Search NASA⌕ Search

Engineering topics

Edgell, D H

Publications and source records attributed to Edgell, D H.

20 records · Page 2

Cryogenic Target-Implosion Experiments on OMEGA

The University of Rochester’s Laboratory for Laser Energetics has been imploding thick cryogenic targets for six years. Improvements in the Cryogenic Target Handling System and the ability to accurately design laser pulse shapes that properly time shocks and minimize electron preheat, produced high fuel areal densities in deuterium cryogenic targets (202+/-7 mg/cm^2). The areal density was inferred from the energy loss of secondary protons in the fuel (D2) shell. Targets were driven on a low final adiabat (alpha = 2) employing techniques to radially grade the adiabat (the highest adiabat at the ablation surface). The ice layer meets the target-design toughness specification for DT ice of 1-um rms (all modes), while D2 ice layers average 3.0-um-rms roughness. The implosion experiments and the improvements in the quality and understanding of cryogenic targets are presented.

Harding, D R↗

The Role of Fast-Electron Preheating in Low-Adiabat Cryogenic Implosions on OMEGA

The compression in direct-drive, low-adiabat spherical implosions was studied using cryogenic D2 targets on the 60-beam, 351-nm OMEGA laser in the range of laser intensities from ~3 x 10^14 to ~1.5 x 10^15 W/cm^2. The neutron-burn–averaged areal densities decreased as the laser intensity increased. This decrease in areal density is highly correlated with the increased hard-x-ray signals, caused by hot electrons generated by the two-plasmon-decay instability. The areal-density reduction up to ~2, observed in the experiments, requires a preheat energy of ~60 J (~0.3% of total laser energy), which is consistent with the estimated preheat levels inferred from the hard-x-ray signal levels. Mitigating the generation of fast-electrons results in high areal densities which are close to the 1D predictions.

Shvarts, D↗