteria used to reduce the number of radioisotopes that are to be considered in the air and radon pathways incorporated into the GoldSim® atmospheric release model (ARM). For the air pathway, a revised screening methodology was developed based on refinement of previous E-Area PA screening approaches and consideration of the strategic plan recommendations. The revised methodology has three sequential screening steps for each radioisotope: (1) volatility test using the Periodic Table of the Elements, (2) stability test based on half-life, and (3) stability test based on volatility as measured by the Henry’s Law constant for the assumed dominant gaseous species or vapor pressure in the case of tritiated water. Of the 1252 radioisotopes listed in the International Commission on Radiological Protection Publication 107, only the 10 that satisfied all three steps of the revised screening methodology will be included in the ARM. They are: Ar-37, Ar-39, Ar-42, C-14, H-3, Hg-194, Hg-203, Kr-81, Kr-85, and Xe-127. For the radon pathway, a revised screening methodology was developed that also has three sequential steps: (1) identify all decay chains that terminate at Rn-222, (2) screen out parents that decay through U-238 because of its 4.5-billion-year primordial half-life, and (3) eliminate remaining parents whose half-life is shorter than one day. Of the 86 possible decay chains leading to Rn-222, six decay chains consist of 15 unique radioisotopes that will be incorporated into the ARM. The 15 radioisotopes are: U-238, Th-234, Pa-234m, Pu-238, U-234, Th-230, Ra-226, Cf-246, Cm-242, Am-242m, Am-242, Np-238, Np-234, Pa-230, and Rn-222.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

488-1D Ash Basin closure cap help modeling- Microdrain® liner option

At the request of Area Completion Engineering and in support of the 488-1D Ash Basin closure, the Savannah River National Laboratory (SRNL) performed hydrologic simulations of the revised 488-1D Ash Basin closure cap design using the Hydrologic Evaluation of Landfill Performance (HELP) model. The revised design substitutes a MicroDrain Liner®—60-mil low-density polyethylene geomembrane structurally integrated with 130-mil drainage layer—for the previously planned drainage/barrier system—300-mil geosynthetic drainage layer (GDL), 300-mil geosynthetic clay liner (GCL), and 6-inch common fill soil layer. For a 25-year, 24-hour storm event, HELP model v3.07 was employed to (1) predict the peak maximum daily hydraulic head for the geomembrane layer, and (2) ensure that South Carolina Department of Health and Environmental Control (SCDHEC) requirements for the barrier layer (i.e., ≤ 12 inches hydraulic head on top of a barrier having a saturated hydraulic conductivity ≤ 1.0E-05 cm/s) will not be exceeded. A 25-year, 24-hour storm event at the Savannah River Site (SRS) is 6.1 inches rainfall (Weber 1998). HELP model v3.07 results based upon the new planned cap design suggest that the peak maximum daily hydraulic head on the geomembrane barrier layer will be 0.15 inches for a minimum slope equal to 3%, which is two orders of magnitude below the SCDHEC upper limit of 12 inches.

58 GEOSCIENCES↗

Production of Low Enriched Uranium Nitride Kernels for TRISO Particle Irradiation Testing

A large batch of UN microspheres to be used as kernels for TRISO particle fuel was produced using carbothermic reduction and nitriding of a sol-gel feedstock bearing tailored amounts of low-enriched uranium (LEU) oxide and carbon. The process parameters, established in a previous study, produced phasepure NaCl structure UN with dissolved C on the N sublattice. The composition, calculated by refinement of the lattice parameter from X-ray diffraction, was determined to be UC 0.27 N 0.73 . The final accepted product weighed 197.4 g. The microspheres had an average diameter of 797±1.35 μm and a composite mean theoretical density of 89.9±0.5% for a solid solution of UC and UN with the same atomic ratio; both values are reported with their corresponding calculated standard error.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