Engineering topics
Publications and source records attributed to Finke, Richard G..
Two routes, as well as their combination, are examined for overcoming recombination in a dye-sensitized photoelectrochemical cell for water oxidation catalysis.
The challenge of elucidating the chemical mechanisms by which nano- and other particles form, and then using those mechanisms to understand, analyze, and ideally predict particle-size and particle-size distributions, was undertaken. Thanks to multi-year, longer-term DOE support each of these challenges was successfully met. The community is now able to both predict, and control in cases where the underlying mechanism of particle formation has been determined, the key PS and PSD that are, in turn, critical properties that strongly influence the catalytic and other physical properties of nano- and larger particles across nature.
In order to quantitatively predict nano- as well as other particle-size distributions, one needs to have both a mathematical model and estimates of the parameters that appear in these models. Here, we show how one can use Bayesian inversion to obtain statistical estimates for the parameters that appear in recently derived mechanism-enabled population balance models (ME-PBM) of nanoparticle growth. The Bayesian approach addresses the question of “how well do we know our parameters, along with their uncertainties?.” The results reveal that Bayesian inversion statistical analysis on an example, prototype $\mathrm{lr(0)_n}$ nanoparticle formation system allows one to estimate not just the most likely rate constants and other parameter values, but also their SDs, confidence intervals, and other statistical information. Moreover, knowing the reliability of the mechanistic model's parameters in turn helps inform one about the reliability of the proposed mechanism, as well as the reliability of its predictions. Importantly, the paper can also be seen as a tutorial with the additional goal of achieving a “Gold Standard” Bayesian inversion ME-PBM benchmark that others can use as a control to check their own use of this methodology for other systems of interest throughout nature. Overall, the results provide strong support for the hypothesis that there is substantial value in using a Bayesian inversion methodology for parameter estimation in particle formation systems.
Following the definition of and four primary criteria for obtaining reliable, disproof-based mechanisms of particle formation, 74 literature papers utilizing synchrotron XASF and SAXS are analyzed with an emphasis on 8 case studies.
Previously, a photoanode composed of nanostructured SnO 2 coated with the perylene diimide dye N,N'-bis(phosphonomethyl)-3,4,9,10-perylenediimide (PMPDI) plus photoelectrochemically deposited cobalt oxide (CoO y ) was shown to photoelectrochemically oxidize water at 31 ± 7% faradaic efficiency. A non-ideal part of that prior system is that the addition of the known CoO y water oxidation catalyst (WOC) resulted in a reduction of the total photocurrent rather than the anticipated increase, due to an increase in charge-carrier recombination. Herein, we show deposition of an ultrathin alumina overlayer applied by atomic layer deposition (ALD) on the SnO 2 /PMPDI photoanode can improve the photoactivity and catalytic activity of the system; the addition a ca. 1 nm-thick AlO x layer deposited on a 4000 nm (i.e., 4 micron) thick mesoporous anode system can and does have a positive, 2.5-fold improvement in the steady-state photocurrent with 29 ± 9% faradaic efficiency vs. the control anode without alumina passivation by reducing charge-carrier recombination. Moreover, ALD-deposited AlO x layer does help support the understanding of the “anti-catalysis” of co-depositing a CoO y WOC on the SnO 2 /PMPDI DS-PECs—specifically the picture of direct CoO y –SnO 2 contact-mediated recombination—but that AlO x layer was unable to improve the photocurrent in a net SnO 2 /PMPDI/AlO x (/CoO y ) system. We attribute the lack of a performance enhancement by CoOy WOC to incomplete coverage of each SnO 2 nanoparticle by the AlO x . Overall, we find the addition of an optimized ultrathin AlOx layer (0.6 nm thick; deposited at 85 °C) improves the SnO 2 /PMPDI/AlO x system's photoactivity by a factor of up to ca. 3-fold with reduced recombination. These results document that metal-oxide passivation by low-temperature ALD can be an effective strategy for improving the water oxidation performance of even nanostructured dye sensitized-photoelectrochemical cell.
Are classical nucleation theory and the 1950 LaMer model of particle formation supported for a wide range of particle formations, or do competing models in the form of chemical reaction mechanisms have better experimental support? Read on to find out.