Engineering topics
Publications and source records attributed to Frost, Walter.
Aircraft measurement techniques are reviewed. Review of past and present applications of instrument aircraft to atmospheric observations is presented. Questions to be answered relative to measuring mean wind profiles as contrasted to turbulence measurements are then addressed. Requirements of instrumentation and accuracy, data reduction, data acquisition, and theoretical and certainty analysis are considered.
The orographic flow data set was obtained from a flight program to measure the influence of orographic features on turbulence momentum, heat, and moisture fluxes. The NASA B-57 aircraft instrumented with probes for measuring the three fluctuating wind speed components, temperature, and humidity was the primary measuring vehicle. Ancillary measurements were made with several ground-based sensors. These include the NOAA radar wind profilers, the Boulder wind network, the PROFS mesoscale surface network, the Boulder Atmospheric Observatory 300 m tower, special rawinsonde observations, and the NOAA/WPL Doppler lidar. The major objective of the flight program was to provide planetary boundary layer parameter information for new and current general circulation computer models. A numerical code, WINDER, based on a discrete element technique was run to numerically model the water tunnel simulated flow. Comparison of the analytical model with the experimental results is very good. Physical fluid dynamic principles embedded in the computational model and visual and hot wire anemometer measurements from the simulation are being rationalized to develop a physical understanding of the vortex flow. The results will be interpreted as they pertain to full scale atmospheric flows.
Reports on aviation meteorology, most of them informal, are presented by representatives of the National Weather Service, the Bracknell (England) Meteorological Office, the NOAA Wave Propagation Lab., the Fleet Numerical Oceanography Center, and the Aircraft Owners and Pilots Association. Additional presentations are included on aircraft/lidar turbulence comparison, lightning detection and locating systems, objective detection and forecasting of clear air turbulence, comparative verification between the Generalized Exponential Markov (GEM) Model and official aviation terminal forecasts, the evaluation of the Prototype Regional Observation and Forecast System (PROFS) mesoscale weather products, and the FAA/MIT Lincoln Lab. Doppler Weather Radar Program.
A recent innovation in aerodynamic calculation techniques is the formulation based upon scalar and vector potentials (Stokes-Helmholtz decomposition) for the velocity field. This technique is presented: an implementation involving classical panel method is studied. The application of interest is to two-dimensional airfoils moving into a nonuniform approach flow. Comparisons with theoretical and numerical results are included. Furthermore the variations of lift and moment coefficients of quasi-steady simulated flight of an airfoil through microburst wind shear data are studied.
Analysis of turbulence measured across the airfoil of a Cambera B-57 aircraft is reported. The aircraft is instrumented with probes for measuring wind at both wing tips and at the nose. Statistical properties of the turbulence are reported. These consist of the standard deviations of turbulence measured by each individual probe, standard deviations and probability distribution of differences in turbulence measured between probes and auto- and two-point spatial correlations and spectra. Procedures associated with calculations of two-point spatial correlations and spectra utilizing data were addressed. Methods and correction procedures for assuring the accuracy of aircraft measured winds are also described. Results are found, in general, to agree with correlations existing in the literature. The velocity spatial differences fit a Gaussian/Bessel type probability distribution. The turbulence agrees with the von Karman turbulence correlation and with two-point spatial correlations developed from the von Karman correlation.
The purpose of the workshop was to provide a forum for industry, universities, and government to assess current status and likely future requirements for application of flight simulators to aviation safety concerns and system certification issues associated with wind shear and atmospheric turbulence. Research findings presented included characterization of wind shear and turbulence hazards based on modeling efforts and quantitative results obtained from field measurement programs. Future research thrusts needed to maximally exploit flight simulators for aviation safety application involving wind shear and turbulence were identified. The conference contained sessions on: Existing wind shear data and simulator implementation initiatives; Invited papers regarding wind shear and turbulence simulation requirements; and Committee working session reports.
The problems of implementing the JAWS wind shear data are discussed. The data sets are described from the view of utilizing them in an aircraft performance computer program. Then, some of the problems of nonstandard procedures are described in terms of programming the equations of aircraft motion when the effects of temporal and spatially variable winds are included. Finally, some of the computed effects of the various wind shear terms are shown.
The subject of modeling turbulence for use with the JAWS wind shear data sets is addressed. The present FAA AC 120-41 wind shear models are quasisteady wind models. FAA recommends superimposing upon these winds a Dryden spectrum model of turbulence. For the JAWS data, it must be decided whether this approach is adequate or whether turbulence must be analyzed and modeled differently. This question is discussed in detail.
