Search NASA⌕ Search

Engineering topics

Felker, Fort F.

Publications and source records attributed to Felker, Fort F..

16 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Accuracy of Tilt Rotor Hover Performance Predictions

The accuracy of various methods used to predict tilt rotor hover performance was established by comparing predictions with large-scale experimental data. A wide range of analytical approaches were examined. Blade lift was predicted with a lifting line analysis, two lifting surface analyses, and by a finite-difference solution of the full potential equation. Blade profile drag was predicted with two different types of airfoil tables and an integral boundary layer analysis. The inflow at the rotor was predicted using momentum theory, two types of prescribed wakes, and two free wake analyses. All of the analyses were accurate at moderate thrust coefficients. The accuracy of the analyses at high thrust coefficients was dependent upon their treatment of high sectional angles of attack on the inboard sections of the rotor blade. The analyses which allowed sectional lift coefficients on the inboard stations of the blade to exceed the maximum observed in two-dimensional wind tunnel tests provided better accuracy at high thrust coefficients than those which limited lift to the maximum two-dimensional value. These results provide tilt rotor aircraft designers guidance on which analytical approaches provide the best results, and the level of accuracy which can be expected from the best analyses.

Felker, Fort F.↗
NASA NTRS1993

Calculation of optimum airfoils using direct solutions of the Navier-Stokes equations

A method has been developed which calculates the optimum airfoil shape at a specified operating condition. The Reynolds-averaged Navier-Stokes equations with a turbulence model are used as the governing equations for the fluid flow, and are explicitly introduced into the optimization analysis as constraint equations. The locations of all grid points which define the surface of the airfoil are design variables, eliminating the need for shape functions to describe changes in the airfoil geometry. A generalized reduced-gradient method is used to find the optimum airfoil shape. The use of a direct solution technique (Newton's method) to solve the Navier-Stokes equations allows for the efficient solution of the problem. This paper describes the optimization method and presents sample results.

Felker, Fort F.↗
NASA NTRS1992

Wing Download Results from a Test of a 0.658-Scale V-22 Rotor and Wing

A test of a 0.658-scale V-22 rotor and wing was conducted in the 40 x 80 Foot Wind Tunnel at Ames Research Center. One of the principal objectives of the test was to measure the wing download in hover for a variety of test configurations. The wing download and surface pressures were measured for a wide range of thrust coefficients, with five different flap angles, two nacelle angles, and both directions or rotor rotation. This paper presents these results, and describes a new method for interpreting wing surface pressure data in hover. This method shows that the wing flap can produce substantial lift loads in hover.

Felker, Fort F.↗
NASA NTRS1992

A new method for transonic static aeroelasticity problems

A new method has been developed to calculate the steady flow and structural deformations for fluid/structure interaction problems. The discretized fluid dynamic and structural equations are regarded as a single set of coupled, nonlinear, algebraic equations. The equilibrium solution is directly obtained using Newton's method. The governing equations used for the fluid flow are the two-dimensional Navier-Stokes equations, and a finite-element model is used to represent the structure. This paper describes the analytical method and presents sample calculations demonstrating the technique. The results show rapid convergence and good agreement with experimental data.

Felker, Fort F.↗
NASA NTRS1991

Results from a test of a 2/3-scale V-22 rotor and wing in the 40- by 80-Foot Wind Tunnel

A test of a 0.658-scale V-22 rotor and wing was conducted in the 40- by 80-Foot Wind Tunnel at Ames Research Center. The principal objectives of the test were to measure the wing download in hover for a variety of test configurations, and rotor performance in forward flight. Also, a limited amount of data on rotor performance in vertical climb were acquired. This paper presents the results from the test with predictions from appropriate analytical methods. A new method for presenting and interpreting wing surface pressure data in hover is described, and this method shows that the wing flap can produce substantial lift loads in hover. The rotor performance in vertical climb was underpredicted by CAMRAD/JA and by the free wake analysis EHPIC. A simple momentum theory is presented which provides good predictions of rotor performance in forward flight.

Felker, Fort F.↗
NASA NTRS1990

Wing force and surface pressure data from a hover test of a 0.658-scale V-22 rotor and wing

A hover test of a 0.658-scale V-22 rotor and wing was conducted in the 40 x 80 foot wind tunnel at Ames Research Center. The principal objective of the test was to measure the surface pressures and total download on a large scale V-22 wing in hover. The test configuration consisted of a single rotor and semispan wing on independent balance systems. A large image plane was used to represent the aircraft plane of symmetry. Wing flap angles ranging from 45 to 90 degrees were examined. Data were acquired for both directions of the rotor rotation relative to the wing. Steady and unsteady wing surface pressures, total wing forces, and rotor performance data are presented for all of the configurations that were tested.

Felker, Fort F.↗
NASA NTRS1988

A review of tilt rotor download research

Experimental and theoretical research on the forces on a wing immersed in the wake of a hovering rotor is reviewed, with emphasis on the tilt rotor download problem. The basic features of the rotor/wing flow field on a tilt rotor aircraft are described. The effect of important geometric and operational parameters on the wing download is assessed. The magnitude of the download for typical tilt rotor configurations is reviewed, and advanced concepts for download reduction are described. Recommendations are presented for the direction of future research efforts.

