Search NASA⌕ Search

Engineering topics

Elmore, K. L.

Publications and source records attributed to Elmore, K. L..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Determining F-factor using ground-based Doppler radar: Validation and results

Using a two-dimensional linear least-squares method applied to Doppler radar data, we test the viability of determining F-factor remotely. The ultimate application of such an algorithm will be supplying real-time F-factor maps, derived from ground-based Doppler radars to air traffic control personnel and pilots. Data from NASA deployments to the MIT/Lincoln Lab TDWR testbed radar in Orlando in 1991 and 1992 along with NASA deployments to the NCAR TDWR testbed radar in Denver are examined. Preliminary analyses show that the two-dimensional method correlates reasonably well with in situ measurements. Several effects, independent of the method used, act to reduce the correlation to less than one. These include time differences between radar and aircraft data, vertical misalignment between the aircraft and the radar beam, different spatial resolution scales between aircraft and radar data, inhomogeneous radar beam filling, noise in radar data that eludes filtering, and phase lag between time and space due to low pass filtering of the aircraft data. In the final assessment, it appears that a shear-based F-factor algorithm is preferable to the currently implemented TDWR algorithms which lack any local shear estimates.

Elmore, K. L.↗
NASA NTRS1986

A high resolution spatial and temporal multiple Doppler analysis of a microburst and its application to aircraft flight simulation

Multiple Doppler radar data collected during the Joint Airport Weather Studies (JAWS) Project is used to synthesize the three-dimensional wind in the region of a microburst. The particular microburst used in this study is the strongest one to date for which three-dimensional winds have been recovered. As a diagnostic tool, a six-DOF numerical aircraft model having characteristics similar to 727 series aircraft is used to investigate jet transport aircraft response to observed microburst winds during simulated approaches and departures. Simple pilot control laws are used to adjust thrust, pitch, roll, and yaw so as to maintain given approach or departure parameters. Generally, when horizontal wind shear along the approach or departure path is 0.01/s or greater, the model is unable to maintain the desired approach path and suffers a significant reduction in climb performance during a go-around or departure. Although the mean wind shear along a path gives a good qualitative measure of the wind shear threat to a jet transport, different paths with similar mean shears can yield markedly different results, as do the same paths through the microburst at different times. These findings are a direct consequence of the fine temporal and spatial scale of microburst winds. During any given modeled aircraft traverse through the region of highest horizontal shear, time variations in the microburst wind field are shown to have an insignificant effect on the modeled flight path. This is because the traverse period is short (30 s) compared to the lifetime of a microburst (300-600 s).

Elmore, K. L.↗
NASA NTRS1984

Simulated flight through JAWS wind shear - In-depth analysis results

The Joint Airport Weather Studies (JAWS) field experiment was carried out in 1982 near Denver. An analysis is presented of aircraft performance in the three-dimensional wind fields. The fourth dimension, time, is not considered. The analysis seeks to prepare computer models of microburst wind shear from the JAWS data sets for input to flight simulators and for research and development of aircraft control systems and operational procedures. A description is given of the data set and the method of interpolating velocities and velocity gradients for input to the six-degrees-of-freedom equations governing the motion of the aircraft. The results of the aircraft performance analysis are then presented, and the interpretation classifies the regions of shear as severe, moderate, or weak. Paths through the severe microburst of August 5, 1982, are then recommended for training and operational applications. Selected subregions of the flow field defined in terms of planar sections through the wind field are presented for application to simulators with limited computer storage capacity, that is, for computers incapable of storing the entire array of variables needed if the complete wind field is programmed.

Frost, W.↗
NASA NTRS1981

An airport wind shear detection and warning system using Doppler radar: A feasibility study

A feasibility study was conducted to determine whether ground based Doppler radar could measure the wind along the path of an approaching aircraft with sufficient accuracy to predict aircraft performance. Forty-three PAR approaches were conducted, with 16 examined in detail. In each, Doppler derived longitudinal winds were compared to aircraft measured winds; in approximately 75 percent of the cases, the Doppler and aircraft winds were in acceptable agreement. In the remaining cases, errors may have been due to a lack of Doppler resolution, a lack of co-location of the two sampling volumes, the presence of eddy or vortex like disturbances within the pulse volume, or the presence of point targets in antenna side lobes. It was further concluded that shrouding techniques would have reduced the side lobe problem. A ground based Doppler radar operating in the optically clear air, provides the appropriate longitudinal winds along an aircraft's intended flight path.

Mccarthy, J.↗
NASA NTRS1980

An airport wind shear detection and warning system using Doppler radar

Two numerical models of aircraft performance are developed to relate atmospheric wind signals in wind-shear situations to aircraft response. Both models produce time histories of pitch angle, airspeed, height above the ground, and other parameters for simulating aircraft making precision approaches along a 3-deg glide slope to the runway. Simulations conducted using thunderstorm environment wind data indicate that the horizontal wind component is at least as important as the vertical component in determining aircraft response to wind shear. Obtaining quantitative measurements of aircraft approach or departure quality is found to depend on several factors, including the knowledge of winds along the expected flight track, clear-air detection in a quasi-horizontal path, and a near continuous estimate of approach deterioration due to shear conditions.

Mccarthy, J.↗
NASA NTRS1980

Instrumented aircraft verification of clear-air radar detection of low-level wind shear

A technique is described in which the longitudinal wind component at airports, measured by Doppler radar, is put through a Fourier transformation to produce an energy density spectrum. The result is multiplied by the aircraft response characteristics to produce quantitative data on aircraft performance in a wind shear situation. The Doppler radar measurements are made along the intended flight path. Two case studies, along a 3 deg approach path, are described from measurements in two modes: Lagrangian, where predictions were computed one range gate ahead of the plane, and Eulerian, where samples were measured instantaneously along the flight path. Wind data obtained every second were interpolated to fit a numerical model by using a cubic spline. Eulerian data were superior to Lagrangian data in terms of ranging, and nearly equal for wind speeds. Improvements in current 75% accuracy are noted to be possible with shrouded antennas to reduce sidelobes and use of Doppler radar with higher resolution to eliminate effects of small scale disturbances within the pulse volume.

Mccarthy, J.↗