Engineering topics

Forbes, E. G.

Publications and source records attributed to Forbes, E. G..

3 records

DOE OSTI2020

Flow Z-pinch plasma production on the FuZE experiment

The Fusion Z Pinch Experiment (FuZE) investigates sheared-flow stabilization of classic m = 0 and m = 1 instabilities in Z pinches with an embedded axial flow. FuZE consists of a 100 cm coaxial plasma accelerator, where neutral gas is ionized and accelerated in a pulsed electrical discharge, followed by a 50 cm assembly region, where pinches are formed. Maintaining the pinch requires continuous plasma injection provided by a deflagration mode in the coaxial accelerator. Two discharge modes, with and without deflagration, are investigated on FuZE. Pinch formation is observed with deflagration only. Plasma velocities in the assembly region are found to match the E × B velocity estimated in the accelerator based on a 1D circuit model, indicating that a 1D MHD approximation may offer a valid description of the plasma in the accelerator channel. The velocity of magnetic field propagation is found to agree with the snowplow model based on momentum conservation, and the lifetime of the pinch is shown to be in agreement with constraints imposed by mass conservation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Plasma Exhaust in a Sheared-Flow-Stabilized Z Pinch

The fusion Z-pinch experiment device produces a 0.3 cm radius by 50 cm-long Z pinch between the end of the inner electrode of a coaxial plasma gun and an end wall 50 cm away. The plasma column is stabilized for thousands of instability growth times by an embedded radially sheared axial plasma flow. To investigate the effect of end wall design on Z-pinch plasma behavior, the solid end wall with a central exhaust port is replaced with a spoked end wall with a solid hub. While the Z-pinch plasma behavior was largely unaffected, the plasma exhausted from the Z-pinch provides an experimental platform to study magnetic confinement and detachment. Here, current and density signals are compared between two cases: a low energy and a high energy case. Plasma is found to be frozen-in flux in the Z-pinch assembly region. The exhaust of plasma from the flux conserving region is found to be dependent on the ratio of plasma ram and thermal pressures to the local magnetic pressure, calculated from an equilibrium model at the end wall. Plasma exhaust is observed to increase with the spoked end wall only for the high energy conditions as its ratio of ram and thermal pressures to the magnetic pressure increases.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Spatio-temporal ion temperature and velocity measurements in a Z pinch using fast-framing spectroscopy

Ion Doppler spectroscopy (IDS) is a diagnostic technique that measures plasma ion temperature and velocity without perturbing the plasma with a physical probe. The ZaP-HD Flow Z-Pinch Experiment at the University of Washington uses this technique to resolve radial temperature and velocity profiles of a Z-pinch plasma. The pinch lifetime is approximately 100 ms, therefore diagnostics capable of sub-microsecond resolution are required to measure the evolution of temperature and velocity profiles. The previous IDS diagnostic system was only capable of collecting a single measurement during a plasma pulse. Here, an improved system has been developed to measure radially-resolved ion temperature and velocity for the entire Z-pinch lifetime. A Kirana 05M ultra-fast framing camera and SIL ultraviolet intensifier are used to record up to 100 spectra per plasma pulse. The temperature is computed from Doppler broadening of the carbon-III (229.687 nm) impurity ion radiation and the velocity from the Doppler shift of carbon-III. Measurements are able to resolve the evolution of the ion temperature and velocity over the course of a plasma pulse. The diagnostic has significantly reduced the number of pulses required and provides a more coherent measurement of plasma dynamics than the previous system.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