Search NASA⌕ Search

Engineering topics

Eng, S. T.

Publications and source records attributed to Eng, S. T..

Single-ended output GaAs/AlGaAs single quantum well laser with a dry-etched corner reflector

GaAs/AlGaAs single quantum well lasers with integrated corner reflectors have been fabricated using chemically assisted ion beam etching. The air-GaAs interface is internally totally reflecting, and no coherent radiation is transmitted through the corner reflector. The corner reflector laser was compared with a conventional Fabry-Perot laser cleaved from the same wafer. An 11-percent reduction in threshold current and a reduction of the far-field angle from 4.4 deg to 0.7 deg was measured.

Hagberg, M.↗

Optically addressed spatial light modulators by MBE-grown nipi MQW structures

Promising approaches for achieving optically addressed spatial light modulators (O-SLMs) are investigated based on combining nipi and multiple quantum well structures. Theoretical aspects of photooptic effects achievable in such structures are treated. Test structures are grown by molecular beam epitaxy using two material systems. (In,Ga)As/GaAs and (Al,Ga)As/GaAs. Experiments show large optically controlled modulation of the absorption coefficient in the quantum well layers, a log power dependence on the control signal, millisecond and shorter time response, and generally predictable behavior. The results are encouraging for several different O-SLM device structures proposed.

Maserjian, Joseph↗

High-speed dual-wavelength demultiplexing and detection in a monolithic superlattice p-i-n waveguide detector array

High-speed (1 Gbit/x) dual-wavelength demultiplexing and detection in a monolithic linear array of superlattice p-i-n photodetectors in a waveguide configuration is demonstrated. A crosstalk attenuation of 28 dB was achieved between two digital transmission channels with an interchannel wavelength spacing of 30 nm. The device performance is a result of an enhanced electroabsorption due to the quantum-confined Stark effect in the superlattice p-i-n diodes.

Larsson, A.↗

A synchronous fiber optic ring local area network for multigigabit/s mixed-traffic communication

A synchronous-ring fiber optic local area network is reported that facilitates the simultaneous transmission of packet and real-time traffic at gigabit/s rates, minimizes the amount of high-speed logic, and simplifies the user interface to the network. The novelty of the technique is based on (1) suspending in transit around the ring's circumference an integral number of data frames and (2) achieving this condition by skewing the frame clock rate a small amount. Rather than use the whole data frame as one packet destined to a specific user, many individual channels are instead time-multiplexed into the data frame. This technique only becomes feasible for local networks as data rates approach the Gbit/s range. This departure from other synchronous rings results in several advantages both in terms of system performance and hardware simplicity.

Bergman, L. A.↗

Spectral and temporal characteristics of AlGaAs/GaAs superlattice p-i-n photodetectors

Measurements of the spectral and the temporal response of AlGaAs/GaAs p-i-n photodetectors with superlattice intrinsic regions grown by molecular beam epitaxy are reported. The feasibility for high-speed applications is demonstrated by a time constant limited impulse response of 200 ps (full width at half-maximum) when excited near the band edge with 100 ps optical pulses. The theory-predicted and recently verified voltage tunability of the band edge with clearly resolved excitonic resonances was observed. The responsivity was measured to be 0.2 A/W.

Larsson, A.↗

A 250-Mbit/s ring local computer network using 1.3-microns single-mode optical fibers

A 250-Mbit/s three-station fiber-optic ring local computer network was built and successfully demonstrated. A conventional token protocol was employed for bus arbitration to maximize the bus efficiency under high loading conditions, and a non-return-to-zero (NRS) data encoding format was selected for simplicity and maximum utilization of the ECL-circuit bandwidth.

Eng, S. T.↗

Effect of Temperature on Fiber-Optic Delay

Fiber/jacket interactions affect performance. Attenuation and phase measurements made to assess effect of temperature on signal delay and attenuation in two fiber-optic cable samples.

Bergman, L. A.↗

Temperature stability of transit time delay for a single-mode fibre in a loose tube cable

The effect of temperature on the transit-time delay of a loose-tube-type single-mode optical-fiber cable is investigated experimentally. A 1058-m length of cable was placed loosely coiled in an oven and used to connect a 820-nm single-mode laser diode to a high-speed avalanche-photodiode detector feeding a vector voltmeter; the signal was provided by a high-stability frequency-synthesized generator. Measurements were made every 2 C from -50 to 60 C and compared to those obtained with a 200-m lacquered bare fiber. The phase change of both fibers varied with temperature at a positive slope of 6-7 ppm/C. This value is significantly better than those reported for other cable types, suggesting the application of loose-fiber cables to long-haul gigabit digital transmissions or precision time-base distribution for VLBI.

Bergman, L. A.↗

Gigahertz analog modulation and differential delay of GaAlAs lasers - Temperature and current behavior

Gigahertz analog modulation characteristics of broad-area commercially available GaAlAs lasers have been investigated as a function of temperature and current in the vicinity of the upper frequency limit, where the resonance phenomena occur. The optimum temperature for small-signal amplitude modulation was found to be around -15 C for our particular broad-stripe geometry double-heterostructure laser. The Q was found to increase by a factor of 2 and the bandwidth by about 2%; the external quantum efficiency was maximized in this range. The optimum dc current bias was about 2% above the threshold current. Differential delays have also been measured down to a few picosecond accuracy by a unique phase-angle measurement method using a vector voltmeter. Some of the temperature effects observed may be related to mode changes and multimode and superradiance behavior.

Eng, S. T.↗