APT Flash Lamps for a New Laser at LLNL Memo
Each flashlamp is supported coaxially within a pyrex water-jacket tube by two identical connector assemblies, one at each end. These connector assemblies not only support the flashlamp mechanically, but also provide source and return pathways for flashlamp DI cooling water and for electrical current. At each end of the flashlamp, the (presumably) tungsten feed-through rod that supports the electrode is attached to a connector assembly through a Multilam fitting. O rings seated on the outside of each connector assembly form a water-tight seal between the connector assembly and the inside of the pyrex water-jacket tube. During operation, DI cooling water enters the tube located at the end of one of the connectors, flows over that connector’s Multilam fitting, flows through a ring of holes in the connector assembly and then flows into the 1-mm gap between the flashlamp and the pyrex water-jacket tube. After passing over the length of the flashlamp, the water flows through the connector assembly at the opposite end of the flashlamp and exits through that connector assembly’s end tube. Electrical pulses are delivered to the flashlamp through the tubes coming out of the connector assemblies.