Search NASA⌕ Search

Engineering topics

Fang, Zhen

Publications and source records attributed to Fang, Zhen.

At least 19 records

Mild, Electroreductive Lignin Cleavage: Optimizing the Depolymerization of Authentic Lignins

Among candidate strategies to depolymerize lignin, electroreduction has promise as a mild, environmentally friendly, low-cost method to cleave lignin’s most common linkage, the β-O-4 bond. Much of the prior work on lignin electrolysis has focused on anodic (oxidative) approaches, while most available electroreduction studies have studied lignin model compounds rather than authentic lignin. Here, after optimizing with a model system, we investigated the room-temperature electroreductive cleavage of four common lignin samples from different pretreatment approaches, including Kraft, Soda, GVL, and Cu-AHP lignin. This mild electrolysis process resulted in the solubilization of 45% of the GVL lignin and 60% of the Cu-AHP lignin, affording approximately 17.6 and 19.4 wt % of monomeric materials, respectively. Furthermore, the present work is an encouraging first step toward an electroreductive strategy for lignin depolymerization and upgrading.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Effective Biomass Fractionation through Oxygen-Enhanced Alkaline-Oxidative Pretreatment

The high recalcitrance of plant cell walls is an obstacle for effective chemical or biological conversion into renewable chemicals and transportation fuels. Here, we investigated the utilization of both oxygen (O 2 ) and hydrogen peroxide (H 2 O 2 ) as co-oxidants during alkalineoxidative pretreatment to improve biomass fractionation and increase enzymatic digestibility. The oxidative pretreatment of hybrid poplar was studied over a variety of conditions. Employing O 2 in addition to H 2 O 2 as a co-oxidant during the two-stage alkaline pre-extraction/coppercatalyzed alkaline hydrogen peroxide (Cu-AHP) pretreatment process resulted in a substantial improvement in delignification relative to using H 2 O 2 alone during the second-stage Cu-AHP pretreatment, leading to high overall sugar yields even at H 2 O 2 loadings as low as 2% (w/w of original biomass). The presence of H 2 O 2 , however, was both critical and synergistic. Performing analogous reactions in the absence of H 2 O 2 resulted in approximately 25% less delignification and a 30% decrease in sugar yields. The lignin isolated from this dual oxidant second stage had high aliphatic hydroxyl group content and reactivity to isocyanate, indicating that it is a promising substrate for the production of polyurethanes. To test the suitability of the isolated lignin as a source of aromatic monomers, the lignin was subjected to a sequential Bobbitt’s salt oxidation followed by formic-acid catalyzed depolymerization process. Monomer yields of approximately 17% (w/w) were obtained, and the difference in yields was not significant between lignin isolated from our Cu-AHP process with and without O 2 as a co-oxidant. Thus, the addition of O 2 did not lead to significant lignin crosslinking, a result consistent with the twodimensional heteronuclear single-quantum coherence (2D HSQC) NMR spectra of the isolated lignin.

09 BIOMASS FUELS↗

Effective Biomass Fractionation through Oxygen-Enhanced Alkaline–Oxidative Pretreatment

The high recalcitrance of plant cell walls is an obstacle for effective chemical or biological conversion into renewable chemicals and transportation fuels. Here, we investigated the utilization of both oxygen (O 2 ) and hydrogen peroxide (H 2 O 2 ) as co-oxidants during alkaline-oxidative pretreatment to improve biomass fractionation and increase enzymatic digestibility. The oxidative pretreatment of hybrid poplar was studied over a variety of conditions. Employing O 2 in addition to H 2 O 2 as a co-oxidant during the two-stage alkaline pre-extraction/copper-catalyzed alkaline hydrogen peroxide (Cu-AHP) pretreatment process resulted in a substantial improvement in delignification relative to using H 2 O 2 alone during the second-stage Cu-AHP pretreatment, leading to high overall sugar yields even at H 2 O 2 loadings as low as 2% (w/w of original biomass). The presence of H 2 O 2 , however, was both critical and synergistic. Performing analogous reactions in the absence of H 2 O 2 resulted in approximately 25% less delignification and a 30% decrease in sugar yields. Here, the lignin isolated from this dual oxidant second stage had high aliphatic hydroxyl group content and reactivity to isocyanate, indicating that it is a promising substrate for the production of polyurethanes. To test the suitability of the isolated lignin as a source of aromatic monomers, the lignin was subjected to a sequential Bobbitt’s salt oxidation followed by formic-acid catalyzed depolymerization process. Monomer yields of approximately 17% (w/w) were obtained, and the difference in yields was not significant between lignin isolated from our Cu-AHP process with and without O 2 as a co-oxidant. Thus, the addition of O 2 did not lead to significant lignin crosslinking, a result consistent with the two-dimensional heteronuclear single-quantum coherence (2D HSQC) NMR spectra of the isolated lignin.

