Engineering topics
Folkner, William M.
Publications and source records attributed to Folkner, William M..
Corner-Cube Retroreflector Instrument for Advanced Lunar Laser Ranging
A paper describes how, based on a structural-thermal-optical-performance analysis, it has been determined that a single, large, hollow corner cube (170- mm outer diameter) with custom dihedral angles offers a return signal comparable to the Apollo 11 and 14 solid-corner-cube arrays (each consisting of 100 small, solid corner cubes), with negligible pulse spread and much lower mass. The design of the corner cube, and its surrounding mounting and casing, is driven by the thermal environment on the lunar surface, which is subject to significant temperature variations (in the range between 70 and 390 K). Therefore, the corner cube is enclosed in an insulated container open at one end; a narrow-bandpass solar filter is used to reduce the solar energy that enters the open end during the lunar day, achieving a nearly uniform temperature inside the container. Also, the materials and adhesive techniques that will be used for this corner-cube reflector must have appropriate thermal and mechanical characteristics (e.g., silica or beryllium for the cube and aluminum for the casing) to further reduce the impact of the thermal environment on the instrument's performance. The instrument would consist of a single, open corner cube protected by a separate solar filter, and mounted in a cylindrical or spherical case. A major goal in the design of a new lunar ranging system is a measurement accuracy improvement to better than 1 mm by reducing the pulse spread due to orientation. While achieving this goal, it was desired to keep the intensity of the return beam at least as bright as the Apollo 100-corner-cube arrays. These goals are met in this design by increasing the optical aperture of a single corner cube to approximately 170 mm outer diameter. This use of an "open" corner cube allows the selection of corner cube materials to be based primarily on thermal considerations, with no requirements on optical transparency. Such a corner cube also allows for easier pointing requirements, because there is no dependence on total internal reflection, which can fail off-axis.
Ka-Band Transponder for Deep-Space Radio Science
A one-page document describes a Ka-band transponder being developed for use in deep-space radio science. The transponder receives in the Deep Space Network (DSN) uplink frequency band of 34.2 to 34.7 GHz, transmits in the 31.8- to 32.3 GHz DSN downlink band, and performs regenerative ranging on a DSN standard 4-MHz ranging tone subcarrier phase-modulated onto the uplink carrier signal. A primary consideration in this development is reduction in size, relative to other such transponders. The transponder design is all-analog, chosen to minimize not only the size but also the number of parts and the design time and, thus, the cost. The receiver features two stages of frequency down-conversion. The receiver locks onto the uplink carrier signal. The exciter signal for the transmitter is derived from the same source as that used to generate the first-stage local-oscillator signal. The ranging-tone subcarrier is down-converted along with the carrier to the second intermediate frequency, where the 4-MHz tone is demodulated from the composite signal and fed into a ranging-tone-tracking loop, which regenerates the tone. The regenerated tone is linearly phase-modulated onto the downlink carrier.
Gravitational wave missions from LISA to Big Bang Observer
Gravitational waves provide a new means to view the universe complimentary to the view provided by electromagnetic radiation.
Direct Communication to Earth from Probes
A viewgraph presentation on outer planetary probe communications to Earth is shown. The topics include: 1) Science Rational for Atmospheric Probes to the Outer Planets; 2) Controlling the Scientific Appetite; 3) Learning more about Jupiter before we send more probes; 4) Sample Microwave Scan From Juno; 5) Jupiter s Deep Interior; 6) The Square Kilometer Array (SKA): A Breakthrough for Radio Astronomy; 7) Deep Space Array-based Network (DSAN); 8) Probe Direct-to-Earth Data Rate Calculations; 9) Summary; and 10) Enabling Ideas.
The Space Technology 7 Disturbance Reduction System
This viewgraph presentation reviews the design and development of the Disturbance Reduction System (DRS). The colloidal microthrusters will allow for precise, quiet spacecraft position and attitude control. The DRS will be attached to ESAS's SMART-2 spacecraft.
Nominal frequency allocation plan for LISA
Explore the source record for details and available documents.
Controller Design for the ST7 Disturbance Reduction System
The Space Technology 7 experiment will perform an on-orbit system-level validation of two specific Disturbance Reduction System technologies: a gravitational reference sensor employing a free-floating test mass and a set of micro-Newton colloidal thrusters. The Disturbance Reduction System is designed to maintain a spacecraft's position with respect to the free-floating test mass to less than 10 nm/ square root of Hz, over the frequency range 10(exp -3) Hz to 10(exp -2) Hz. This paper presents the design and analysis of the coupled drag-free and attitude control system that closes the loop between the gravitational reference sensor and the micro-Newton thrusters while incorporating star tracker data at low frequencies. The effects of actuation and measurement noise and disturbances on the spacecraft and test masses are evaluated in a seven-degree-of-freedom planar model incorporating two translational and one rotational degrees of freedom for the spacecraft and two translational degrees of freedom for each test mass.
Differential Interferometry For Spacecraft Navigation
Report proposes use of differential very-long-baseline interferometry to measure accurately angular separation, viewed from Earth, of two spacecraft near another planet. One spacecraft would be in orbit around planet on trajectory already determined accurately, relative to planet, by conventional Doppler tracking. Other spacecraft would be approaching planet. Use of differential very-long-baseline interferometry "tie" between two spacecraft and previously determined "tie" between orbiter and planet increases accuracy of navigation of approaching spacecraft relative to planet.
