Engineering topics

Fedorov, Vladimir (ORCID:0000000334328680)

Publications and source records attributed to Fedorov, Vladimir (ORCID:0000000334328680).

9 records

DOE OSTI2023

Spectral narrowing and broadening of Cr:ZnS/Se laser oscillation due to mode competition and spatial hole burning in the gain element

In this paper, we demonstrate the laser characterization of Cr:ZnS/Se polycrystalline gain media in non-selective unpolarized, linearly polarized, and twisted mode cavities. Lasers were based on post-growth diffusion-doped, commercially available antireflective-coated Cr:ZnSe and Cr:ZnS polycrystals with a length of 9 mm. The spectral output of lasers based on these gain elements in non-selective unpolarized and linearly polarized cavities was measured to be broadened to ∼20-50 nm due to the spatial hole burning (SHB) effect. SHB alleviation in the same crystals was realized in the “twisted mode” cavity, with linewidth narrowing to ∼80-90 pm. Both broadened and narrow-line oscillations were captured by adjusting the orientation of intracavity waveplates with respect to facilitated polarization.

47 OTHER INSTRUMENTATION↗

DOE OSTI2021

Lasing in 15 atm CO 2 cell optically pumped by a Fe:ZnSe laser

10 µm lasing is studied in a compact CO 2 -He cell pressurized up to 15 atm when optically pumped by a ∼50 mJ Fe:ZnSe laser tunable around 4.3 µm. The optimal pump wavelength and partial pressure of CO 2 for generating 10 µm pulses are found to be ∼4.4 µm and 0.75 atm, respectively. Without cavity optimization, the optical-to-optical conversion efficiency reached ∼10% at a total pressure of 7 atm. The gain lifetime is measured to be ∼1 µs at pressures above 10 atm, indicating the feasibility of using high-pressure optically pumped CO 2 for the efficient amplification of picosecond 10 µm pulses.

Tovey, Dana↗

DOE OSTI2021

Spectroscopy of GR1 centers in synthetic diamonds

We report on the spectroscopic characterization, absorption saturation, and excited-state dynamics of GR1 centers in synthetic diamonds. The non-linear optical measurements reveal an efficient bleaching of the GR1 center’s ground level under ns-pulsed 633 nm excitation. The maxima of absorption and emission cross sections were estimated to be 4.5 × 10 −17 cm 2 and 9 × 10 −17 cm 2 at 630 nm and 780 nm, respectively. The radiative lifetime of the excited level was estimated to be 8.5 ns. The 658 nm probe kinetics uncovered relaxation of 1 T 2 excited level going predominantly to a metastable state with a lifetime of 220 μs. An induced absorption detected with the use of a highly concentrated diamond sample could be due to up-conversion and photoionization processes in additional impurity-vacancy center with absorption at the short-wavelength tail of GR1. The results presented here indicate that synthetic diamonds with GR1 centers could serve as near infrared gain media or passive Q-switchers for laser cavities over the 633–750 nm spectral range. Optimization of the center concentration and the crystal parameters are required to minimize the induced absorption at the lasing wavelengths.

36 MATERIALS SCIENCE↗

DOE OSTI2021

High energy (0.8 J) mechanically Q-switched 2.94 μm Er:YAG laser

We report a flashlamp pumped mechanically Q-switched (MQS) 2.94 μm Er:YAG laser based on a spinning mirror with a highest output energy of 805 mJ at a pulse duration of 61 ns and 13 MW of peak power at 1 Hz repetition rate. This record output energy was achieved with the use of 300 mm long MQS Er:YAG laser cavity consisting of a 70% output coupler, 7 × 120 mm AR coated Er(50%):YAG crystal, and 4200 rad/s angular speed of the spinning mirror. The pulse jitter was also measured by using optical triggering and was smaller than 10 ns for 150 ns Q-switched pulses, which could be applicable to many laser applications where precise synchronization of pulses is required.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2021

Kerr-lens mode-locked Cr:ZnS oscillator reaches the spectral span of an optical octave

