Engineering topics

E. Dinnat

Publications and source records attributed to E. Dinnat.

3 records

NASA NTRS2023

The Dielectric Constant of Sea Water and Extension to High Salinity

Accurate knowledge of the dielectric constant of sea water is important for remote sensing of surface parameters such as sea surface temperature (SST) and sea surface salinity (SSS). The advent of sensors in space, SMOS [1], Aquarius [2] and SMAP [3] capable of measuring SSS motivated modern measurements [4,5] and modelling [5,6] of the dielectric constant at L-band (1.4 GHz). In the past, the range of salinity included in the data used to create these models has been restricted to values typically encountered in the open ocean (e.g., less than 40 psu). However, there are many smaller water bodies with much higher salinity. Notable examples are the Great Salt Lake in Utah with salinity on the order of 180 psu and Garabogazköl lagoon in Turkmenistan with even higher salinity. Unfortunately, existing models for the dielectric constant can’t necessarily just be extended to higher values of salinity. The problem is that the polynomials in salinity and temperature used to represent the unknown parameters in the models are not constrained outside the range of SSS and SST used to determine their coefficients. While the models for the dielectric constant may be very good within that range, outside that range they can lead to unrealistic behavior. Research is underway to develop a model that represents the dielectric constant well over the ocean and behaves well at high salinity. In preparation for possible wideband remote sensing of salinity [7,8 ,9], the laboratory measurements made at 1.413 GHz [4,5] are being repeated at 0.707 GHz (P-band) and the plan is to include values of high salinity (50, 100, 150 psu).

D.M. Le Vine↗

NASA NTRS2022

Multi-Frequency Radiometer-Based Soil Moisture Retrieval and Algorithm Parameterization Using In Situ Sites

L-band brightness temperature (TB) has been shown to provide the best sensitivity to soil moisture (SM) although C- and X-band based products offer a longer time-series from satellite-based measurements. Currently, global coverage SM is routinely produced from spaceborne measurements using all three frequency bands, but despite continued validation efforts of the products, the relative characteristics and performance of these observations have not been fully established. Therefore, this study focused on the parametrization of SM retrieval algorithms at L-, C- and X-bands using TB observations from the L-band radiometer on NASA's SM Active Passive (SMAP) mission and the C- and X-band channels of JAXA's Advanced Microwave Scanning Radiometer 2 (AMSR2) onboard the GCOM-W satellite. These can be applied in global SM retrieval algorithms using either one of the frequencies or a combination of them. The reference in situ SM data was obtained from 12 core validation sites across various land cover types around the world. The investigation highlighted the known challenges of retrieving SM from C- and X-band data compared to the higher sensitivity of the L-band data. Even with a site-specific retrieval algorithm parameterization, the mean correlation of the C- and X-band retrievals for the core validation site SM measurement were much lower than that for L-band, being 0.52 (0.54) and 0.45 (0.47) for vertical (horizontal) polarization, respectively, while for the L-band retrieval the corresponding values were 0.81 (0.77). The parameterization exercise showed that matching the C- and X-band TB measurements with an emission model was not difficult; the problem was relating the observations to SM under the influence of large roughness and vegetation effects. As a result, parameter optimization produced values for some sites that were not realistic or did not allow any practical sensitivity to SM at C- and X-band. Considering the L-band observations, the parameter optimization resulted in superior bias performance as compared to the operational SMAP product parameterization, but the sensitivity to SM changes (R and unbiased root mean square difference) did not improve markedly, or in some cases degraded at the expense of a smaller bias.

passive microwave↗

NASA NTRSDate not supplied

SMOS Salinity Retrieved from New Seawater Dielectric Constant Models at L-band

The accuracy of the Sea Surface Salinity (SSS) retrieved from L-Band radiometer measurements is strongly dependent on the accuracy of the modelling of the dielectric constant. Two new parametrizations have recently been developed based on one hand on the Soil Moisture and Ocean Salinity (SMOS) satellite multi-angular brightness temperature measurements [1] (BV) and on the other hand on new laboratory measurements [3] (GW2020). These two approaches are fully independent. The brightness temperatures, Tb, simulated with the BV and GW2020 parametrizations are compared with each other and with the ones derived from dielectric constant models previously in use in the SMOS, Soil Moisture Active Passive (SMAP) and Aquarius SSS retrievals. Tb simulated with the BV and GW2020 parametrizations agree particularly well for most SSS and SST commonly observed over the open ocean and are found to be in closer agreement than with earlier parametrizations. Nevertheless, uncertainty remains at low SST where a ∼ 0.1 K relative difference between the two models is observed. A complete reprocessing of SMOS SSS (2010–2020) has been performed using the BV parametrization instead of the Klein and Swift (1977) model previously used in SMOS processing. When compared with Argo derived near surface salinity maps, clear improvements are observed in warm and cold regions. Remaining uncertainties in cold waters will be discussed relatively to the uncertainties in SMOS Tb linked to sea ice contamination and given the constraints given by the GW2020 laboratory measurements.

J. Boutin↗