Engineering topics

Fricke, J.

Publications and source records attributed to Fricke, J..

3 records

DOE OSTI2020

Non-uniform longitudinal current density induced power saturation in GaAs-based high power diode lasers

The output power of modern 975 nm GaAs-based broad area diode lasers is limited by increasing carrier and photon losses at high bias. Here, we use experiment and one-dimensional calculations on these devices to reveal that higher current densities (and hence higher local recombination rates and higher losses) arise near the front facet due to spatial hole burning and that the non-uniformity is strongly affected by laser geometry, which is more severe for longer resonators and less severe for higher front facet reflectivity. Specifically, we use devices with a segmented p-contact to directly measure the current distribution along the resonator and compare this with laser simulation. Devices with a 6 mm resonator show 29% more current at the front than back, twice as large as the 15% current non-uniformity in devices with a 3 mm resonator. In contrast, increased front facet reflectivity (20% rather than 0.8%) is shown to almost halve the current non-uniformity from 29% to 18% in devices with a 6 mm resonator and reduces power saturation. Although the magnitude of current non-uniformity in experiment and theory is broadly consistent, in experiment, an additional divergence is seen in current flow (and hence recombination rate) near the facets, and earlier power saturation occurs. Finally, we discuss the possible saturation mechanisms that are not included in the simulation.

47 OTHER INSTRUMENTATION↗

NASA NTRS1972

Excitation of sodium D-line radiation in collisions of sodium atoms with internally excited H2, D2 and N2.

Excitation of D-line radiation in collisions of Na atoms with vibrationally excited N2, H2, and D2 was studied in two modulated crossed-beam experiments. In both experiments, the molecular excitation was provided by heating the molecular beam to temperatures which were assumed to give populations corresponding to the Boltzmann distribution. In the first experiment, a total rate coefficient was measured as a function of molecular beam temperature. The second experiment achieved partial separation of internal vs kinetic energy transfer effects by using a velocity-selected molecular beam. The data from both experiments were used to determine parameters for the dependence of the transfer cross section upon the kinetic energy for a given change in the vibrational quantum number. Results indicate that most of the Na excitation energy comes from internal vibrational energy, with the remainder coming from kinetic energy.

Krause, H. F.↗

NASA NTRS1972

Excitation of Na D-line radiation in collisions of sodium atoms with internally excited H2, D2, and N2

Excitation of D-line radiation in collisions of Na atoms with vibrationally excited N2, H2 and D2 was studied in two modulated crossed beam experiments. In both experiments, the vibrational excitation of the molecules was provided by heating the molecular beam source to temperatures in the range of 2000 to 3000 K, which was assumed to give populations according to the Boltzmann expression. In the first experiment, a total rate coefficient was measured as a function of molecular beam temperature, with absolute calibration of the photon detector being made using the black body radiation from the heated molecular beam source. Since heating affects both the internal energy and the collisional kinetic energy, the first experiment could not determine the relative contributions of internal energy transfer versus collisional excitation. The second experiment achieved partial separation of internal versus kinetic energy transfer effects by using a velocity-selected molecular beam. Using two simple models for the kinetic energy dependence of the transfer cross section for a given change in vibrational quantum number, the data from both experiments were used to determine parameters in the models.

Krause, H. F.↗