Search NASA⌕ Search

Engineering topics

Felsteiner, J

Publications and source records attributed to Felsteiner, J.

X-band microwave generation caused by plasma-sheath instability

It is well known that oscillations at the electron plasma frequency may appear due to instability of the plasma sheath near a positively biased electrode immersed in plasma. This instability is caused by transit-time effects when electrons, collected by this electrode, pass through the sheath. Such oscillations appear as low-power short spikes due to additional ionization of a neutral gas in the electrode vicinity. Herein we present first results obtained when the additional ionization was eliminated. We succeeded in prolonging the oscillations during the whole time a positive bias was applied to the electrode. These oscillations could be obtained at much higher frequency than previously reported (tens of GHz compared to few hundreds of MHz) and power of tens of mW. These results in combination with presented theoretical estimations may be useful, e.g., for plasma diagnostics.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Effect of the reference electrode size on the ionization instability in the plasma sheath of a small positively biased electrode

It is well known that additional ionization in the vicinity of a positively biased electrode immersed into a weakly ionized plasma is responsible for a hysteresis in the electrode current-voltage characteristics and the current self-oscillations rise. Here we show both experimentally and theoretically that under certain conditions these phenomena cannot be correctly interpreted once considered separately from the reference electrode current-voltage characteristics. It is shown that small electrodes can be separated into three groups according to the relation between the electrode and the reference electrode areas. Each group is characterized by its own dependence of the collected current on the bias voltage.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Broad-band polarization-independent absorption of electromagnetic waves by an overdense plasma

Surface plasmon-polaritons can be efficiently excited on a plasma-vacuum interface by an electromagnetic wave when a subwavelength diffraction grating is placed in front of the plasma boundary. The excitation efficiency depends strongly on the wave frequency (or plasma density, when the frequency is fixed) and polarization. We show both experimentally and theoretically that this sensitivity can be essentially suppressed. A nonzero angle of incidence and an axially symmetric diffraction grating ensure near-total absorption of the incident wave in a broad range of wave frequencies (or plasma densities, when the frequency is fixed). Direct detection of surface plasmon-polaritons has been achieved for the first time using a miniature antenna embedded in the plasma. A new absorption mechanism which is not associated with surface plasma wave excitation is revealed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Input impedance of a powerful single-core ferromagnetic inductively coupled plasma source

An experimental study of the recently developed version of the ferromagnetic inductively coupled plasma source has shown that under certain circumstances its input impedance becomes almost independent of the delivered rf driving power and (therefore) of the produced plasma density. This plasma source consists of a large ferromagnetic core, which is fully immersed in plasma. This core is surrounded by a primary winding and plasma appears due to gas discharge driven by an rf voltage applied to this primary winding. We have found values of parameters which determine the input impedance in such an ''independent'' regime and derived a quantitative theory which is in good agreement with the measured impedance values.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Electron beam and plasma modes of a channel spark discharge operation

Parameters of a modified pulsed channel spark discharge (CSD), operating at a repetition rate up to 100 Hz at Ar gas pressures of 10{sup -3} and 10{sup -4} Torr and of the generated electron beam, were studied using different electrical, optical, and x-ray diagnostics. It was shown that efficient (up to approx74%) transfer of the initially stored energy to the energetic electron beam is realized only at the pressure of 10{sup -4} Torr. Conversely, at the pressure of 10{sup -3} Torr, less than 10% of the stored energy is acquired by the energetic electrons. It was found that the energetic electron beam generation is limited by the expansion of the cathode and anode plasmas and by the formation of plasma inside the gap between the CSD capillary output and the anode. It was also found that the plasma, which acquires the hollow cathode potential, is already formed at the beginning of the CSD operation inside the capillary, and the electron emission occurs from the capillary output plasma boundary. Finally, it was shown that the electron beam energy spectrum differs significantly from the energy spectrum, which one may expect in the case of the planar diode operation.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Pulsed plasma electron sources

There is a continuous interest in research of electron sources which can be used for generation of uniform electron beams produced at E{<=}10{sup 5} V/cm and duration {<=}10{sup -5} s. In this review, several types of plasma electron sources will be considered, namely, passive (metal ceramic, velvet and carbon fiber with and without CsI coating, and multicapillary and multislot cathodes) and active (ferroelectric and hollow anodes) plasma sources. The operation of passive sources is governed by the formation of flashover plasma whose parameters depend on the amplitude and rise time of the accelerating electric field. In the case of ferroelectric and hollow-anode plasma sources the plasma parameters are controlled by the driving pulse and discharge current, respectively. Using different time- and space-resolved electrical, optical, spectroscopical, Thomson scattering and x-ray diagnostics, the parameters of the plasma and generated electron beam were characterized.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