Engineering topics

Franz, J. R.

Publications and source records attributed to Franz, J. R..

3 records

NASA NTRS2001

Plasma Waves Observed in the Cusp Turbulent Boundary Layer: An Analysis of High Time Resolution Wave and Particle Measurements from the Polar Spacecraft

The boundary layer located in the cusp and adjacent to the magnetopause is a region that is quite turbulent and abundant with waves. The Polar spacecraft's orbit and sophisticated instrumentation are ideal for studying this region of space. Our analysis of the waveform data obtained in this turbulent boundary layer shows broadband magnetic noise extending up to a few kilohertz (but less than the electron cyclotron frequency); sinusoidal bursts (a few tenths of a second) of whistler mode waves at around a few tens of hertz, a few hundreds of hertz, and just below the electron cyclotron frequency; and bipolar pulses, interpreted as electron phase-space holes. In addition, bursts of electron cyclotron harmonic waves are occasionally observed with magnetic components. We show evidence of broadband electrostatic bursts covering a range of approx. 3 to approx. 25 kHz (near but less than the plasma frequency) occurring in packets modulated at the frequency of some of the whistler mode waves. On the basis of high time resolution particle data from the Polar HYDRA instrument, we show that these bursts are consistent with generation by the resistive medium instability. The most likely source of the whistler mode waves is the magnetic reconnection site closest to the spacecraft, since the waves are observed propagating both toward and away from the Earth, are bursty, which is often the case with reconnection, and do not fit on the theoretical cold plasma dispersion relation curve.

Pickett, J. S.↗

NASA NTRS1999

Plasma Waves Observed During CUSP Energetic Particle Events and Their Correlation With Polar and Akebono Satellite and Ground Data

We present Polar plasma wave data during cusp energetic particle (CEP) events at 6-9 R(sub E). These data suggest the presence of coherent electrostatic structures that are highly localized and that have typical velocities on the order of hundreds to thousands of kilometers per second along the ambient magnetic field. Some of the wave signatures are solitary waves and some are wave packets. The Polar wave instrument also provides evidence that some of the bursts of electromagnetic waves (with frequencies of a few hundred Hz and just below the electron cyclotron frequency around 800 Hz to 1-2 kHz) that are observed are coher&nt and propagating both up and down the field lines. Electron cyclotron harmonic (ECH) waves are often detected but their duration is usually short (less than 1 second). Low Frequency (less than 1 kHz), broadband, bursty electromagnetic waves are also present. The Polar wave data results are used to obtain a better understanding of the macro/microphysics during a CEP event that takes place on September 11, 1996, by correlating various Polar (approximately 7.0 R(sub E)) and Akebono (approximately 1.4 R(sub E)) data while both spacecraft are in or near the cusp/cleft region and nearly on the same field line, and magnetometer data from the Canadian Intermagnet and Canopus ground stations, which lie near the base of the magnetic footprint passing through Polar. Solar wind and magnetic field data from the interplanetary medium and magnetosheath are provided by the Geotail and IMP-8 satellites, respectively. Some of the cusp waves may be indicators of the reconnection process taking place through the cusp, the result of mixing of magnetosheath with magnetospheric plasma, and the consequence of an anisotropic electron population in a depressed magnetic field. The low frequency electromagnetic waves are still under study to determine their role, if any, in the heating and acceleration of the MeV He ions during CEP events.

Pickett, J. S.↗

NASA NTRS1993

FNAS computational modeling

Numerical calculations of the electronic properties of liquid II-VI semiconductors, particularly CdTe and ZnTe were performed. The measured conductivity of these liquid alloys were modeled by assuming that the dominant temperature effect is the increase in the number of dangling bonds with increasing temperature. For low to moderate values of electron correlation, the calculated conductivity as a function of dangling bond concentration closely follows the measured conductivity as a function of temperature. Both the temperature dependence of the chemical potential and the thermal smearing in region of the Fermi surface have a large effect on calculated values of conductivity.

Franz, J. R.↗