Engineering topics

Faust, I. C.

Publications and source records attributed to Faust, I. C..

5 records

DOE OSTI2021

High Field Side Launch of RF Waves: A New Approach to Reactor Actuators

Launching radio frequency (RF) waves from the high field side (HFS) of a tokamak offers significant advantages over low field side (LFS) launch with respect to both wave physics and plasma material interactions (PMI). For lower hybrid (LH) waves, the higher magnetic field opens the window between wave accessibility and the condition for strong electron Landau damping, allowing LH waves from the HFS to penetrate into the core of a burning plasma, while waves launched from the LFS are restricted to the periphery of the plasma. The lower of waves absorbed at higher yields a higher current drive efficiency as well. In the ion cyclotron range of frequencies (ICRF), HFS launch allows for direct access to the mode conversion layer where mode converted waves absorb strongly on thermal electrons and ions, thus avoiding the generation of energetic minority ion tails. The absence of turbulent heat and particle fluxes on the HFS, particularly in double null configuration, makes it the ideal location to minimize PMI damage to the antenna structure. The quiescent SOL also eliminates the need to couple LH waves across a long distance to the separatrix, as the antenna can be located close to plasma without risking damage to the structure. Improved impurity screening on the HFS will help eliminate the long-standing issues of high Z impurity accumulation with ICRF.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2019

Observation of Efficient Lower Hybrid Current Drive at High Density in Diverted Plasmas on the Alcator C-Mod Tokamak

Efficient lower hybrid current drive (LHCD) is demonstrated at densities up to ne≈1.5×10^20 m^-3 in diverted plasmas on the Alcator C-Mod tokamak by operating at increased plasma current - and therefore reduced Greenwald density fraction. This density exceeds the nominal "LH density limit" at ne≈1.0×10^20 m^-3 reported previously, above which an anomalous loss of current drive efficiency was observed. The recovery of current drive efficiency to a level consistent with engineering scalings is correlated with a reduction in density shoulders and turbulence levels in the far scrape-off layer. Concurrently, rf wave interaction with the edge and/or scrape-off-layer plasma is reduced, as indicated by a minimal broadening of the wave frequency spectrum measured at the plasma edge. These results have important implications for sustaining steady-state tokamak operation and indicate a pathway forward for implementing efficient LHCD in a reactor.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2019

Lower hybrid wave edge power loss quantification on the Alcator C-Mod tokamak

For the first time, the power deposition of Lower Hybrid RF waves into the edge plasma of a diverted tokamak has been systematically quantified. Edge deposition represents a parasitic loss of power that can greatly impact the use and efficiency of Lower Hybrid Current Drive (LHCD) at reactor-relevant densities. Through the use of a unique set of fast time resolution edge diagnostics, including innovative fast-thermocouples, an extensive set of Langmuir probes, and a Ly? ionization camera, the toroidal, poloidal and radial structure of the power deposition has been simultaneously determined. Power modulation was used to directly isolate the RF effects due to the prompt (t < ?E ) response of the scrape-off-layer (SOL) plasma to LHRF power. LHRF power was found to absorb more strongly in the edge at higher densities. It is found that a majority of this edge-deposited power is promptly conducted to the divertor. This correlates with the loss of current drive efficiency at high density previously observed on Alcator C-Mod, and displaying characteristics that contrast with the local RF edge absorption seen on other tokamaks. Measurements of ionization in the active divertor show dramatic changes due to LHRF power, implying that divertor region can be key for the LHRF edge power deposition physics. These observations support the existence of a loss mechanism near the edge for LHRF at high density (ne > 1.0 1020 [m?3]). Results will be shown addressing the distribution of power within the SOL, including the toroidal symmetry and radial distribution. These characteristics are important for deducing the cause of the reduced LHCD efficiency at high density and motivates the tailoring of wave propagation to minimize SOL interaction, for example, through the use of high-field-side launch.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2018

Observation of Efficient Lower Hybrid Current Drive at High Density in Diverted Plasmas on the Alcator C-Mod Tokamak

Here, efficient lower hybrid current drive (LHCD) is demonstrated at densities up to $\bar{n}_e$ ≈ 1.5 x 10 20 m –3 in diverted plasmas on the Alcator C-Mod tokamak by operating at increased plasma current - and therefore reduced Greenwald density fraction. This density exceeds the nominal “LH density limit” at $\bar{n}_e$ ≈ 1.0 x 10 20 m –3 reported previously, above which an anomalous loss of current drive efficiency was observed. The recovery of current drive efficiency to a level consistent with engineering scalings is correlated with a reduction in density shoulders and turbulence levels in the far scrape-off layer. Concurrently, rf wave interaction with the edge and/or scrape-off-layer plasma is reduced, as indicated by a minimal broadening of the wave frequency spectrum measured at the plasma edge. These results have important implications for sustaining steady-state tokamak operation and indicate a pathway forward for implementing efficient LHCD in a reactor.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2016

eqtools: Modular, extensible, open-source, cross-machine Python tools for working with magnetic equilibria

As plasma physics research for fusion energy transitions to an increasing emphasis on cross-machine collaboration and numerical simulation, it becomes increasingly important that portable tools be developed to enable data from diverse sources to be analyzed in a consistent manner. This paper presents eqtools, a modular, extensible, open-source toolkit implemented in the Python programming language for handling magnetic equilibria and associated data from tokamaks. eqtools provides a single interface for working with magnetic equilibrium data, both for handling derived quantities and mapping between coordinate systems, extensible to function with data from different experiments, data formats, and magnetic reconstruction codes, replacing the diverse, non-portable solutions currently in use. Moreover, while the open-source Python programming language offers a number of advantages as a scripting language for research purposes, the lack of basic tokamak-specific functionality has impeded the adoption of the language for regular use. Implementing equilibrium-mapping tools in Python removes a substantial barrier to new development in and porting legacy code into Python. In this paper, we introduce the design of the eqtools package and detail the workflow for usage and expansion to additional devices. Additionally, the implementation of a novel three-dimensional spline solution (in two spatial dimensions and in time) is also detailed. Finally, verification and benchmarking for accuracy and speed against existing tools are detailed. Wider deployment of these tools will enable efficient sharing of data and software between institutions and machines as well as self-consistent analysis of the shared data.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