Search NASA⌕ Search

Engineering topics

Farley, John M

Publications and source records attributed to Farley, John M.

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1954

Investigation of Conical Subsonic Diffusers for Ram-jet Engines

The efficiency of a 30 degree conical diffuser was improved as much as 20 percent and separation was eliminated by the use of vortex generators. The use of splitter cones gave only small efficiency gains, but relatively uniform diffuser-outlet velocity profiles were obtained with the better designs. A configuration which incorporated both vortex generators and a splitter cone gave efficiencies higher than those obtained with any other splitter-cone configuration and also higher than those obtained when the same vortex generators were used without the splitter cone. Moderate diffuser-efficiency increases were obtained with guide vanes; however, in all cases combustion occurred in the vane wakes.

Farley, John M↗
NASA NTRS1951

Altitude Wind Tunnel Investigation of the Performance of Compressor, Combustor, and Turbine Components of Prototype J47D (RX1-1) Turbojet Engine

As a portion of an over-all performance investigation of the prototype J47D (RX-1) turbojet engine, performance of the compressor, combustor, and turbine components has been determined in the Lewis altitude wind tunnel over a range of altitude from 5000 to 55,000 feet and at flight Mach numbers from 0.19 to 0.92. Investigations were conducted with the engine operating on an electronic control schedule and slow with a two-lever control system by which fuel flow and exhaust-nozzle area could be controlled separately. Two combustor configurations were investigated.

ENGINES, TURBO-JET↗
NASA NTRS1951

Internal Flow and Burning Characteristics of 16-inch Ram Jet Operating in a Free Jet at Mach Numbers of 1.35 and 1.73

The effects of mass-flow ratio on the additive drag and normal-shock position of a single oblique-shock diffuser are presented. Also evaluated is the variation with operating condition of the velocity distribution at the combustion-chamber inlet. A comparison with connected-pipe data is included. Burner performance with a corrugated gutter-grid flame holder is discussed. It is shown that the total-pressure drop across the combustion chamber can be predicted with reasonable accuracy from the computed flame holder and combustion momentum pressure losses.

DIFFUSERS, SUPERSONIC↗