The Control of Float Zone Interfaces by the Use of Selected Boundary Conditions
Since the float zone process involves two solid-melt interfaces, possible gas interfaces, heat and mass transfers, various driving forces and complex heating sources, an analysis of the entire process would be very complex. For an initial investigation, a more feasible approach is to examine each component of the process separately. The three principal components are: (1) the shapes of the melt and solid-melt interfaces, (2) the heat and mass transfers, and (3) the heating and cooling sources. This study combined facets of all three components. The purpose of this effort was to study and compute the surface boundary conditions required to give flat (float zone) FZ solid-melt interfaces. This study was undertaken in two phases. The first phase was to investigate the solid zones surface boundary conditions required for flat solid-melt interfaces when given the melt zone surface boundary conditions. The second phase complemented the first and was to investigate the melt zone surface boundary conditions required for flat solid-melt interfaces if given the solid zones surface boundary conditions. Dual integral transform methods were used in both phases; in addition, the use of various numerical methods for differential equations and linear systems of equations were required.