Search NASA⌕ Search

Engineering topics

Feistel, T. W.

Publications and source records attributed to Feistel, T. W..

13 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

A historic review of canard configurations

The first human-powered flight was achieved by a canard-configured aircraft (Wright Brothers). Although other canard concepts were flown with varying degrees of success over the years, the tail-aft configuration has dominated the aircraft market for both military and civil use. This paper reviews the development of canard aircraft with emphasis on stability and control, handling qualities, and operating problems. The results show that early canard concepts suffered adversely in flight behavior because of a lack of understanding of the sensitivities of these concepts to basic stability and control principles. Modern canard designs have been made competitive with tail-aft configurations by using appropriate handling qualities design criteria.

Anderson, S. B.↗
NASA NTRS1985

Interdependence of parameters important to the design of subsonic canard-configured aircraft

An analysis is made of the interrelationship of the longitudinal parameters important to the aerodynamic design of an efficient canard or tandem wing configuration. It is shown that theoretical configuration span efficiencies substantially greater than one are feasible with the proper choice of parameters. This improvement can translate into significantly increased lift/drag ratios assuming fixed spans. The Prandtl-Munk relationship for induced drag is used as a convenient qualitative guide, with stability and trim criteria superimposed. An 'aspect-ratio ratio' parameter is introduced to aid in optimizing a configuration longitudinally. It is shown that a canard/wing 'aspect-ratio ratio' of approximately 3/2 to 2 is necessary to achieve peak span efficiency for a given span ratio and gap, assuming representative parameters.

Feistel, T. W.↗
NASA NTRS1981

Wind-tunnel measurements of wing-canard interference and a comparison with various theories

Wind-tunnel tests and analyses of the aerodynamics of wing-canard combinations for low speed applications are presented. Systematic tests are conducted in a 7 x 10 wind tunnel to explore various combinations of wing-canard vertical and horizontal positioning. The goals of the tests are (1) to investigate potential improved stalling characteristics over conventional tail-aft configurations, (2) to investigate the existence of a lift coefficient advantage, and (3) to determine induced drag levels. The measurements obtained are compared with calculations made using the Prandtl-Munk theory, and with a vortex-lattice panel code. Results indicate that the panel code gives excellent results for lift and induced drag at moderate lift coefficient, whereas Prandtl-Munk theory gives conservative results for induced drag. The application is a light transport aircraft used for short-haul operations.

Feistel, T. W.↗
NASA NTRS1981

Alleviation of Spin-Entry Tendencies through Localization of Wing-Flow Separation

Studies have been made on several wing leading-edge modifications applicable at present to single-engine light aircraft, which produce stabilizing vortices at stall and beyond. These vortices have the effect of fixing the stall pattern of the wing such that the various portions of the wing upper surface stall nearly symmetrically. The lift coefficient produced is maintained at a high level to angles of attack significantly above the stall angle of the unmodified wing, and the divergence in roll usually is reduced to a controllable level. It is hypothesized that these characteristics will help prevent inadvertent spin entry after a stall. Results are presented from recent large-scale wind-tunnel tests of a typical light aircraft, both with and without the modifications. The data indicate (hot the static stall and poststall characteristics of this aircraft, in a typical landing-approach condition, are noticeably improved when it suitable leading-edge modification is employed; and also that no appreciable aerodynamic penalties are evident in the normal flight envelope.

Feistel, T. W.↗
NASA NTRS1980

Large-scale wind-tunnel tests of inverting flaps on a STOL utility aircraft model

A unique inverting flap system was investigated on a large scale deflected slipstream model in the Ames 40 by 80 foot wind tunnel. The subject tests utilized 33% chord double-slotted flaps on a low aspect ratio wing that was fully immersed in the propeller slipstream. Evaluation of the flap effectiveness is aided by comparisons with the results of tests of other flap systems on the same twin propeller, twin tail boom STOL utility aircraft mode. No extreme or abrupt force or moment increments were encountered when the flaps were deflected through a wide range, corresponding to the complete retraction/extension spectrum. The lift and descent capability of the inverting flaps compared very favorably with that of the other flap systems that have been tested on this model, including some with much greater mechanical complexity. As expected, the flaps caused large nose down, pitching moment increments at the high lift settings; however, the trimmed characteristics are still competitive with those obtained from the more complicated flap systems. It is believed that these flaps may have promising potential application to the design of relatively simple STOL utility aircraft with improved performance capabilities. In addition, they may merit consideration as retrofits to existing aircraft with less effective flap systems.

Feistel, T. W.↗
NASA NTRS1978

A method for localizing wing flow separation at stall to alleviate spin entry tendencies

A wing leading-edge modification has been developed, applicable at present to single-engine light aircraft, which produces stabilizing vortices at stall and beyond. These vortices have the effect of fixing the stall pattern of the wing such that the various portions of the wing upper surface stall nearly symmetrically. The lift coefficient produced is essentially constant to very high angles of attack above the stall angle of the unmodified wing. It is hypothesized that these characteristics will help prevent inadvertent spin entry after a stall. Results are presented from recent large-scale wind-tunnel tests of a complete light aircraft, both with and without the modification.

Feistel, T. W.↗
NASA NTRS1976

Reduction of Stall-Spin Entry Tendencies Through Wing Aerodynamic Design

Results of recent wind tunnel tests and analyses are described which are aimed at helping to prevent spin entry after a stall by modifications to the aircraft wing. Simple add-on devices were utilized which modify the shape of the lift curve after stall, making it essentially flat to 30- 40 degree angle of attack. It is hypothesized that his will greatly reduce the danger of spin entry. Further research will be aimed at laying a firmer theoretical and analytical basis for the approach and at incorporating the complete full scale airplane and its dynamics into the problem.

Kroeger, R. A.↗
NASA NTRS1972

A look at V/STOL for business aircraft.

Attempt to ascertain the economic viability of the V/STOL capability for business aircraft and the manner in which this viability depends on the aircraft concept. A cost-benefit analysis is presented which indicates that a VTOL business aircraft would be more viable economically than a contemporary turbine-powered business aircraft. The combination of traveler's time value and trip distance for which each aircraft dominates is shown. The significance of disk loading in V/STOL concept application is discussed, and preliminary design configuration studies for three different business-aircraft-sized V/STOLs, using three concepts covering a range of disk loading, are presented as examples. Finally, a discussion of operational aspects of interest to future users of V/STOL business aircraft is presented which centers around the requirements for routine IFR terminal-area operations.

Feistel, T. W.↗