Engineering topics

Foudriat, Edwin C.

Publications and source records attributed to Foudriat, Edwin C..

8 records

NASA NTRS1989

The Information Science Experiment System - The computer for science experiments in space

The concept of the Information Science Experiment System (ISES), potential experiments, and system requirements are reviewed. The ISES is conceived as a computer resource in space whose aim is to assist computer, earth, and space science experiments, to develop and demonstrate new information processing concepts, and to provide an experiment base for developing new information technology for use in space systems. The discussion covers system hardware and architecture, operating system software, the user interface, and the ground communication link.

Foudriat, Edwin C.↗

NASA NTRS1985

Distributed computer taxonomy based on O/S structure

The taxonomy considers the resource structure at the operating system level. It compares a communication based taxonomy with the new taxonomy to illustrate how the latter does a better job when related to the client's view of the distributed computer. The results illustrate the fundamental features and what is required to construct fully distributed processing systems. The problem of using network computers on the space station is addressed. A detailed discussion of the taxonomy is not given here. Information is given in the form of charts and diagrams that were used to illustrate a talk.

Foudriat, Edwin C.↗

NASA NTRS1962

Study of an Automatic System for Control of the Terminal Phase of Satellite Rendezvous

An analytical and simulation study has been conducted of an automatic system for control of the terminal phase of rendezvous between two space vehicles. The basic system employs switching and thrust orientation criteria based upon relative-motion parameters first to establish a collision course and then to reduce the range and range rate to zero, simultaneously. In addition, a technique has been devised by which the system effects control based upon the total amount of fuel available for this phase of the space mission. The onboard equipment assumed for the intercepting vehicle includes a special-purpose computer, an attitude-control system, a single main rocket engine with, multi-start capabilities, and sensors capable of measuring range, line-of sight angles, and the time derivatives of these quantities. Techniques are developed. for employing control with either modulated thrust or on-off thrust at a constant level. The results of an analog simulation study of the automatic control system in which a six-degree-of freedom vehicle is assumed are presented for various initial conditions at the beginning of the terminal phase. The results of the study indicate that the automatic system can effectively control the terminal phase of rendezvous over a wide range of initial conditions and control-system requirements and, in addition, can utilize the available fuel in a very efficient manner.

RENDEZVOUS↗

NASA NTRS1962

Study of an Automatic System for Control of the Terminal Phase of Satellite Rendezvous

An analytical and simulation study was conducted of an automatic system to control the terminal phase of rendezvous between two space vehicles. The system employs switching and thrust orientation criteria based upon relative-motion parameters first to establish a collision course and then to reduce the range and range rate to zero simultaneously. Techniques are developed for employing either modulated thrust or on-off thrust at a constant level. Results of the study indicate that the automatic system can effectively control rendezvous over a wide range of initial conditions and can utilize the available fuel in a very efficient manner.

Lineberry, Edgar C., Jr.↗

NASA NTRS1961

Guidance and Control During Direct-Descent Parabolic Reentry

The results of studies of four reentry guidance and control techniques for the energy management of vehicles returning to the earth at escape speeds are compared in this paper. The reentry trajectories are constrained to those of direct descent, that is, where the vehicle does not leave that portion of the atmosphere where useful aerodynamic forces are available after its initial entry. The guidance techniques compared are: (1) a piloted simulator study reference trajectory techniques; 2) An automatic controller using reference trajectory techniques; 3) A predictor system employing linear prediction (perturbation) techniques; and 4) A repetitive prediction system employing rapid-time computer techniques.

Foudriat, Edwin C.↗

NASA NTRS1961

Study of the Use of a Terminal Controller Technique for Reentry Guidance of a Capsule-Type Vehicle

A study has been made of the use o f a terminal controller technique i n the guidance of a high-drag, variable-lift reentry vehicle to a desired landing point. The technique uses linearized equations of motion attained by the perturbation of the dependent variables from those of a reference trajectory. The guidance system continuously predicts the terminal range error and uses this error to control the angle of attack of the vehicle in an on-off manner until the predicted range error is within +-O.1 degrees of the required arc or +-6.9 miles.

Foudriat, Edwin C.↗

NASA NTRS1961

Analog Simulation of a Pilot-Controlled Rendezvous

The rendezvous of a pilot-controlled space ferry vehicle with an orbiting space station was simulated in six degrees of freedom. A fixed-base simulator and an analog computer were used. The ferry vehicle was assumed to have a single main thrusting rocket and to be provided with attitude control. Control of the thrust was provided by a rocket throttle quadrant which could provide either proportional or on-off control. The attitude of the vehicle was controlled during the rendezvous with a two-axis, pencil-type side-arm controller and rudder pedals. For the most part rendezvous maneuvers were made with the target satellite in a circular orbit. In addition, an elliptical station orbit was investigated. Tolerable initial conditions, as well as adequate data presentations, were determined. Results of the investigation indicate that a human pilot can rendezvous successfully with the vehicle and instrumentation considered over a wide band of initial conditions. Coplanar conditions are not necessary. Retro-rocket fuel used is not greatly increased by imposing perturbing influences such as rocket-misalignment torques on the rendezvous vehicle. When excessive attitude-control torques are required to maintain the necessary trim attitudes under misalignment influences, the reaction fuel used for this control increases. The time required for a specific rendezvous varies somewhat between pilots. If control of the time for completing the rendezvous is desired, requirements for retrorocket fuel are affected, and an energy-management schedule is required. Continuous variation of the thrust is not necessary. The pilot positions the throttle to obtain a desired level of thrust, and applies bursts of thrust as required. All data were presented on dialed instruments. The quantities required are range and range rate and line-of-sight rates between the vehicle and the station, vehicle attitudes and angular rates, and the angles subtended by the line of sight. For the equipment assumed herein, satellite rendezvous presented no great problem to the pilot.

Brissenden, Roy F.↗

NASA NTRS1961

Application of Describing-Function Analysis to the Study of an On-Off Reaction-Control System

An analytical study was made of an automatic reaction-control system for the upper stages of a missile to determine limit cycle characteristics, corresponding duty cycles, and the effects of the various system parameters on these quantities. A nonlinear servo analysis (describing function) technique was used to obtain a mathematical representation of the nonlinear components of the system. The results obtained by this analysis are compared with the results obtained from an analog simulation including the jet reaction-control hardware. The good agreement between the results of the two studies tends to indicate the feasibility of using such an analysis technique in the early design phase of a reaction-control system, since by so doing, the parameters for good system performance can be determined quite readily.

Lineberry, Edgar C., Jr.↗