Engineering topics

Filleux, C.

Publications and source records attributed to Filleux, C..

3 records

NASA NTRS1978

Direct measurement of surface carbon concentrations for lunar soil breccias

A nuclear reaction depth profiling technique previously described by Filleux et al. (1977) has been used to measure the depth distribution of C on grain surfaces for Apollo 11, 15, 16 and 17 soil breccias. The surface C concentration of all samples studied lies between 2 and 8 times 10 to the 15th atoms per sq cm, showing no correlation with the volume C, which varies over an order of magnitude. If the observed variation represents the presence of unexposed grains on the surfaces studied, these results indicate a steady state surface C concentration of 5 to 10 times 10 to the 15th atoms per sq cm, accumulated over a time scale short compared with that required for the formation of volume-related C and with the mean lifetime of grains at the lunar surface. About one-third to one-half of the total C in lunar soil seems to be surface-correlated.

Filleux, C.↗

NASA NTRS1977

Direct measurement of surface carbon concentrations

Measurements of surface concentrations of carbon in lunar soils and soil breccias provide information on the origin of carbon in the regolith. The reaction C-12 (d, p sub zero) is used to measure 'surface' and 'volume' concentrations in lunar samples. This method has a depth resolution of 1 micron, which permits only a 'surface' and a 'volume' component to be measured. Three of four Apollo 16 double drive tube samples show a surface carbon concentration of about 8 by 10 to the 14th power/sq cm, whereas the fourth sample gave 4 by 10 to the 14th power/sq cm. It can be convincingly shown that the measured concentration does not originate from fluorocarbon or hydrocarbon contaminants. Surface adsorbed layers of CO or CO2 are removed by a sputter cleaning procedure using a 2-MeV F beam. It is shown that the residual C concentration of 8 by 10 to the 14th power/sq cm cannot be further reduced by increased F fluence, and it is therefore concluded that it is truly lunar. If one assumes that the measured surface C concentration is a steady-state concentration determined only by a balance between solar-wind implantation and sputtering, a sputter erosion rate of 0.1 A/yr is obtained. However, it would be more profitable to use an independently derived sputter erosion rate to test the hypothesis of a solar-wind origin of the surface carbon.

Filleux, C.↗

NASA NTRS1972

Solar wind composition experiment

The Apollo 16 SWC experiment is a continuation of the earlier experiments; however, an essential change was introduced in the solar wind particle collection technique. Platinum surfaces were incorporated in the collector foil, and use was made of a layer technique for distinguishing particles of different energies and different directions of arrival. The improvements and the expanded scope of the Apollo 16 experiment, relative to the earlier SWC experiments, can be summarized as follows: elimination of possible residual dust contamination by treating the platinum foil sections with dilute hydrofluoric acid before analysis; increased accuracy of solar wind argon abundance; determination of solar wind albedo; and search for helium in the energy range above approximately 40 KeV/nucleon.

Geiss, J.↗