Folkman, S. L. | Search NASA

NASA NTRS1979

Thrust oscillations of the Space Shuttle solid rocket Booster motor during static tests

Thrust oscillations have occurred during static tests of Space Shuttle Booster solid rocket motors. These oscillations in measured axial thrust occurred primarily near 15 Hz; these oscillations late in the motor burn reach magnitudes up to approximately + or - 3% of motor thrust. The phenomenon has consistently occurred on the four demonstration motors which have been static tested and appears to be associated with small amplitude, 15 Hz pressure oscillations inside the motor. The source of the pressure oscillations is thought to be associated with the fundamental longitudinal acoustic resonance of the motor at 15 Hz. These thrust oscillations potentially can impact the design of the Space Shuttle vehicle structure. The demonstration motors have been instrumented with an array of transducers to aid in understanding the phenomenon. In addition to measuring axial and lateral thrust of the motor, pressure transducers were located to measure chamber pressure oscillations at the forward dome. Accelerometers and extensometers have measured motions of the structure. A modal survey was conducted on a fired motor to identify its structural dynamic characteristics, and these data were used to validate mathematical models of the motor in the static test facility.

Mason, D. R.↗

NASA NTRS1978

Space Shuttle SRM Ignition System

This paper presents the Space Shuttle SRM Ignition System, which consists of a large solid propellant main igniter, a small solid propellant initiating igniter and an electromechanical safety and arming device containing two NASA Standard Initiators and a B-KNO3 pyrotechnic booster charge. In development motors, the igniter also has a valve through which CO2 is injected for post-firing quench of the SRM. The igniter has redundant, testable seals at all pressurized joints and three major reusable components; the case, the adapter, and the S&A device. Two development problem areas are discussed. One problem area was transverse mode combustion instability in the main igniter with maximum amplitude of 340 psi peak-to-peak at a frequency of 1500 Hz, which was reduced by a propellant grain configuration change and a change from a 2% aluminum content propellant to a formulation containing 10% aluminum. The other problem area was an excessively rapid rise of thrust in the SRM, which was reduced by reducing the igniter mass flow rate. This mass flow rate reduction was accomplished by removing portions of the grain starpoints in the head end.

Bolieau, C. W.↗