Engineering topics

Frigione, D.

Publications and source records attributed to Frigione, D..

5 records

DOE OSTI2024

Alpha particle loss measurements and analysis in JET DT plasmas

Abstract Burning reactor plasmas will be self-heated by fusion born alpha particles from deuterium-tritium reactions. Consequently, a thorough understanding of the confinement and transport of DT-born alpha particles is necessary to maintain the plasma self-heating. Measurements of fast ion losses provide a direct means to monitor alpha particle confinement. JET’s 2021–2022 second experimental DT-campaign offers burning plasma scenarios with advanced fast ion loss diagnostics for the first time in nearly 25 years. Coherent and non-coherent alpha losses were observed due to a variety of low frequency MHD activity. This manuscript will present the loss mechanisms, spatial and pitch dependencies, scalings with plasma parameters, correlations with wall impurities, and magnitude of DT-alpha born losses.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

Prediction of transport in the JET DTE2 discharges with TGLF and NEO models using the TGYRO transport code

Abstract The JET Deuterium-Tritium-Experiment Campaign 2 (DTE2) has demonstrated the highest-ever fusion energy production. To forecast the transport dynamics within these discharges, the TGLF and NEO models within the TGYRO transport code were employed. A critical development in this study is the new quasilinear transport model, TGLF-SAT2, specifically designed to resolve discrepancies identified in JET deuterium discharges. This model accurately describes the saturated three-dimensional (3D) fluctuation spectrum, aligning closely with a database of nonlinear CGYRO turbulence simulations, thereby enhancing the predictive accuracy of TGYRO simulations. In validating against the JET DTE2 discharges across two primary operating scenarios, TGYRO effectively predicted the temperature profiles within a broad radial window ( ρ ∼ 0.2–0.85), though with minor ion temperature discrepancies near the core. However, a consistent underprediction of electron density profiles by 20% across the simulation domain was noted, indicating areas for future refinement. To achieve a self-consistent steady-state solution based on the JET DTE2 discharges, an integrated modeling workflow TGYRO-STEP within the OMFIT framework was introduced. This workflow iterates among the core transport, the pedestal pressure and the MHD equilibrium, ultimately yielding a converged solution that significantly reduces dependence on experimental boundary conditions for temperature and density profiles. The integrated simulation results show negligible differences in electron density and temperature profiles compared to standalone TGYRO modeling, while the ion temperature profile is lower due to the updated boundary condition in TGYRO-STEP. The application of the TGYRO-STEP workflow to JET DTE2 discharges serves as a crucial test to validate its robustness and highlights its limitations, providing valuable insights for its potential future application in ITER and Fusion Power Plant deuterium and tritium prediction modeling.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

The JET hybrid scenario in Deuterium, Tritium and Deuterium-Tritium

The JET hybrid scenario has been developed from low plasma current carbon wall discharges to the record-breaking Deuterium-Tritium plasmas obtained in 2021 with the ITER-like Be/W wall. The development started in pure Deuterium with refinement of the plasma current, and toroidal magnetic field choices and succeeded in solving the heat load challenges arising from 37 MW of injected power in the ITER like wall environment, keeping the radiation in the edge and core controlled, avoiding MHD instabilities and reaching high neutron rates. The Deuterium hybrid plasmas have been re-run in Tritium and methods have been found to keep the radiation controlled but not at high fusion performance probably due to time constraints. For the first time this scenario has been run in Deuterium-Tritium (50:50). These plasmas were re-optimised to have a radiation-stable H-mode entry phase, good impurity control through edge T i gradient screening and optimised performance with fusion power exceeding 10 MW for longer than three alpha particle slow down times, 8.3 MW averaged over 5 s and fusion energy of 45.8 MJ.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Parameter dependencies of the separatrix density in low triangularity L-mode and H-mode JET-ILW plasmas

