Search NASA⌕ Search

Engineering topics

Ecklund, W. L.

Publications and source records attributed to Ecklund, W. L..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Climatology of tropospheric vertical velocity spectra

Vertical velocity power spectra obtained from Poker Flat, Alaska; Platteville, Colorado; Rhone Delta, France; and Ponape, East Caroline Islands using 50-MHz clear-air radars with vertical beams are given. The spectra were obtained by analyzing the quietest periods from the one-minute-resolution time series for each site. The lengths of available vertical records ranged from as long as 6 months at Poker Flat to about 1 month at Platteville. The quiet-time vertical velocity spectra are shown. Spectral period ranging from 2 minutes to 4 hours is shown on the abscissa and power spectral density is given on the ordinate. The Brunt-Vaisala (B-V) periods (determined from nearby sounding balloons) are indicated. All spectra (except the one from Platteville) exhibit a peak at periods slightly longer than the B-V period, are flat at longer periods, and fall rapidly at periods less than the B-V period. This behavior is expected for a spectrum of internal waves and is very similar to what is observed in the ocean (Eriksen, 1978). The spectral amplitudes vary by only a factor of 2 or 3 about the mean, and show that under quiet conditions vertical velocity spectra from the troposphere are very similar at widely different locations.

Ecklund, W. L.↗
NASA NTRS1986

Continuous wind measurement in the tropical Pacific using VHF radars

Very High Frequency (VHF) Radar Wind Profilers are being installed on Ponape, East Caroline Islands and Christmas Island, Republic of Kiribati to continuously monitor winds aloft. The purpose of this experiment is to study wind fluctuations on time scales between minutes and days, to determine the longitudinal character of these fluctuations, and to examine their relationship to climate variability. Six-hourly wind profiles will be provided via satellite to the scientific community for Project TOGA (Tropical Ocean Global Atmosphere).

Balsley, B. B.↗
NASA NTRS1986

Phased-array design for MST and ST radars

All of the existing radar systems fully dedicated to clear-air radar studies use some type of phased-array antennas. The effects of beam-steering techniques including feed networks and phase shifters; sidelobe control; ground-clutter suppression; low altitude coverage; arrays with integrated radiating elements and feed networks; analysis of coaxial-collinear antennas; use of arrays with multiple beams; and array testing and measure on structural design of the antenna are discussed.

Ecklund, W. L.↗
NASA NTRS1986

The NOAA TOGA antenna array

The Aeronomy Laboratory recently installed a 100 x 100 meter array antenna with limited beam steering on Christmas Island as a part of the TOGA (Tropical Ocean and Global Atmosphere) program. The array and the associated beam steering and indicating hardware are described.

Ecklund, W. L.↗
NASA NTRS1986

Low-altitude coverage of ST radars

Clear air ST (stratosphere troposphere) radars are now widely used for atmospheric research and wind profiling. Most attention to date has been directed toward extending the altitude coverage as high as possible. It is also desirable to extend the coverage as low as possible. Any improvement in the low altitude coverage of existing wind profiling radars would be useful. The approximate lower limits of some existing ST radars are listed and what set these limits are briefly examined.

Ecklund, W. L.↗
NASA NTRS1986

The grid array antenna

Attention is called to the grid array as a possible useful antenna design for UHF clear air radars. This type of antenna integrates radiating elements and the feed network into a single structure so that a fairly large array can be driven from a single feed point. Figures are given which demonstrate the basic principle of the grid array, which are adapted from Conti et al. (1981). Conductors are arranged above a ground plane in a repeating, staggered array of connected rectangles. Each rectangular element is approximately one by one-half wavelength in size. The currents on the conductors at resonance is indicated. The grid array illustrated can be expanded in both vertical and horizontal directions about the feed point by adding additional rectangular conductors. The design eliminates the feed network and would provide a thin, panel-like antenna that could be easily built and transported.

Ecklund, W. L.↗
NASA NTRS1986

Simultaneous multibeam sounding of wind and turbulence

Most clear air radars use an antenna with either a few fixed beam positions or one that can be steered to a number of beam positions, one position at a time. For spatial studies of parameters that can change rapidly these conventional radar may be severely limited. The problem is that the fixed beam radars do not cover enough positions and the steerable radars may not be able to cover the entire field of interest in a short enough time period. Preliminary results are presented from a brief experiment that suggests a way to overcome some of these space-time problems in clear air radar research. A typical clear air radar antenna located in France was modified in a simple way to produce a number of beam simultaneouly. The radar, the modifications and the resulting beam patterns are described. Spectra is then shown obtained with the multibeam array and some results are presented on the spatial variations of reflectivity. Both the positive and negative aspects of using a multibeam antenna array for clear air radar studies are summarized.

