Search NASA⌕ Search

Engineering topics

Feo, A.

Publications and source records attributed to Feo, A..

Rotating Rig Development for Droplet Deformation/Breakup and Impact Induced by Aerodynamic Surfaces

This work presents the development of a Rotating Rig Facility by the Instituto Nacional de Tecnica Aeroespacial (INTA) in cooperation with the NASA Glenn Research Center. The facility is located at the INTA installations near Madrid, Spain. It has been designed to study the deformation, breakup and impact of large droplets induced by aerodynamic bodies. The importance of these physical phenomena is related to the effects of Supercooled Large Droplets in icing clouds on the impinging efficiency of the droplets on the body, that may change should these phenomena not be taken into account. The important variables and the similarity parameters that enter in this problem are presented. The facility's components are described and some possible set-ups are explained. Application examples from past experiments are presented in order to indicate the capabilities of the new facility.

Feo, A.↗

Feasibility of predicting performance degradation of airfoils in heavy rain

The heavy rain aerodynamic performance penalty program is detailed. This effort supported the design of a fullscale test program as well as examined the feasibility of estimating the degradation of performance of airfoils from first principles. The analytic efforts were supplemented by a droplet splashback test program in an attempt to observe the physics of impact and generation of ejecta. These tests demonstrated that the interaction of rain with an airfoil is a highly complex phenomenon and this interaction is not likely to be analyzed analytically with existing tools.

Bilanin, A. J.↗

Interaction between a shock wave and a turbulent boundary layer in transonic flow

Interaction between a shock wave and an unseparated turbulent boundary layer is considered. The method of matched asymptotic expansions is used, with solutions valid in the double limit as Reynolds number tends to infinity and Mach number tends to unity. The shock is weak enough that interaction effects can be considered as perturbations to the undisturbed flow; the case considered is that where the sonic line is near the outer edge of the boundary layer. It is shown that, with order estimates for Reynolds stress perturbations, the induced wall pressure distribution can be calculated using only the two outer interaction regions, independent of a specific closure condition and that this solution is in fact a turbulent free interaction solution. A detailed analysis of the inner regions, for which an eddy viscosity model for the Reynolds shear stress is used, provides a description of the variations in velocity, temperature and density near and at the wall.

Adamson, T. C., Jr.↗

Base pressure in laminar supersonic flow.

An asymptotic description is proposed for supersonic laminar flow over a wedge or a backward-facing step, for large Reynolds number and for a base or step height which is small compared with the boundary-layer length. The analysis is carried out for adiabatic wall conditions and a viscosity coefficient proportional to temperature. In a particular limit corresponding to a very thick boundary layer, a similarity law is obtained for the base pressure. For a thinner boundary layer an asymptotic form for the base pressure is obtained which shows the dependence on the parameters explicitly and which permits good agreement with experiment. This latter result is based on an inviscid-flow approximation for the corner expansion and for reattachment with viscous forces important primarily in a thin sublayer about the dividing streamline. A prediction of the pressure distribution at reattachment is given and the result is compared with experimental pressure distributions.

Messiter, A. F.↗