Engineering topics

Flittner, D.

Publications and source records attributed to Flittner, D..

3 records

NASA NTRS2007

A Slow Retrieval Algorithm for Satellite and Surface Based Instruments

We present results of a retrieval algorithm for satellite and ground based instruments using the Arizona radiative transfer code. A state vector describing the atmospheric and surface condition is iteratively modified until the calculated radiances match the observed values. Elements of the state vector include: aerosol concentrations, radius, optical properties, mass-weighted altitudes, chlorophyll concentration and wind speed. While computationally expensive, many assumptions used in other retrieval algorithms are not invoked. We present co-located retrievals for MODIS, SEAWIFS and nearby AERONET sites. MODIS AQUA and SEA WIFS: Ten MODIS (.412 - 2.110 microns) and eight SEA WIFS (.412-.865 microns) radiances (.412-.865 microns) include channels where aerosols absorb and reflect radiation. We focus on retrieving bio-mass burning aerosols that are advected over open ocean. Since chlorophyll absorbs at frequencies where black carbon absorbs, our retrieval algorithm accounts for chlorophyll absorption by simultaneously retrieving both aerosol and chlorophyll amount. Our retrieved chlorophyll concentrations are similar to those from the Ocean Color Group. AERONET: Both Almucantar and Principle plane radiances are used to retrieve the state of the atmosphere and ocean conditions. Our retrieved aerosol size distributions and optical properties are consistent with the aerosol inversions from the AERONET group.

Weaver, C.↗

NASA NTRS2002

Description and Sensitivity Analysis of the SOLSE/LORE-2 and SAGE III Limb Scattering Ozone Retrieval Algorithms

The SOLSE (Shuttle Ozone Limb Sounding Experiment) and LORE (Limb Ozone Retrieval Experiment) instruments are scheduled for reflight on Space Shuttle flight STS-107 in July 2002. In addition, the SAGE III (Stratospheric Aerosol and Gas Experiment) instrument will begin to make limb scattering measurements during Spring 2002. The optimal estimation technique is used to analyze visible and ultraviolet limb scattered radiances and produce a retrieved ozone profile. The algorithm used to analyze data from the initial flight of the SOLSE/LORE instruments (on Space Shuttle flight STS-87 in November 1997) forms the basis of the current algorithms, with expansion to take advantage of the increased multispectral information provided by SOLSE/LORE-2 and SAGE III. We also present detailed sensitivity analysis for these ozone retrieval algorithms. The primary source of ozone retrieval error is tangent height misregistration (i.e., instrument pointing error), which is relevant throughout the altitude range of interest, and can produce retrieval errors on the order of 10-20 percent due to a tangent height registration error of 0.5 km at the tangent point. Other significant sources of error are sensitivity to stratospheric aerosol and sensitivity to error in the a priori ozone estimate (given assumed instrument signal-to-noise = 200). These can produce errors up to 10 percent for the ozone retrieval at altitudes less than 20 km, but produce little error above that level.

Loughman, R.↗

NASA NTRS2000

Actinic Flux Calculations: A Model Sensitivity Study

calculate direct and diffuse surface irradiance and actinic flux (downwelling (2p) and total (4p)) for the reference model. Sensitivity analysis has shown that the accuracy of the radiative transfer flux calculations for a unit ETS (i.e. atmospheric transmittance) together with a numerical interpolation technique for the constituents' vertical profiles is better than 1% for SZA less than 70(sub o) and wavelengths longer than 310 nm. The differences increase for shorter wavelengths and larger SZA, due to the differences in pseudo-spherical correction techniques and vertical discretetization among the codes. Our sensitivity study includes variation of ozone cross-sections, ETS spectra and the effects of wavelength shifts between vacuum and air scales. We also investigate the effects of aerosols on the spectral flux components in the UV and visible spectral regions. The "aerosol correction factors" (ACFs) were calculated at discrete wavelengths and different SZAs for each flux component (direct, diffuse, reflected) and prescribed IPMMI aerosol parameters. Finally, the sensitivity study was extended to calculation of selected photolysis rates coefficients.

Krotkov, Nickolay A.↗