Search NASA⌕ Search

Engineering topics

Fisher, B. D.

Publications and source records attributed to Fisher, B. D..

28 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Summary of flight tests of an airborne lighting locator system and comparison with ground-based measurements of precipitation and turbulence

Data from an airborne lightning locator system and data relating to storm intensity obtained by ground-based Doppler radars and the S-band research radar are presented. When comparing lightning locations from the airborne lightning locator system with ground-based Doppler radar measurements of reflectivity and spectrum width, the lightning locations tended to be further from the aircraft position than the Doppler radar contours, but at the same relative bearing from the aircraft as the Doppler contours. The results also show that convective storms generate little or no lightning for a significant part of their life cycle, but can produce at least moderate turbulence. Therefore, it is concluded that a lack of lightning activity cannot be accepted as an inference of a corresponding lack of other hazards to the flight of aircraft through convective storms.

Fisher, B. D.↗
NASA NTRS1981

Operational evaluation of thunderstorm penetration test flights during project Storm Hazards '80

The National Aeronautics and Space Administration is conducting a research project called Storm Hazards '80 in order to study the prediction, detectability and avoidance of the hazards of severe storms for aircraft operations. The project, using a highly instrumented NASA F-106B airplane to penetrate thunderstorms, gathered and correlated data from both airborne and ground based instrumentation. The objectives of this project are to determine the effects of lightning on the design and operation of aircraft composite structures and digital electronic systems. The data will be used to determine the correlation of lightning hazards with other severe storm hazards, such as heavy precipitation, hail, turbulence and wind-shear, in order to develop an initial data base for use in design and avoidance. The NASA F-106B was equipped with a weather radar, stormscope, lightning measurement instrumentation and air sampling equipment. This paper will focus on the operational aspects of thunderstorm penetrations and the pilot techniques used to avoid the extremely hazardous portions of the storm such as the tornadoes and hail. It will deal with the effects of the storm elements on the aircraft hardware, avionics and the crew.

Keyser, G. L., Jr.↗
NASA NTRS1980

Storm hazards '79: F-106B operations summary

Preliminary flight tests with a F-106B aircraft were made on the periphery of isolated thunder cells using weather radar support. In addition to storm hazards correlation research, a direct-strike lightning measurement experiment and an atmospheric chemistry experiment were conducted. Two flights were made to close proximity to lightning generating cumulonimbus clouds; however, no direct lightning strikes were experienced. Although no discernible lightning transients were recorded, many operational techniques were identified and established.

Fisher, B. D.↗
NASA NTRS1979

Flight investigation of piloting techniques and crosswind limitations using a research type crosswind landing gear

A research-type crosswind landing gear was tested in a flight program which used a light STOL transport in strong crosswind conditions. The research-type crosswind landing gear used enabled the airplane to land to crosswinds up to a magnitude of 25 to 30 knots. Three modes of landing-gear operation were investigated: preset, automatic, and castor (passive self-alignment). Actual test data and histograms are given for the 195 'visual flight rules' crosswind landings made.

Fisher, B. D.↗
NASA NTRS1978

Summary of NASA landing-gear research

This paper presents a brief summary of the airplane landing gear research underway at NASA. The technology areas include: ground handling simulator, antiskid braking systems, space shuttle nose-gear shimmy, active control landing gear, wire brush skid landing gear, air cushion landing systems, tire/surface friction characteristics, tire mechanical properties, tire-tread materials, powered wheels for taxiing, and crosswind landing gear. This paper deals mainly with the programs on tire-tread materials, powered wheel taxiing, air cushion landing systems, and crosswind landing gear research with particular emphasis on previously unreported results of recently completed flight tests. Work in the remaining areas is only mentioned.

Fisher, B. D.↗
NASA NTRS1978

A flight evaluation of a trailing anemometer for low-speed calibrations of airspeed systems on research aircraft

Research airspeed systems on three low-speed general aviation airplanes were calibrated by the trailing anemometer method. Each airplane was fitted with an NASA pitot-static pressure tube mounted on either a nose or wing boom. The uncalibrated airspeed systems contained residual static-pressure position errors which were too large for high-accuracy flight research applications. The trailing anemometer calibration was in agreement with the tower flyby calibration for the one aircraft for which the comparison was made. The continuous deceleration technique for the trailing anemometer method offers reduced test time with no appreciable loss of accuracy for airspeed systems with pitot-static system lag characteristics similar to those described.

Fisher, B. D.↗
NASA NTRS1976

A flight investigation of piloting techniques and crosswind limitations during visual STOL-type landing operations

A flight research program was undertaken to investigate problems concerned with landing a STOL airplane in crosswind conditions. The program included a study of piloting techniques and crosswind limitations during visual STOL type landing operations. The results indicated that the crosswind was more limiting during the ground roll out than during the airborne phases. The pilots estimated that the crosswind limit for commercial STOL type operations with the test aircraft would be approximately 15 to 20 knots. The pilots thought that the crosswind limits for ground operation might be extended by incorporating wing-lift spoilers, improved nose gear steering, and improved engine response. The pilots agreed that a crosswind landing gear would also be beneficial.

Fisher, B. D.↗
NASA NTRS1976

Trailing anemometer for low airspeed calibration

A propeller-type trailing airspeed anemometer system is described for low airspeed (M not exceeding 0.2) calibration which has improved accuracy and is easy to implement as compared to most methods currently in use. The trailing anemometer system consists of the trailing anemometer itself, a deployment mechanism, and an operator's control box. The trailing anemometer is a small low-drag brass body provided with tail fins for self-alignment with the airstream. The rotational speed of a small six-bladed low-inertia propeller is sensed with a miniature self-generating tachometer inside the anemometer. A very satisfactory airspeed calibration can be made with this device in which true airspeed can be measured to within 1 knot. Results from flight calibration of an aircraft and trail-back characteristics of the anemometer and cable are included. The operating speed range of the designed cable-anemometer combination is 7 to 165 knots.

Fisher, B. D.↗
NASA NTRS1974

Flight investigation of the VFR and IFR landing approach characteristics and terminal area airspace requirements for a light STOL airplane

A flight research program was conducted to determine the terminal area instrument flight capabilities of a light STOL airplane. Simulated (hooded) instrument landing approaches were made using steep single-segment and two-segment glide slopes. A brief investigation was also made of the visual flight terminal area capabilities of the aircraft. The results indicated that the airplane could be flown on a 7 deg glide-slope ILS-type approach in still air with an adequate 3 deg margin for downward correction.

Crane, H. L.↗