Engineering topics

Dyer, J. E.

Publications and source records attributed to Dyer, J. E..

3 records

NASA NTRS1986

Deployable truss structure advanced technology

The 5-meter technology antenna program demonstrated the overall feasibility of integrating a mesh reflector surface with a deployable truss structure to achieve a precision surface contour compatible with future, high-performance antenna requirements. Specifically, the program demonstrated: the feasibility of fabricating a precision, edge-mounted, deployable, tetrahedral truss structure; the feasibility of adjusting a truss-supported mesh reflector contour to a surface error less than 10 mils rms; and good RF test performance, which correlated well with analytical predictions. Further analysis and testing (including flight testing) programs are needed to fully verify all the technology issues, including structural dynamics, thermodynamics, control, and on-orbit RF performance, which are associated with large, deployable, truss antenna structures.

Dyer, J. E.↗

NASA NTRS1975

Isogrid structures

Test results and related structural instability analyses are presented for a 10-foot-diameter, 37-inch-long cylinder, and a 10-foot-diameter, 40-inch-long, 45-degree conical frustum. Both structures are based upon flanged isogrids and are fabricated in 2024-T851 aluminum. Peak edge load intensities at failure were 1,654 lb/in for the cylinder and 1,457 lb/in at the small diameter of the frustum. General instability cylindrical-monocoque-structure equivalent knockdown factors for both were in good agreement (gamma = 0.48). Design analysis is also derived for estimating critical cylinder instability edge loads from the performance of two tandem isogrid members. Evaluation is made of effective skin contributing to isogrid load-carrying cross-section.

Slysh, P.↗

NASA NTRS1974

Conical isogrid adapter structural test results

The structural characteristics of isogrid composite structures are discussed. To demonstrate the feasibility of applying isogrid to conical structures, a full scale flanged isogrid conical adapter similar to the configuration of the D-1 Centaur equipment module was constructed. The adapter was tested to evaluate the response of the conical isogrid structure to various combinations of bending and axial compression loading. The analysis techniques for predicting conical isogrid structural capability are examined.

Dyer, J. E.↗