Search NASA⌕ Search

Engineering topics

Flamant, P.

Publications and source records attributed to Flamant, P..

Boundary layer structure over the ocean observed by LEANDRE 1 during a tramontane event

A new airborne backscatter lidar, has been developed by CNRS (Service d'Aeronomie, (SA) Laboratoire de Meteorologie Dynamique (LMD) and the Institut des Sciences de 1'Univers) in the frame of the LEANDRE research program. It has been qualified on board the ARAT in autumn 1989 and spring 1990 and was involved in its first cooperative campaign during PYREX in October and November 1990. During this campaign, lidar observations of the perturbations induced on tropospheric flow and boundary layer structure were performed, and results are presented. A large number of experiments were performed, for synoptic situation description (meteorological radiosoundings, constant level balloons) and local flow analysis (aircrafts, radars, sodars). For the first time in such an experiment, a lidar has been flown on a research aircraft to perform altitude resolved observations of these perturbations, and we will present here results obtained for deflected flow structure. In the presence of a synoptic northerly flow, part of it is deflected to the east by the Pyrenees, and accelerated over the Mediterranean by the mountain surroundings. In this case, a low level wind is generated (the Tramontane) bringing cold and dry air over the Mediterranean Sea. As the sea is still at a warm temperature in November (around 17 degrees), an Internal Marine Boundary Layer rapidly grows over the first tens of kilometers and stabilizes at about 1 km depth, corresponding to an altitude just below the Lifting Condensation Level. The whole Marine Atmospheric Boundary Layer (MABL) is characterized by highly turbulent motions bringing large humid particles from the surface up to its top. The lidar signal due to scattering by these particles is then representative of the turbulent kinetic energy in this layer.

Flamant, C.↗

Alexandrite laser source for atmospheric lidar measurements

During the past years, there has been a marked increase in interest in the applications of vibronic solid state lasers to meteorology and atmospheric physics. Two airborne lidar programs are now under development in France. The differential absorption lidar (DIAL) method with vibronic solid state lasers is very attractive for water vapor, temperature and pressure measurements. Alexandrite laser and titanium-sapphire are both suitable for these applications. However, only alexandrite rods are commercially available. The requirements on the laser source for airborne dial applications are two fold: (1) a restriction on laser linewidth and a requirement on stability and tunability with a good spectral purity; and (2) a requirement on the time separation between the two pulses. These constraints are summarized.

Pelon, J.↗

An ER-2 aircraft airborne lidar as part of the development program of a spaceborne system: A potential NASA/CNES cooperative project

A lidar system for atmospheric investigations to fly aboard a high altitude aircraft is introduced. Scientific objectives of the program are reviewed in terms of the expected accuracy and temporal and/or spatial resolution of measurements such as ozone vertical profiles in the troposphere and stratosphere, cirrus clouds studies, tropospheric and stratospheric aerosol monitoring and water vapor measurements in the boundary layer and at the troposphere stratosphere interface. The instrument is conceived as an autonomous, space qualified system as a first step towards a fully automated system for spaceborne applications.

Megie, G.↗