The purpose of the workshop was to bring together various disciplines of the aviation, missile, and space programs involved in predicting, measuring, modeling, and understanding the processes of atmospheric turbulence. Working committees re-examined the current state of knowledge, identified present and future needs, and documented and prioritized integrated and cooperative research programs.
Comparisons of in situ wind and turbulence measurements made with the NASA B-57 instrumented aircraft and those remotely made with both radar and lidar systems are presented. Turbulence measurements with a lidar or radar system as compared with those from an aircraft are the principal themes. However, some discussion of mean wind speed and direction measurements is presented. First, the principle of measuring turbulence with Doppler lidar and radar is briefly and conceptually described. The comparisons with aircraft measurements are then discussed. Two studies in particular are addressed: one uses the JAWS Doppler radar data and the other uses data gathered both with the NASA Marshall Space Flight Center and the the NOAA Wave Propagation Lab. gound based lidars. Finally, some conclusions and recommendations are made.
A flight program to measure the influence of orographic features on turbulent momentum, heat, and moisture fluxes was carried out. Characteristic wake flow patterns were observed in laboratory studies. While the upper level winds (above 10,000 ft msl) blow from west to east (perpendicular to the mountain range), flow patterns similar to flow from a backward-facing step are observed. When the upper level winds blow at 301 and 312 deg from true north (slightly oblique to the mountain range), experimental evidence suggests flow patterns typical of a vortex shed from the mountain range similar to a leading edge vortex from a delta wing aircraft. The observed flow patterns are analyzed. It is concluded that wake flow very similar to those observed in laboratory facilities can occur due to winds over mountain ranges. Results of studies in the laboratory may shed considerable insight to atmospheric boundary layer winds obstructed by orographic features.
A potential improvement on measuring atmospheric winds by using a coherent Doppler system has led to a need for detailed knowledge concerning the aerosol backscattering characteristics, especially at CO2 wavelengths. In order to meet this requirement, a plan of study has been developed to establish a global data base of atmospheric aerosol backscattering coefficients.
General aviation aircraft and helicopters exposed to an icing environment can accumulate ice resulting in a sharp increase in drag and reduction of maximum lift causing hazardous flight conditions. NASA Lewis Research Center (LeRC) is conducting a program to examine, with the aid of high-speed computer facilities, how the trajectories of particles contribute to the ice accumulation on airfoils and engine inlets. This study, as part of the NASA/LeRC research program, develops a computer program for the calculation of icing particle trajectories and impingement limits relative to axisymmetric bodies in the leeward-windward symmetry plane. The methodology employed in the current particle trajectory calculation is to integrate the governing equations of particle motion in a flow field computed by the Douglas axisymmetric potential flow program. The three-degrees-of-freedom (horizontal, vertical, and pitch) motion of the particle is considered. The particle is assumed to be acted upon by aerodynamic lift and drag forces, gravitational forces, and for nonspherical particles, aerodynamic moments. The particle momentum equation is integrated to determine the particle trajectory. Derivation of the governing equations and the method of their solution are described in Section 2.0. General features, as well as input/output instructions for the particle trajectory computer program, are described in Section 3.0. The details of the computer program are described in Section 4.0. Examples of the calculation of particle trajectories demonstrating application of the trajectory program to given axisymmetric inlet test cases are presented in Section 5.0. For the examples presented, the particles are treated as spherical water droplets. In Section 6.0, limitations of the program relative to excessive computer time and recommendations in this regard are discussed.
The proceedings of a workshop on meteorological and environmental inputs to aviation systems held at The University of Tennessee Space Institute, Tullahoma, Tennessee, March 25-27, 1980, are reported. The workshop was jointly sponsored by NASA, NOAA, and FAA and brought together many disciplines of the aviation communities in round table discussions. The major objectives of the workshop are to satisfy such needs of the sponsoring agencies as the expansion of our understanding and knowledge of the interaction of the atmosphere with aviation systems, the better definition and implementation of services to operators, and the collection and interpretation of data for establishing operational criteria relating the total meteorological inputs from the atmospheric sciences to the needs of aviation communities. The unique aspects of the workshop were the diversity of the participants and the achievement of communication across the interface of the boundaries between pilots, meteorologists, training personnel, accident investigators, traffic controllers, flight operation personnel from military, civil, general aviation, and commercial interests alike. Representatives were in attendance from government, airlines, private agencies, aircraft manufacturers, Department of Defense, industries, research institutes, and universities. Full-length papers from invited speakers addressed topics on icing, turbulence, wind and wind shear, ceilings and visibility, lightning, and atmospheric electricity. These papers are contained in the proceedings together with the committee chairmen's reports on the results and conclusions of their efforts on similar subjects.