Abstract The midplane electron separatrix density, n e,sep , in JET-ILW L-mode and H-mode low triangularity deuterium fuelled plasmas exhibits a strong explicit dependence on the averaged outer divertor target electron temperature, n e,sep ∼ T e,ot −1/2 . This dependence is reproduced by analytic reversed two point model (rev-2PM), and arises from parallel pressure balance, as well as the ratio of the power and momentum volumetric loss factors, (1 − f cooling )/(1 − f mom-loss ). Quantifying the influence of the (1 − f cooling ) and (1 − f mom-loss ) loss factors on n e,sep has been enabled by measurement estimates of these quantities from L-mode density (fueling) ramps in the outer horizontal, VH(C), and vertical target, VV, divertor configurations. Rev-2PM n e,sep estimates from the extended H-mode and more limited L-mode datasets are recovered to within ±25% of the measurements, with a scaling factor applied to account for use of T e,ot , an averaged quantity, rather than flux tube resolved target values. Both the (1 − f cooling ) and (1 − f mom-loss ) trends and recovery of n e,sep using the rev-2PM formatting are reproduced in EDGE2D-EIRENE L-mode-like and H-mode-like density scan simulations. The general lack of a divertor configuration effect in the JET-ILW n e,sep trends can be attributed to a significant influence of main chamber recycling, which has been shown in the EDGE2D-EIRENE results to moderate n e,sep with respect to changes in divertor neutral leakage imposed by changes in the divertor configuration. The unified n e,sep vs T e,ot trends can, however, be broken if large modifications to the divertor geometry (e.g. complete removal of the outer divertor baffle structure) are introduced in the model. The more pronounced high-field side high density region formation in the VH(C) configuration with reduced clearance to the separatrix does not appear to have a significant influence on the outer midplane separatrix and pedestal parameters when mapped to T e,ot , although conditions at the inner midplane could not be assessed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Experimental study on the role of the target electron temperature as a key parameter linking recycling to plasma performance in JET-ILW*

Changes in global and edge plasma parameters (H98(y,2), dimensionless collisionality ν*, core density peaking, separatrix density ne,sep) with variations in the D2 fueling rate and divertor configuration are unified into a single trend when mapped to $\langle$Te,ot$\rangle$, the spatially averaged spectroscopically derived outer target electron temperature. Dedicated JET with the ITER-like wall (JET-ILW) experiments in combination with an extended JET-ILW database of unseeded low-triangularity H-mode plasmas spanning a wide range of D2 fueling rates, Ip, Bt and heating power have demonstrated the importance of $\langle$Te,ot$\rangle$ as a key physics parameter linking the recycling particle source and detachment with plasma performance. The remarkably robust H98(y,2) trend with $\langle$Te,ot$\rangle$ is connected to a strong inverse correlation between $\langle$Te,ot$\rangle$, ne,sep and ν*, thus directly linking changes in the divertor recycling moderated by $\langle$Te,ot$\rangle$ with the previously established relationship between ν*, core density peaking and core pressure resulting in a degradation in core plasma performance with decreasing $\langle$Te,ot$\rangle$ (increasing ν*). Additionally, a strong inverse correlation between the separatrix to pedestal density ratio, ne,sep/ne,ped, and $\langle$Te,ot$\rangle$ is also established, with the rise in ne,sep/ne,ped saturating at $\langle$Te,ot$\rangle$ > 10 eV. A strong reduction in H98(y,2) is observed as $\langle$Te,ot$\rangle$ is driven from 30 to 10 eV via additional D2 gas fueling, while the divertor remains attached. Consequently, the pronounced performance degradation in attached divertor conditions has implications for impurity seeding radiative divertor scenarios, in which H98(y,2) is already low (~0.7) before impurities are injected into the plasma since moderate gas fueling rates are required to promote high divertor neutral pressure. A favorable pedestal pressure, pe,ped, dependence on Ip has also been observed, with an overall increase in pe,ped at Ip = 3.4 MA as $\langle$Te,ot$\rangle$ is driven down from attached to high-recycling divertor conditions. In contrast, pe,ped is reduced with decreasing $\langle$Te,ot$\rangle$ in the lower Ip branches. Further work is needed to (i) clarify the potential role of edge opacity on the observed favorable pedestal pressure Ip scaling; as well as to (ii) project the global and edge plasma performance trends with $\langle$Te,ot$\rangle$ to reactor-scale devices to improve predictive capability of the coupling between recycling and confined plasma fueling in what are foreseen to be more opaque edge plasma conditions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