Felker, Fort F.↗
NASA NTRS1988

Comparisons of predicted and measured rotor performance in hover using a new free wake analysis

A new free-wake analysis has been developed to predict the performance of rotors in hover and axial flight. The analysis finds the rotor wake geometry using a novel influence coefficient/relaxation scheme. In this paper, the features of the analysis are reviewed, and the accuracy of the analysis is assessed for a wide range of rotor configurations in hover and vertical climb. The effects of variations in the analysis parameters are addressed, and recommendations for future development are presented. Generally good results were obtained for the predicted performance of a wide range of rotor geometries and operating conditions without any special 'tuning' of the analysis. The analysis also provides predictions of rotor performance in vertical climb that are substantially more accurate than momentum theory.

Felker, Fort F.↗
NASA NTRS1987

Reduction of tilt rotor download using circulation control

The effect of boundary layer control blowing on the download of a wing in the wake of a hovering rotor was measured in a small scale experiment. The objective was to evaluate the potential of boundary layer control blowing for reducing tilt rotor download. Variations were made in rotor thrust coefficient, blowing pressure ratio, and blowing slot height. The effect of these parameter variations on the wing download and wing surface pressures is presented. The boundary layer control blowing caused reductions in the wing download of 25 to 55 percent.

Felker, Fort F.↗
NASA NTRS1987

Performance and loads data from a hover test of a 0.658-scale V-22 rotor and wing

A hover test of a 0.658-scale model of a V-22 rotor and wing was conducted at the Outdoor Aerodynamic Research Facility at Ames Research Center. The primary objectives of the test were to obtain accurate measurements of the hover performance of the rotor system, and to measure the aerodynamic interactions between the rotor and wing. Data were acquired for rotor tip Mach numbers ranging from 0.1 to 0.73. This report presents data on rotor performance, rotor-wake downwash velocities, rotor system loads, wing forces and moments, and wing surface pressures.

Felker, Fort F.↗
NASA NTRS1987

The effect of nonlinear elastomeric lag damper characteristics on helicopter rotor dynamics

Many helicopters use elastomeric lag dampers to prevent ground resonance and aeromechanical instability in hover and forward flight. Recent experimental results have shown that when the damper motion occurs at two superimposed frequencies, which is characteristic of operation in forward flight, the damper properties are not well-predicted by a superposition of the damper properties at each of the motion frequencies. This paper presents experimental data obtained with an elastomeric damper while it was undergoing single- and dual-frequency motion. The effect of the nonlinear dual-frequency damper characteristics on predicted rotor aeromechanical stability in forward-flight operation in a wind tunnel was evaluated using the comprehensive rotorcraft analysis program called CAMRAD.

Felker, Fort F.↗
NASA NTRS1987

Analysis of induced velocities in the wake of a hovering helicopter rotor

A simple analytical method has been developed to predict the induced velocities at the tip vortex in the wake of a hovering helicopter rotor. The wake model in the analysis includes the blade bound vortex as well as a tip vortex and vortex sheet trailed from each blade. Standard, prescribed wake models were used to describe the geometry of the tip vortex and the vortex sheet. Curved vortex elements were used to model the tip vortices and the vortex sheets. The analysis was used to study the contribution from each wake component to the axial-induced velocity of the tip vortex. Results show a highly variable induced velocity at the tip vortex both before and after the first blade passage. However, the prescribed tip vortex models require a constant axial velocity of the tip vortex. This inconsistency between the prescribed axial velocity of the tip vortex and the velocity that the wake geometry induces on the tip vortex points to a limitation of the current prescribed tip vortex geometry models.

Light, Jeffrey S.↗
NASA NTRS1987

An assessment of upper surface blowing for the reduction of tilt rotor download

A study evaluating the use of upper-surface blowing to reduce the wing download on a V-22 tilt rotor aircraft has been completed. The study assesses the penalties associated with the upper-surface blowing system (compressor weight, compressor power, etc.), and the reduction in wing download, for a wide range of blowing slot heights and blowing pressure ratios. Three wing configurations were investigated: blowing at both leading and trailing edges with no change in wing planform relative to the V-22 tilt rotor aircraft, blowing at both leading and trailing edges with a 25% reduction in wing chord, and blowing at the leading edge only with the flap deflected 75 deg. Predicted download is presented for all of these configurations, and is compared with the download of the baseline V-22 tilt rotor aircraft configuration. The optimum configuration had 15% less net download than the baseline V-22 configuration.

Faye, Robert E.↗
NASA NTRS1986

Aerodynamic interactions between a rotor and wing in hover

An experimental investigation of rotor/wing aerodynamic interactions in hover is described. The investigation consisted of both a large-scale and a small-scale test. A 0.658-scale V-22 rotor and wing was used in the large-scale test. Wing download, wing surface pressure, rotor performance, and rotor downwash data from the large-scale test are presented. A small-scale experiment was conducted to determine how changes in the rotor/wing geometry affected the aerodynamic interactions. These geometry variations included the distance between the rotor and wing, wing incidence angle, wing flap angle, rotor rotation direction, and configurations both with the rotor axis at the tip of the wing (tilt rotor configuration) and with the rotor axis at the center of the wing (compound helicopter configuration).

Felker, Fort F.↗
NASA NTRS1986

Performance and loads data from a hover test of a full-scale advanced technology XV-15 rotor

A hover test of a full-scale, composite, advanced technology XV-15 rotor was conducted at the Outdoor Aerodynamic Research Facility at Ames Research Center. The primary objective of the test was to obtain accurate measurements of the hover performance of this rotor system. Data were acquired for rotor tip Mach numbers ranging from 0.35 to 0.73. The rotor was tested with several alternate blade root and blade-tip configurations. Data are presented on rotor performance, rotor-wake downwash velocities, and rotor system loads.

Felker, Fort F.↗