Engineering topics

Farouk, Tanvir I.

Publications and source records attributed to Farouk, Tanvir I..

3 records

DOE OSTI2023

2D-imaging of absolute OH and H 2 O 2 profiles in a He–H 2 O nanosecond pulsed dielectric barrier discharge by photo-fragmentation laser-induced fluorescence

We report pulsed dielectric barrier discharges (DBD) in He–H 2 O and He–H 2 O–O 2 mixtures are studied in near atmospheric conditions using temporally and spatially resolved quantitative 2D imaging of the hydroxyl radical (OH) and hydrogen peroxide (H 2 O 2 ). The primary goal was to detect and quantify the production of these strongly oxidative species in water-laden helium discharges in a DBD jet configuration, which is of interest for biomedical applications such as disinfection of surfaces and treatment of biological samples. Hydroxyl profiles are obtained by laser-induced fluorescence (LIF) measurements using 282 nm laser excitation. Hydrogen peroxide profiles are measured by photo-fragmentation LIF (PF-LIF), which involves photo-dissociating H 2 O 2 into OH with a 212.8 nm laser sheet and detecting the OH fragments by LIF. The H 2 O 2 profiles are calibrated by measuring PF-LIF profiles in a reference mixture of He seeded with a known amount of H 2 O 2 . OH profiles are calibrated by measuring OH-radical decay times and comparing these with predictions from a chemical kinetics model. Two different burst discharge modes with five and ten pulses per burst are studied, both with a burst repetition rate of 50 Hz. In both cases, dynamics of OH and H 2 O 2 distributions in the afterglow of the discharge are investigated. Gas temperatures determined from the OH-LIF spectra indicate that gas heating due to the plasma is insignificant. The addition of 5% O 2 in the He admixture decreases the OH densities and increases the H 2 O 2 densities. The increased coupled energy in the ten-pulse discharge increases OH and H 2 O 2 mole fractions, except for the H 2 O 2 in the He–H 2 O–O 2 mixture which is relatively insensitive to the additional pulses.

hydrogen peroxide↗

DOE OSTI2021

Striations in moderate pressure dc driven nitrogen glow discharge

Plasma stratification has been studied for more than a century. Despite the many experimental studies reported on this topic, theoretical analyses and numerical modeling of this phenomenon have been mostly limited to rare gases. In this work, a one-dimensional fluid model with detailed kinetics of electrons and vibrationally excited molecules is employed to simulate moderate-pressure (i.e. a few Torrs) dc discharge in nitrogen in a 15.5 cm long tube of radius 0.55 cm. The model also considers ambipolar diffusion to account for the radial loss of ions and electrons to the wall. The proposed model predicts self-excited standing striations in nitrogen for a range of discharge currents. The impact of electron transport parameters and reaction rates obtained from a solution of local two-term and a multi-term Boltzmann equation on the predictions are assessed. In-depth kinetic analysis indicates that the striations result from the undulations in electron temperature caused due to the interaction between ionization and vibrational reactions. Furthermore, the vibrationally excited molecules associated with the lower energy levels are found to influence nitrogen plasma stratification and the striation pattern strongly. A balance between ionization processes and electron energy transport allows the formation of the observed standing striations. Simulations were conducted for a range of discharge current densities from ~0.018 to 0.080 mA cm –2 , for an operating pressure of 0.7 Torr. Parametric studies show that the striation length decreases with increasing discharge current. Furthermore, the predictions from the model are compared against experimental measurements and are found to agree favorably.

42 ENGINEERING↗

DOE OSTI2020

Multidimensional simulations of Mckenna-driven flow tube configuration: Investigating non-ideality in NO x formation flow tube experiments

Multidimensional simulations have been conducted to simulate atmospheric pressure, flat-flame/McKenna-burner-driven-flow tube experiments targeted to obtain NO x speciation data for predicting/analyzing syngas combustion emissions. In a prior work, we demonstrated the impacts of multidimensional transport on post flame region prediction departures from those assuming unidimensional flow/transport conditions. In this work, we develop and utilize a multidimensional laminar reacting flow solver to simulate the fully coupled flame and post flame regions to further elucidate the impacts of the earlier unidimensional modeling assumptions on interpreting post flame NO x experimental data. The model is used to simulate a lean, premixed syngas/air flame and its associated post flame regions within a cylindrical flow-tube-like arrangement. The combustion process takes place under atmospheric condition with trace amount of NO x seeding fed into the inlet gas stream. The spatial evolution of NO x species (NO and NO 2 ) in the flame and in the post-combustion zone suggests two distinct regions: 1) a region encompassing the flame structure itself; and 2) a post flame region in which the temperature decays due to both axial and radial transport processes. The predictions show that for the conditions studied, a pulsatile flow field exists due to the formation of an expanding and contracting recirculation zone in the outer periphery of the flow tube. By resolving the nature of the flow, the resulting time-averaged temperature and species concentrations show improved agreement with existing experimental measurements. The flow-field interaction results in radial inhomogeneities in the NO 2 profiles with the maximum concentration offset from the flow centerline. The location of the peak in NO 2 is coupled with radial temperature gradients from wall cooling effects and their significant influence on NO/NO 2 interconversion kinetics, producing notable NO 2 accumulation in regions near the wall. Geometrical configurations capable of suppressing/minimizing the pulsatile nature are also investigated and the results are compared. Other experimental configurations could be considered in parametric simulations to determine the optimal configuration that would minimize non-idealities in the observations. The work shows the value in performing such computations in advance of settling on a particular design for flow tube/flow reactor experiments.

42 ENGINEERING↗