Optically Lithographed WSiX Superconducting Nanowire Single Photon Detectors (SNSPDs) Demonstrated near 1550 Nm
No abstract available
Beyer, Andrew D.↗
Engineering topics
Farr, W. H.
Publications and source records attributed to Farr, W. H..
Deep-Space Optical Terminals
We eport on engineering trades that led to the conceptual design of a laser communications terminal for spacecraft probing Mars. The flight terminal, the ground receiver and the ground transmitter subsystems are described. The flight terminal point design has 0.25 Gb/s downlink data-rate capability from the Mars close distance (0.42 AU). Capability for uplink data-rate of 0.3 Mb/s and ranging with 30 cm precision are also addressed.
laser communications↗
Characterization of Photon-Counting Detector Responsivity for Non-Linear Two-Photon Absorption Process
Sub-band absorption at 1550 nm has been demonstrated and characterized on silicon Geiger mode detectors which normally would be expected to have no response at this wavelength. We compare responsivity measurements to singlephoton absorption for wavelengths slightly above the bandgap wavelength of silicon (approx. 1100 microns). One application for this low efficiency sub-band absorption is in deep space optical communication systems where it is desirable to track a 1030 nm uplink beacon on the same flight terminal detector array that monitors a 1550 nm downlink signal for pointingcontrol. The currently observed absorption at 1550 nm provides 60-70 dB of isolation compared to the response at 1064 nm, which is desirable to avoid saturation of the detector by scattered light from the downlink laser.
Geiger mode detector↗
Deep-Space Optical Terminals (DOT)
A conceptual design study titled Deep-Space Optical Terminals was recently completed for an optical communication technology demonstration from Mars in the 2018 time frame. We report on engineering trades for the entire system, and for individual subsystems including the flight terminal, the ground receiver and the ground transmitter. A point design is described to meet the requirement for greater than 0.25 Gb/s downlink from the nearest distance to Mars of 0.42 AU with a maximum mass and power allocation of 40 kg and 110 W. Furthermore, the concept design addresses link closure at the farthest Mars range of 2.7 AU. Maximum uplink data-rate of 0.3 Mb/s and ranging with 30 cm precision are also addressed.
optical communications↗
Airborne Optical Communications Demonstrator Design And Preflight Test Results
A second generation optical communications demonstrator (OCD-2) intended for airborne applications like air-to-ground and air-to-air optical links is under development at JPL. This development provides the capability for unidirectional high data rate (2.5-Gbps) transmission at 1550-nm, with the ability to receive an 810-nm beacon to aid acquisition pointing and tracking. The transmitted beam width is nominally 200-(micro)rad. A 3x3 degree coarse field-of-view (FOV) acquisition sensor with a much smaller ~3-mrad FOV tracking sensor is incorporated. The OCD-2 optical head will be integrated to a high performance gimbal turret assembly capable of providing pointing stability of 5- microradians from an airborne platform. Other parts of OCD-2 include a cable harness, connecting the optical head in the gimbal turret assembly to a rugged electronics box. The electronics box will house: command and control processors, laser transmitter, data-generation-electronics, power conversion/distribution hardware and state-of-health monitors. The entire assembly will be integrated and laboratory tested prior to a planned flight demonstrations.
optical communications↗
Characterization of the visible light photon counter for optical communications on a photon-starved channel
Explore the source record for details and available documents.
optical communications↗
Deep space optical communications link availability and data volume
Optical links from a spacecraft at planetary distance to a ground-based receiver presume a cloud free line of site (CFLOS). Future ground-based optical reeiving networks, should they be implemented, will rely on site diversity of could cover to increase link availability.
optical communications↗
Laboratory Characterization and Modeling of a Near-Infrared Enhanced Photomultiplier Tube
The photon-starved channel for optical communications from deep space requires the development of detector technology that can achieve photon-counting sensitivities with high bandwidth. In this article, a near-infrared enhanced photomultiplier tube (PMT) with a quantum e.ciency of 0.08 at a 1.06- m wavelength is characterized in the laboratory. A Polya distribution model is used to compute the probability distribution function of the emitted secondary photoelectrons from the PMT. The model is compared with measured pulse-height distributions with reasonable agreement. The model accounts for realistic device parameters, such as the individual dynode stage gains and a shape parameter that is representative of the spatial uniformity of response across the photocathode and dynodes. Bit-error rate (BER) measurements also are presented for 4- and 8-pulse-position modulation (PPM) modulation schemes with data rates of 20 to 30 Mb/s. A BER of 10-2 is obtained for a mean of 8 detected photons.
Biswas, A.↗
Laboratory demonstration of the sub-microradian ATP subsystem for deep-space optical communications
Explore the source record for details and available documents.
free-space optical communications acquisition trac↗
Acousto-Optical/Electronic Processor For SAR
Lightweight, compact, low-power apparatus processes synthetic-aperture-radar (SAR) returns in real time, providing imagery aboard moving aircraft or spacecraft platform. Processor includes optical and electronic subsystems that, together, resolve range and azimuth coordinates of radar targets by combination of spatial and temporal integrations.
Bicknell, T. J.↗
An interactive program for software reliability modeling
With the tremendous growth in computer software, the demand has arisen for producing cost effective reliable software. Over the last 10 years an area of research has developed which attempts to address this problem by estimating a program's current reliability by modeling either the times between error detections or the error counts in past testing periods. A new tool for interactive software reliability analysis using the computer is described. This computer program allows the user to perform a complete reliability analysis using any of eight well-known models appearing in the literature. Some of the capabilities of the program are illustrated by means of an analysis of a set of simulated error data.
Farr, W. H.↗