09 BIOMASS FUELS↗

Synthesis of graphene-like carbon from biomass pyrolysis and its applications

Two-dimensional graphene materials attracted much attention worldwide because of their superior performance in electronic devices, sensors, and energy storage. However, its application is limited by high cost and insufficient production. The work to find out a simple and environmentally friendly process is highly needed. Designed pyrolysis of biomass precursors can derive graphene-like materials. This review summarizes some typical preparation processes for graphene-like materials synthesis from biomass carbonization via pyrolysis, including salt-based activation, template-based confinement, chemical blowing, coupling with hydrothermal carbonization pretreatment, post exfoliation, and some other methods. The operation of these methods and the performance of obtained graphene-like materials were closely highlighted. The scalability of the techniques and the applications of the biomass graphene-like carbon were also discussed. Some advanced characterization methods, such as SEM, TEM, AFM, Raman, and XPS to determine the graphene-like structure and graphitization degree were also discussed. In the end, some current challenges and future perspectives of the synthesis of these graphene-like materials were concluded.

pyrolysis, graphene, biomass, application, scalabi↗

Series Solution for Magnetic Flux Density of Circular Current Loop and a Relevant Application

The series solution to the magnetic flux density of a circular current loop is presented in the paper. The convergences of these series are assessed. Comparing the result with elliptic integral method, the validity and feasibility of series solution were verified. A computer program has been developed by the method to calculate the magnetic flux density of a multi-coil magnet and its uniformity successfully.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Enhanced cell survival and paracrine effects of mesenchymal stem cells overexpressing hepatocyte growth factor promote cardioprotection in myocardial infarction

Poor cell survival post transplantation compromises the therapeutic benefits of mesenchymal stem cells (MSCs) in myocardial infarction (MI). Hepatocyte growth factor (HGF) is an important cytokine for angiogenesis, anti-inflammation and anti-apoptosis. This study aimed to evaluate the cardioprotective effects of MSCs overexpressing HGF in a mouse model of MI. The apoptosis of umbilical cord-derived MSCs (UC-MSCs) and HGF-UC-MSCs under normoxic and hypoxic conditions was detected. The conditioned medium (CdM) of UC-MSCs and HGF-UC-MSCs under a hypoxic condition was harvested and its protective effect on neonatal cardiomyocytes (NCMs) exposed to a hypoxic challenge was examined. UC-MSCs and HGF-UC-MSCs were transplanted into the peri-infarct region in mice following MI and heart function assessed 4 weeks post transplantation. The apoptosis of HGF-UC-MSCs under hypoxic conditions was markedly decreased compared with that of UC-MSCs. NCMs treated with HGF-UC-MSC hypoxic CdM (HGF-UC-MSCs-hy-CdM) exhibited less cell apoptosis in response to hypoxic challenge than those treated with UC-MSC hypoxic CdM (UC-MSCs-hy-CdM). HGF-UC-MSCs-hy-CdM released the inhibited p-Akt and lowered the enhanced ratio of Bax/Bcl-2 induced by hypoxia in the NCMs. HGF-UC-MSCs-hy-CdM expressed higher levels of HGF, EGF, bFGF and VEGF than UC-MSCs-hy-CdM. Transplantation of HGF-UC-MSCs or UC-MSCs greatly improved heart function in the mouse model of MI. Compared with UC-MSCs, transplantation of HGF-UC-MSCs was associated with less cardiomyocyte apoptosis, enhanced angiogenesis and increased proliferation of cardiomyocytes. This study may provide a novel therapeutic strategy for MSC-based therapy in cardiovascular disease.

60 APPLIED LIFE SCIENCES↗