Brun, E.↗
NASA NTRS1986

The elimination of a class of pseudo echoes by an improved T/R switch technique

An annoying class of pseudo echoes are described that evidently occur occasionally in a number of ST (stratosphere troposphere) radars. The origin of these signals are located in the output circuitry of the radar transmitter. Two methods for the elimination of the radar echoes are suggested and briefly desscrib.

Green, J. L.↗
NASA NTRS1984

A modified Fresnel scattering model for the parameterization of Fresnel returns, part 2.3A

A modified Fresnel scatter model is presented and the revised model is compared with observations from the Poker Flat, Alaska, radar, the SOUSY radar and the Jimcamarca radar. The modifications to the original model have been made to better account for the pulse width dependence and height dependence of backscattered power observed at vertical incidence at lower VHF. Vertical profiles of backscattered power calculated using the revised model and routine radiosonde data show good agreement with observed backscattered power profiles. Relative comparisons of backscattered power using climatological data for the model agree fairly well with observed backscattered power profiles from Poker Flat, Jicamarca, and SOUSY.

Gage, K. S.↗
NASA NTRS1984

Tropospheric gravity waves observed by three closely spaced ST radars

Clear-air radar experiments were carried out on the southern coast of France during the (ALPEX) Alpine experiment program vertically directed stratosphere-troposphere-radars were set up with spacings of about 5 to 6 km. The temporal and spectral characteristics of the vertical velocity fluctuations were examined. The horizontal and vertical properties of gravity waves in the lower atmosphere were analyzed. The techniques used and the first results from this wave study are described.

Carter, D. A.↗
NASA NTRS1984

The Ponape ST radar

In May, 1984, a 50-MHz ST radar was installed on the island of Ponape in the western equatorial Pacific (7 deg N, 158 deg E) by the Aeronomy Laboratory of NOAA. The radar consists of a 100 m x 100 m array with a single, vertically directed, beam and is initially transmitting micro sec. (2.25 km) pulses. The radar is operating continuously, with Doppler spectra being recorded at approximately 1 1/2 minute intervals and sent to Boulder for later analysis. One of the principal goals of the radar is to measure vertical motions in the troposphere and lower stratosphere at a location which is within the intertropical convergence zone during part of the year. First results, during generally fair weather conditions, show detectable echoes up to about 21 km with the tropopause at 17-18 km. Once daily balloon soundings are available locally from a NOAA Weather Service Office on the island, it is planned that this radar will be joined in the coming year by two others with oblique as well as vertical beams on two yet-to-be-selected equatorial islands as part of the TOGA (Tropical Oceans Global Atmosphere) program.

Carter, D. A.↗
NASA NTRS1983

Solar control of winter mesospheric echo occurrence at Poker Flat, Alaska

Winter mesospheric echoes are observed between about 55 and 80 km when auroral absorption is present during daylight hours. Relatively steady auroral absorption during sunrise and sunset periods causes a distinct onset and decay signature in mesospheric echo occurrence. The echo onset and disappearance time are shown versus height by the inclined lines for four different dates. The more vertical lines give the visible sunlight height/time curves for both sunrise (SR) and sunset (SS). The data is combined and replotted to give the morning onset height and the afternoon disappearance height as a function of solar zenith angle. Echoes are not observed at the lowest heights in the morning until the solar zenith angle is less than 90 deg. The afternoon echoes at the lowest heights also start to disappear as soon as the solar zenith angle exceeds 90 deg, implying that the solar component which sustains the mesospheric echo is screened by a layer extending up to about 60 km. The morning echo at 73 km onsets near the time of visible sunrise, but in the afternoon the 73 km echo lasts well past visible sunset.