Very-long-baseline-interferometry measurements of planetary orbiters at Mars and Venus
The first attempts to use radio interferometric techniques to measure the positions of planetary orbiters were made in 1980 with the Viking Mars orbiter and again in 1993 using the Pioneer Venus orbiter. The angular accuracy of these early measurements was on the order of 200 nrad. This work describes more recent very-long baseline interferometry (VLBI) measurements made in 1989 of the Soviet Martian orbiter, Phobos 2, and several measurements made since September of 1990 of the Magellan spacecraft orbiting Venus. Both the Phobos and Magellan measurements recorded data with the Mark 3 VLBI systems located at antennas of NASA's Deep Space Network (DSN). The much wider bandwidth of this recording system and the availability of ionospheric calibrations should allow angular accuracy approaching 5 nrad to be achieved with these measurements.
Tracking Two Spacecraft With Same-Beam Interferometry
Accuracy greater than in prior interferometric spacecraft tracking. Report discusses use of same-beam interferometry in determining relative positions of two spacecraft, one in orbit around distant planet, other either in orbit or on surface of planet. Same-beam interferometry used when angle subtended by both spacecraft, as seen from Earth, less than angular width of beam of tracking antenna. Two ground stations separated by long baseline simultaneously and continuously track phases of carrier signals transmitted by both spacecraft.
Ties Between Celestial And Planetary Reference Frames
Report presents new determination of relative orientation (or frame tie) between reference frame of extra-galactic radio sources and reference frame of planetary ephemeris. Method employed for improved frame-tie estimate relies on ability to measure orientation of Earth with respect to inertial reference frame. Improves orbit determination for interplanetary spacecraft.
Position determination of spacecraft at Mars using earth-based differential tracking
The presence of two or more landed or orbiting spacecraft at a planet provides the opportunity to perform extremely accurate earth-based navigation by simultaneously acquiring Doppler data and either Same-Beam Interferometry (SBI) or ranging data. Covariance analyses were performed to investigate the accuracy with which lander and rover positions on the surface of Mars can be determined. Simultaneous acquisition of Doppler and ranging data from a lander and rover over two or more days enables determination of all components of their relative position to under 20 m. Acquiring one hour of Doppler and SBI enables three-dimensional lander-rover relative position determination to better than 5 m. Twelve hours of Doppler and either SBI or ranging from a lander and a low circular or half synchronous circular Mars orbiter makes possible lander absolute position determination to tens of meters.
Spacecraft-spacecraft very long baseline interferometry for planetary approach navigation
The study presents an error budget for Delta differential one-way range (Delta-DOR) measurements between two spacecraft. Such observations, made between a planetary orbiter (or lander) and another spacecraft approaching that planet, would provide a powerful target-relative angular tracking data type for approach navigation. Accuracies of about 5 nrad should be possible for a pair of X-band spacecraft incorporating 40-MHz DOR tone spacings, while accuracies approaching 1 nrad will be possible if the spacecraft incorporate Ka-band downlinks with DOR tone spacings of order 250 MHz. Operational advantages of this data type are discussed, and ground system requirements needed to enable S/C-S/C Delta-DOR observations are outlined. A covariance analysis is presented to examine the potential navigation improvement for this scenario. The results show factors of 2-3 improvement in spacecraft targeting over conventional Doppler, range, and quasar-relative VLBI, along with reduced sensitivity to ephemeris uncertainty and other systematic errors.
Precise tracking of the Magellan and Pioneer Venus orbiters by same-beam interferometry
Results of a demonstration of same-beam interferometry, the simultaneous tracking of two spacecraft in orbit about a distant planet by widely separated earth-based radio antennas, are presented with regard to the Magellan and Pioneer 12 orbiters at Venus. Signals from both spacecraft fall within the same beamwidth of the tracking antennas. The plane-of-sky position difference between spacecraft is precisely determined by double-differenced phase measurements. This data type complements line-of-sight Doppler and improves orbital accuracy by up to an order of magnitude. The predicted error is dominated by solar plasma fluctuations, and is 15.1 psec for a 5-min integration. The rms of the residuals is less than this by about 25 percent. The shape of the spectrum computed from residuals is consistent with that derived from a model of solar plasma fluctuations. Same-beam interferometry is expected to enhance tracking accuracy and efficiency for proposed multiple missions to Mars.
A determination of the radio-planetary frame tie and the DSN tracking station locations
The orientation of the reference frame of radio source catalogs relative to that of planetary ephemerides is uncertain by 30 mas (150 nrad). At this level of uncertainty this orientation offset, or 'frame tie', can be a major systematic error source for interplanetary spacecraft orbit determination. This work presents a method of determining the radio-planetary frame tie from a comparison of Very Long Baseline Interferometry (VLBI) and Lunar Laser Ranging (LLR) station coordinate and earth orientation parameter estimates. Preliminary results are presented which indicate that accuracies of 5 mas or better may be achieved with this method. An important by-product of this method of frame tie determination is a set of Deep Space Network (DSN) station locations with 10 cm per component accuracy. This station set is in a geocentric coordinate system with known orientation relative to the radio and planetary frames.
Differential spacecraft tracking by interferometry
This study estimates measurement system errors for two space vehicles on the surface of Mars, and for two Mars orbiting spacecraft, which are being tracked by differential interferometry. In these examples, signals from all spacecraft lie within the same beamwidth of an earth-based radio antenna. The measurements of all spacecraft signals are made simultaneously; errors that scale with angular source separation or with temporal separation between measurement epochs are practically removed. It is shown that errors due to system thermal noise and to systematic effects within ground receiver electronics dominate, except for geometries when signals pass close to the sun, when solar plasma becomes the dominant error source. The instantaneous relative position of two orbiters may be measured to within ten meters, leading to 50-meter three-dimensional orbital accuracy.