Engineering topics
Publications and source records attributed to Fenwick, J. R..
Technique for obtaining force components on cylindrical bearing holder uses pairs of opposing strain gages. Signals proportional to outputs of pairs of opposing gages subtracted from each other. Subtraction nearly eliminates crosstalk between orthogonal force components. Signal-processing technique equally applicable to rotating as well as stationary loads.
Methods of computer simulation of turbopump vibrations described in report. For aircraft and aerospace service, high-speed, high-performance turbomachinery should be as light in weight as possible. Certain amount of mass needed in turbomachine housing for stiffness. Report addresses question of how much extra weight is necessary. Analyses shows under certain conditions, flexible housing more stable than rigid one.
Methods to evaluate the effect of casing flexibility on rotor stability and component loads were developed. Recent Rocketdyne turbomachinery was surveyed to determine typical properties and frequencies versus running speed. A small generic rotor was run with a flexible case with parametric variations in casing properties for comparison with a rotor attached to rigid supports. A program for the IBM personal computer for interactive evaluation of rotors and casings is developed. The Root locus method is extended for use in rotor dynamics for symmetrical systems by transforming all motion and coupling into a single plane and using a 90 degree criterion when plotting loci.
To effectively assess the Pogo stability of the space shuttle vehicle, it was necessary to characterize the structural, propellant, and propulsion dynamics subsystems. Extensive analyses and comprehensive testing programs were established early in the project as an implementation of management philosophy of Pogo prevention for space shuttle. The role of the space shuttle main engine (SSMF) in the Pogo prevention plans, the results obtained from engine ground testing with analysis, and measured data from STS-1 flight are discussed.
An accumulator particularly adapted for use in controlling the pressure of a stream of fluid in its liquid phase utilizing the fluid in its gaseous phase was designed. The accumulator is characterized by a shell defining a pressure chamber having an entry throat for a liquid and adapted to be connected in contiguous relation with a selected conduit having a stream of fluid flowing through the conduit in its liquid phase. A pressure and volume stabilization tube, including an array of pressure relief perforations is projected into the chamber with the perforations disposed adjacent to the entry throat for accommodating a discharge of the fluid in either gaseous or liquid phases, while a gas inlet and liquid to gas conversion system is provided, the chamber is connected with a source of the fluid for continuously pressuring the chamber for controlling the pressure of the stream of liquid.
Volume in new cryogenic accumulator is controlled passively and automatically, accumulator level sensor is eliminated, and sensing and control electronics and number of valves are minimized.
A dynamic (frequency response) analysis was made of a liquid oxygen feed system consisting of a low-speed inducer, a high-speed main pump and a positive displacement pulser utilized for simulating pogo induced pressure oscillations. Based on the results of the analysis, an active control system for suppression of pulser generated pressure oscillations was designed, fabricated and tested. The test results verified that the suppressor was effective in attenuating the generated pressure oscillations over the frequency range from 10 to 30 Hz.
Active control technique, using accelerometer-controlled servovalve to operate a compensating piston, effectively eliminates pressure fluctuations due to longitudinal structural vibration within a relatively long bandwith.
Nonlinear equation relates the flowrate at an orifice to that at a station downstream from the orifice. This equation should aid in understanding combustion instabilities and should not be subject to the substantial errors of prior analytical methods.