Ecklund, W. L.↗
NASA NTRS1983

Techniques for studying gravity waves and turbulence: Vertical wind speed power spectra from the troposphere and stratosphere obtained under light wind conditions

A joint France/U.S. experiment was conducted near the mouth of the Rhone river in southern France as part of the ALPEX program. This experiment used 3 vertically directed 50 MHz radars separated by 4 to 6 km. The main purpose of this experiment was to study the spatial characteristics of gravity waves. The good height resolution (750 meters) and time resolution (1 minute) and the continuous operation over many weeks have yielded high resolution vertical wind speed power spectra under a variety of synoptic conditions. Vertical spectra obtained during very quiet (low wind) conditions in the troposphere and lower stratosphere from a single site are presented.

Ecklund, W. L.↗
NASA NTRS1983

Capabilities and limitations of existing MST radars: Poker Flat

Designed as a prototype system to continuously monitor the atmosphere up to approximately 100 km, the Poker Flat MST radar began operating in 1979 at a relatively low sensitivity. In almost continuous operation since then, the system is steadily increasing in sensitivity to its ultimate design characteristics. Current and final parameters are listed. The advantages of its modular design, which uses 64 transmitting modules distributed through the 200 mx 200 m antenna array include: easy maintenance, beam switching using very low power switching, air cooled transmitting tubes, lower feedline costs, and no moving parts. Continuous, uninterrupted operation ( 4 years) and less man-made interference because of the remote location) are other assets. Most disadvantages are related to its not-yet-finished status, climate, moose excursions, and operating expenses.

Balsley, B. B.↗
NASA NTRS1983

Design considerations for high-power VHF radar transceivers: The Poker Flat MST radar phase control system

Sixty-four separate 50-kW peak-power transmitters are distributed throughout the 200 x 200 meter Poker Flat MST radar antenna array. The relative phase of each transmitter is automatically controlled by a 64-channel unit located in the main building at the edge of the antenna. The phase control unit is described. In operation the RF pulse from a transmitter coupler is power divided and compared with the phase reference in a mixer. The mixer output is low-pass filtered and sampled near the center of the resulting video pulse by an amplifying sample-and-hold integrated circuit. Phase control is effected by maintaining the mixer output pulse near zero volts by amplifying the sample-and-hold output which then drives the voltage-controlled phase shifter in the direction to null the mixer output. The voltage-controlled shifter achieves over 360 deg phase shift in the range from 0.7 to 24 volts. When the voltage into the shifter tracks to either voltage limit the wrap-around control resets the voltage so that the shifter is always operating within its control range.

Ecklund, W. L.↗
NASA NTRS1983

Design considerations for high-power VHF radar transceivers: Phase matching long coaxial cables using a cable radar

The Poker Flat 49.92-MHz MST radar uses 64 phase-controlled transmitters in individual shelters distributed throughout the antenna array. Phase control is accomplished by sampling the transmitted pulse at the directional coupler of each transmitter and sending the sample pulse back to a phase-control unit. This method requires phase matching 64 long (256 meter) coaxial cables (RG-213) to within several electrical degrees. Tests with a time domain reflectometer showed that attenuation of high frequency components in the long RG-213 cable rounded the leading edge of the reflected pulse so that the cables could only be measured to within 50 cm (about 45 deg at 49.92 MHz). Another measurement technique using a vector voltmeter to compare forward and reflected phase required a directional coupler with unattainable directivity. Several other techniques were also found lacking, primarily because of loss in the long RG-213 cables. At this point it was realized that what was needed was a simple version of the phase-coherent clear-air radar, i.e., a cable radar. The design and operation of this cable are described.

Johnson, P. E.↗
NASA NTRS1983

Design considerations for high-power VHF radar transceivers: T/R switch design

The transceiver (TR) switch developed at NOAA's Aeronomy Laboratory for use in their 50 kW peak power, 50 MHz transmitter is described. The switch mounts inside the transmitter chassis and was designed to be compact while retaining the ability to handle well over 50 kW peak power at average power levels up to 2 kW. The TR switch is a conventional TR/ATR design with equivalent /4 transmission line sections constructed of lumped constant coils and transmitting capacitors in ''Tee' sections. Two TR sections are placed in series to achieve adequate receiver protection. The switch is set into the ''transmit' mode by forward biasing the 3 pin diodes to about 1.2 amperes each. The receive mode is achieved by back biasing the diodes to -15 volts. A directional coupler is also incorporated into the TR switch box to provide a convenient monitor point for forward and reflected transmitter power.

Ecklund, W. L.↗