Search NASA⌕ Search

Engineering topics

Esterhuizen, Stephan

Publications and source records attributed to Esterhuizen, Stephan.

11 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2018

A GNSS Receiver for Small-Sats Enabling Precision POD, Radio Occultations and Reflections

A low cost, low power, and low mass GNSS receiver (called Cion) has been developed and is currently flying on the CICERO cubesats. The receiver was designed in less than a year by JPL for Tyvak and GeoOptics for use in the GeoOptics CICERO constellation and leverages 25 years of JPL GNSS reciever design experience. Cion uses a commercial off-the-shelf (COTS) computer along with existing space qualified RF down-converters, software, and firmware to produce atmospheric Radio Occultation (RO) data. By combining a FPGA with dual core ARM processor and an embedded system controller, the Xilinx Zynq processor is an enabling technology that provides a customizable digital signal processing platform integrated into the computer (System on a chip) and enables off-the-shelf hardware to become the main engine behind this software defined radio. Using Linux for the on-board computer allows for fast development times and liberal use of existing open source software libraries. The parts of the receiver that require realtime implementation are performed in the Field Programmable Gate Array (FPGA), which can also be reprogrammed in flight. While the Zynq is not rad hard, the silicon on insulator (SOI) technology is rad tolerant ‘by accident’, allowing for its use in many space-based applications. Early results show that the Cion is working as designed, has demonstrated the first known GLONASS occultations, and obtains high quality atmospheric profiles with excellent lower troposphere penetration (near Earth’s surface).

Young, Larry↗
NASA NTRS2017

Relay Communications Support to the ExoMars Schiaparelli Lander

The European Space Agency’s ExoMars Trace Gas Orbiter (TGO) arrived at Mars on October 19, 2016, three days after releasing the Schiaparelli Lander on a ballistic trajectory to Meridiani Planum. During the separation event, and subsequently during Schiaparelli’s Entry, Descent, and Landing (EDL), the NASA-provided Electra UHF payload onboard TGO was used to record signals from the Schiaparelli Lander for post-processing on the ground to recover both tracking of the lander’s carrier signal and reconstruction of the lander’s 8 kb/s telemetry. In addition, ESA’s Mars Express orbiter also recorded the Schiaparelli signal, with ground post-processing providing independent tracking of the lander carrier signal, and the Giant Metrewave Radio Telescope near Pune, India was configured to provide real-time detection of the lander carrier signal. While an anomaly in the latter stages of EDL led to loss of the lander, these critical event data sets, and in particular the telemetry reconstruction enabled by the TGO Electra recording, proved essential in enabling detailed diagnosis of the anomaly. And while the loss of the lander during EDL precluded the planned surface relay operations, the preparations for that activity provide important lessons learned for future Mars relay support scenarios.

Edwards, Charles D., Jr.↗
NASA NTRS2013

Method to Measure Total Noise Temperature of a Wireless Receiver During Operation

A method has been developed to measure the total effective noise power in a GPS receiver, including contributions from the system temperature, the antenna temperature, interference, lossy components, etc. A known level of noise is periodically injected before the preamplifier during normal tracking, with a switch set to a very low duty cycle, so that there is insignificant signal loss for the GPS signals being tracked. Alternately, a signal of known power may be injected. The coupling port is fed with a switch that can be controlled from the receiver s digital processing section. The switch can connect the coupling port to a noise or signal source at a known power level. The combined system noise is measured, and nearly continuous noise calibrations are made. The effect from injected noise/signals on the performance of the GPS receiver can be less than 0.01 dB of SNR loss. Minimal additional components are required. The GPS receiver is used to measure the SNRs required to solve for the noise level. Because this measurement is referenced to the preamplifier input, it is insensitive to variations in the receiver gain.

Young, Lawrence E.↗
NASA NTRS2012

Moon-to-Earth: Eavesdropping on the GRAIL Inter-Spacecraft Time-Transfer Link Using a Large Antenna and a Software Receiver

NASA's twin GRAIL [1] spacecraft (Ebb and Flow) arrived at Earth's Moon on New Year's Day, 2012. GRAIL's primary mission is to create a high-resolution map of the Moon's gravitational field by measuring very precisely the change in distance between the two spacecraft [2]. Each spacecraft transmits two signals to the other spacecraft, a PRN code modulated on a 2 GHz carrier (S-band), as well as an unmodulated carrier at roughly 33 GHz (Ka-band). Since it's not feasible to synchronize the two GRAIL spacecraft's clocks via GPS (as was done with GRACE), the S-band signals are used as a time-transfer link to synchronize either Ebb's clock to Flow or vice versa. As an independent measure to determine the clock offset of the GRAIL ultra-stable oscillators to UTC(NIST), an experiment was conducted where our JPL team used a large antenna on Earth to eavesdrop on the inter-spacecraft time-transfer link.

time-transfer subsystem (TTS)↗