Search NASA⌕ Search

Engineering topics

Dziedzic, William M.

Publications and source records attributed to Dziedzic, William M..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Water cooling system for an air-breathing hypersonic test vehicle

This study provides concepts for hypersonic experimental scramjet test vehicles which have low cost and low risk. Cryogenic hydrogen is used as the fuel and coolant. Secondary water cooling systems were designed. Three concepts are shown: an all hydrogen cooling system, a secondary open loop water cooled system, and a secondary closed loop water cooled system. The open loop concept uses high pressure helium (15,000 psi) to drive water through the cooling system while maintaining the pressure in the water tank. The water flows through the turbine side of the turbopump to pump hydrogen fuel. The water is then allowed to vent. In the closed loop concept high pressure, room temperature, compressed liquid water is circulated. In flight water pressure is limited to 6000 psi by venting some of the water. Water is circulated through cooling channels via an ejector which uses high pressure gas to drive a water jet. The cooling systems are presented along with finite difference steady-state and transient analysis results. The results from this study indicate that water used as a secondary coolant can be designed to increase experimental test time, produce minimum venting of fluid and reduce overall development cost.

Petley, Dennis H.↗
NASA NTRS1993

Design of a Hypersonic Waverider-Derived Airplane

The paper describes the first assessment study of a waverider-derived Mach 5 aircraft design using fuselage integrated-underslung over/under turboramjets with endothermic fuel. The study is based on a tanker-to-tanker mission, which begins at Mach 0.8 and 30,000 feet, with the vehicle accelerating to Mach 12 at constant altitude and then to Mach 5 while climbing to about 90,000 feet. The paper describes the vehicle, the aerodynamic analysis, and the propulsion system and its installed performance, structure design, and analysis. The mission simulation was run using the CSOTAV code developed by the NASA Langley Research Center.

Pegg, Robert J.↗
NASA NTRS1992

Integrated numerical methods for hypersonic aircraft cooling systems analysis

Numerical methods have been developed for the analysis of hypersonic aircraft cooling systems. A general purpose finite difference thermal analysis code is used to determine areas which must be cooled. Complex cooling networks of series and parallel flow can be analyzed using a finite difference computer program. Both internal fluid flow and heat transfer are analyzed, because increased heat flow causes a decrease in the flow of the coolant. The steady state solution is a successive point iterative method. The transient analysis uses implicit forward-backward differencing. Several examples of the use of the program in studies of hypersonic aircraft and rockets are provided.

Petley, Dennis H.↗
NASA NTRS1991

Analysis of cooling systems for hypersonic aircraft

A computer program has been written to analyze cooling systems of hypersonic aircraft. This computer program called NASP/SINDA is written into the SINDA'85 command structure and uses the SINDA'85 finite difference subroutines. Both internal fluid flow and heat transfer must be analyzed, because increased heating causes a decrease in the flow of the coolant. Also local hot spots will cause a redistribution of the coolant in the system. Both steady state and transient analyses have been performed. Details of empirical correlations are presented. Results for two cooling system applications are given.

Petley, Dennis H.↗
NASA NTRS1991

An analytical comparison of convective heat transfer correlations in supercritical hydrogen

Four correlations that cover the ranges of liquid to gas for turbulent flow convection of hydrogen are compared with CFD analysis over a range of expected design conditions for active cooling of hypersonic aircraft. Analysis of hydrogen cooling in a typical cooling panel shows how predicted design performance varies with the correlation utilized. The CFD heat transfer coefficient results for a heat spike differed significantly from all four correlations. An acceptable heat transfer coefficient can be calculated at the heat spike location by overlooking the coefficient at the spike and averaging the coefficient before and after the spike.

Dziedzic, William M.↗