Engineering topics

Erickson, R. E.

Publications and source records attributed to Erickson, R. E..

6 records

NASA NTRS1986

NASA rotor systems research aircraft: Fixed-wing configuration flight-test results

The fixed-wing, airplane configuration flight-test results of the Rotor System Research Aircraft (RSRA), NASA 740, at Ames/Dryden Flight Research Center are documented. Fourteen taxi and flight tests were performed from December 1983 to October 1984. This was the first time the RSRA was flown with the main rotor removed; the tail rotor was installed. These tests confirmed that the RSRA is operable as a fixed-wing aircraft. Data were obtained for various takeoff and landing distances, control sensitivity, trim and dynamics stability characteristics, performance rotor-hub drag, and acoustics signature. Stability data were obtained with the rotor hub both installed and removed. The speed envelope was developed to 261 knots true airspeed (KTAS), 226 knots calibrated airspeed (KCAS) at 10,000 ft density altitude. The airplane was configured at 5 deg. wing incidence with 5 deg. wing flaps as a normal configuration. Level-flight data were acquired at 167 KCAS for wing incidence from 0 to 10 deg. Step inputs and doublet inputs of various magnitudes were utilized to acquire dynamic stability and control sensitivity data. Sine-wave inputs of constantly increasing frequency were used to generate parameter identification data. The maximum load factor attained was 2.34 g at 206 KCAS.

Erickson, R. E.↗

NASA NTRS1985

RSRA flight development test in the airplane configuration

The Rotor Systems Research Aircraft (RSRA) was flown in the airplane configuration. Eleven successful flights were made from May 8 to October 3, 1984. The takeoff and landing method was demonstrated and the resultant parameters were obtained. Control power data were obtained. In addition, main rotor hub drag, airplane configuration acoustics data, and aircraft stability data were obtained. Hub drag, acoustics, and stability will be separately reported in more detail. The tail rotor was installed for all tests.

Erickson, R. E.↗

NASA NTRS1984

Rotor systems research aircraft airplane configuration flight-test results

The rotor systems research aircraft (RSRA) has undergone ground and flight tests, primarily as a compound aircraft. The purpose was to train pilots and to check out and develop the design flight envelope. The preparation and flight test of the RSRA in the airplane, or fixed-wind, configuration are reviewed and the test results are discussed.

Painter, W. D.↗

NASA NTRS1984

Rotor systems research aircraft airplane configuration flight-test results

The Rotor Systems Research Aircraft (RSRA) has been undergoing ground and flight tests by Ames Research Center since late 1979, primarily as a compound aircraft. The purpose was to train pilots and to check out and develop the design flight envelope established by the Sikorsky Aircraft Company. This paper reviews the preparation and flight test of the RSRA in the airplane, or fixed-wing, configuration and discusses the results of that test.

Painter, W. D.↗

NASA NTRS1984

NASA rotor system research aircraft flight-test data report: Helicopter and compound configuration

The flight test activities of the Rotor System Research Aircraft (RSRA), NASA 740, from June 30, 1981 to August 5, 1982 are reported. Tests were conducted in both the helicopter and compound configurations. Compound tests reconfirmed the Sikorsky flight envelope except that main rotor blade bending loads reached endurance at a speed about 10 knots lower than previously. Wing incidence changes were made from 0 to 10 deg.

Erickson, R. E.↗

NASA NTRS1982

An evaluation of vertical drag and ground effect using the RSRA rotor balance system

A flight test program utilizing the Rotor Systems Research Aircraft (RSRA) main rotor balance system was conducted to obtain data for the helicopter configuration. The test program is discussed along with the employed data reduction methods, and the results. NASA 740, the RSRA used for the vertical drag test, was in the standard helicopter configuration. The 31-foot radius blades have a linear twist of eight degrees and NACA 0012 airfoil sections. Aspects of instrumentation are considered, taking into account the data recording system, the static calibration facility, and aspects of data calibration and processing. Attention is given to the test procedure, data analysis methods, balance measurements, the ground effect, and vertical drag. It is found that the RSRA rotor balance system is capable of providing high quality performance data. The vertical drag of the RSRA is 4%, compared to 2.9% predicted.

Flemming, R. J.↗