Engineering topics

Flamant, Pierre H.

Publications and source records attributed to Flamant, Pierre H..

3 records

NASA NTRS2011

Can CO2 Turbulent Flux Be Measured by Lidar? A Preliminary Study

The vertical profiling ofCO2 turbulent fluxes in the atmospheric boundary layer (ABL) is investigated using a coherent differential absorption lidar (CDIAL) operated nearby a tall tower in Wisconsin during June 2007. A CDIAL can perform simultaneous range-resolved CO2 DIAL and velocity measurements. The lidar eddy covariance technique is presented. The aims of the study are (i) an assessment of performance and current limitation of available CDIAL for CO2 turbulent fluxes and (ii) the derivation of instrument specifications to build a future CDIAL to perform accurate range-resolved CO2 fluxes. Experimental lidar CO2 mixing ratio and vertical velocity profiles are successfully compared with in situ sensors measurements. Time and space integral scales of turbulence in the ABL are addressed that result in limitation for time averaging and range accumulation. A first attempt to infer CO2 fluxes using an eddy covariance technique with currently available 2-mm CDIAL dataset is reported.

Gilbert, Fabien↗

NASA NTRS1994

Airborne CO2 coherent lidar measurements of cloud backscatter and opacity over the ocean surface

The use of an airborne CO2 lidar to obtain cloud backscatter and extinction data at a thermal infrared wavelength is described. The extinction in this spectral region is proportional to the cloud liquid water content. The use of coherent detection results in high sensitivity and narrow field of view, the latter property greatly reducing multiple-scattering effects. Backscatter measurements in absolute units are obtained through a hard target calibration methodology. For clouds of low to moderate optical thickness at the lidar wavelength, both geometric thickness and optical thickness can be measured. The sea surface reflectance signal is used to obtain estimates of the cloud optical thickness. The utility of this technique results from studies that indicate that the spatial scale of variability of the sea surface reflectance is generally large compared with that of cloud optical thickness. Selected results are presented from data taken during flights over the Pacific Ocean.

Menzies, Robert T.↗

NASA NTRS1992

A comparison of lidar inversion methods for cirrus applications

Several methods for inverting the lidar equation are suggested as means to derive the cirrus optical properties (beta backscatter, alpha extinction coefficients, and delta optical depth) at one wavelength. The lidar equation can be inverted in a linear or logarithmic form; either solution assumes a linear relationship: beta = kappa(alpha), where kappa is the lidar ratio. A number of problems prevent us from calculating alpha (or beta) with a good accuracy. Some of these are as follows: (1) the multiple scattering effect (most authors neglect it); (2) an absolute calibration of the lidar system (difficult and sometimes not possible); (3) lack of accuracy on the lidar ratio k (taken as constant, but in fact it varies with range and cloud species); and (4) the determination of boundary condition for logarithmic solution which depends on signal to noise ration (SNR) at cloud top. An inversion in a linear form needs an absolute calibration of the system. In practice one uses molecular backscattering below the cloud to calibrate the system. This method is not permanent because the lower atmosphere turbidity is variable. For a logarithmic solution, a reference extinction coefficient (alpha(sub f)) at cloud top is required. Several methods to determine alpha(sub f) were suggested. We tested these methods at low SNR. This led us to propose two new methods referenced as S1 and S2.

Elouragini, Salem↗