We report, to the best of our knowledge, the first super-octave femtosecond polycrystalline Cr:ZnS laser at the central wavelength 2.4 µm. The laser is based on a non-polarizing astigmatic X-folded resonator with normal incidence mounting of the gain element. The chromatic dispersion of the resonator is controlled with a set of dispersive mirrors within one third of an optical octave over 2.05–2.6 µm range. The resonator’s optics is highly reflective in the range 1.8–2.9 µm. The components of the oscillator’s output spectrum at the wavelengths 1.6 µm and 3.2 µm are detected at –60 dB with respect to the main peak. Average power of few-cycle Kerr-lens mode-locked laser is 1.4 W at the pulse repetition frequency 79 MHz. That corresponds to 22% conversion of cw radiation of Er-doped fiber laser, which we used for optical pumping of the Cr:ZnS oscillator.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2021

Room temperature, nanosecond, 60 mJ/pulse Fe:ZnSe master oscillator power amplifier system operating at 3.8-5.0 µm

We report on a RT gain-switched Fe:ZnSe master oscillator power amplifier (MOPA) system tunable over 3.8–5.0 µm pumped by radiation of Er:YAG laser operating at 2.94 µm. The mechanically Q-switched Er:YAG laser with output energy up to 220 mJ was used as a pump source for a master oscillator and three-stage power amplifier. The maximum output energies in 200 ns pulses exceeded 60, 56, and 48 mJ at 4.4, 4.3, and 4.1 µm, respectively, under 220 mJ of pump energy. The extraction energy efficiencies were measured to be 25, 30, and 40% at the first, second, and third stages, respectively.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2020

Hot-pressed ceramic Fe:ZnSe gain-switched laser

We report the first room temperature gain-switched Fe:ZnSe hot-pressed ceramic laser pumped by 2.94 µm radiation of mechanically Q-switched Er:YAG laser. The maximum output energy at 4.2 µm was 41 mJ at 3 Hz repetition rate and 120 ns pulse duration. The measured slope efficiency was 25% with respect to the absorbed energy. This technique could be attractive for the future development of high-energy short-pulse solid-state mid-IR systems.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Octave-spanning mid-infrared femtosecond OPA in a ZnGeP 2 pumped by a 2.4 μm Cr:ZnSe chirped-pulse amplifier

We report on the highly efficient, octave-spanning mid-infrared (mid-IR) optical parametric amplification (OPA) in a ZnGeP 2 (ZGP) crystal, pumped by a 1 kHz, 2.4 μm, 250 fs Cr:ZnSe chirped-pulse amplifier. The full spectral coverage of 3−10 μm with the amplified signal and idler beams is demonstrated. The signal beam in the range of ∼3 − 5 μm is produced by either white light generation (WLG) in YAG or optical parametric generation (OPG) in ZGP using the common 2.4 μm pump laser. We demonstrate the pump to signal and idler combined conversion efficiency of 23% and the pulse energy of up to 130 μJ with ∼2 μJ OPG seeding, while we obtain the efficiency of 10% and the pulse energy of 55 μJ with ∼0.2 μJ WLG seeding. The OPA output energy is limited by the available pump pulse energy (0.55 mJ at ZGP crystal) and therefore further energy scaling is feasible with multi-stage OPA and higher pump pulse energy. The autocorrelation measurements based on random quasi-phase matching show that the signal pulse durations are ∼318 fs and ∼330 fs with WLG and OPG seeding, respectively. In addition, we show the spectrally filtered 30 μJ OPA output at 4.15 μm suitable for seeding a Fe:ZnSe amplifier. Our ultrabroadband femtosecond mid-IR source is attractive for various applications, such as strong-field interactions, dielectric laser electron acceleration, molecular spectroscopy, and medical surgery.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2020

Cross-section of electrical impact excitation in bulk n-type monocrystalline Al:Cr:ZnSe

Middle-infrared luminescence of bulk Al:Cr:ZnSe crystal under direct electrical excitation of Cr 2+ , 5 E− 5 T 2 transition, is reported. Effective cross-section of electrical excitation was estimated based on comparative luminescence measurements under electrical and optical (1560 nm) excitations. Calculation of the threshold current density for lasing under electrical excitation of this material was also performed.

36 MATERIALS SCIENCE↗