Search NASA⌕ Search

Engineering topics

Fu, Kai

Publications and source records attributed to Fu, Kai.

29 records · Page 2

Steep-slope field-effect transistors with AlGaN/GaN HEMT and oxide-based threshold switching device

We report the demonstration of a steep-slope field-effect transistor with AlGaN/GaN MIS-HEMTs employing SiO 2 -based threshold switching devices in series with the source. The SiO 2 -based threshold switching devices exhibited steep slope when changing resistance states. The integrated steep-slope transistor showed a low subthreshold swing of sub-5 mV/dec with a transition range of over 10 5 in the transfer characteristics in both sweep directions at room temperature, as well as the low leakage current (10 -5 μA μm -1 ) and a high I ON /I OFF ratio (>10 7 ). Moreover, with the SiO 2 -based threshold switching devices we also observed a positive shift of threshold voltages of the integrated device. Results from more than 50 transfer characteristics measurements also indicate the good repeatability and practicability of such a steep-switching device, where the average steep slopes are below 10 mV/decade. In conclusion, this steep-slope transistor with oxide-based threshold switching devices can be further extended to various transistor platforms like Si and III–V and are of potential interest for the development of power switching and high frequency devices.

36 MATERIALS SCIENCE↗

Non-uniform Mg distribution in GaN epilayers grown on mesa structures for applications in GaN power electronics

A strong variation in the luminescence characteristics in Mg-doped GaN grown on mesa structures has been observed, with the sidewall luminescence being different from that of the flat regions. A comparison with the luminescence characteristics of Mg-doped GaN epilayers with different Mg concentrations indicates that the sidewall has a significantly lower Mg content. Here, this observed non-uniform Mg distribution is attributed to the dependence of Mg incorporation efficiency on the crystal orientation of the growth surface, which should impact the electrical performance of power devices.

36 MATERIALS SCIENCE↗

Threshold Switching and Memory Behaviors of Epitaxially Regrown GaN-on-GaN Vertical $p-n$ Diodes With High Temperature Stability

This letter reports the observation of threshold switching and memory behaviors of epitaxially regrown GaN-on-GaN vertical p-n diodes. This mechanism was ascribed to the conductive path formed by traps in the insulating layer at the regrowth interface after soft breakdown. The device can reliably switch more than 1000 cycles at both room temperature and 300 °C with small fluctuation on the set and reset voltage. The set voltage increased with the increasing temperature due to the enhanced thermal detrapping effect that made it harder to form conductive path at high temperatures. Besides, the device showed memory behaviors when the reset voltage was higher than 4.4 V. This letter can serve as an important reference to further developing GaN-based memory devices and integrated circuits.

36 MATERIALS SCIENCE↗

Investigation of GaN-on-GaN vertical p - n diode with regrown p -GaN by metalorganic chemical vapor deposition

Here, to mimic selective-area doping, p -GaN was regrown on an etched GaN surface on GaN substrates by metalorganic chemical vapor deposition. Vertical GaN-on-GaN p - n diodes were fabricated to investigate the effects of the etch-then-regrowth process on device performance. The crystal quality of the sample after each epitaxial step was characterized by X-ray diffraction, where the etch-then-regrowth process led to a very slight increase in edge dislocations. A regrowth interfacial layer was clearly shown by transmission electron microscopy. Strong electroluminescence was observed with three emission peaks at 2.2 eV, 2.8 eV and 3.0 eV, respectively. The forward current density increased slightly with the increasing temperature, while the reverse current density was almost temperature independent indicating tunneling as the reverse transport mechanism. This result is very similar to the reported Zener tunnel diode comprising a high doping profile at the junction interface. High levels of silicon and oxygen concentrations were observed at the regrowth interface with a distribution width of ~100 nm. This work provides valuable information of p -GaN regrowth and regrown GaN p - n diodes, which can serve as an important reference for developing selective doping for advanced GaN power electronics for high voltage and high power applications.

42 ENGINEERING↗

Nonpolar vertical GaN-on-GaN p–n diodes grown on free-standing $(10\bar{1}0)$ m -plane GaN substrates

We report nonpolar vertical GaN-on-GaN p–n diodes grown on m-plane free-standing substrates. Cathodoluminescence measurements showed that the nonpolar p-GaN had a high quality with very few deep-level states. The device exhibited good rectifying behaviors with a turn-on voltage of 4.0 V, on-resistance of 2.3 mΩ∙cm 2 , and high on/off ratio of 10 10 . The reverse current leakage was described by a trap-assisted space-charge- limited current conduction mechanism. The critical electrical field was calculated to be 2.0 MV/cm without field plates or edge termination. Finally, these results pave the way for development of novel nonpolar power electronics and polarization-engineering-related advanced power devices.

36 MATERIALS SCIENCE↗

High Performance Vertical GaN-on-GaN p-n Power Diodes With Hydrogen-Plasma-Based Edge Termination

This letter reports the first implementation of a hydrogen-plasma-based edge termination technique (HPET) in vertical GaN p-n power diodes grown on bulk GaN substrates using metalorganic chemical vapor deposition. The device with a 9-μm-thick drift layer exhibited a high breakdown voltage (V bd ) of 1.57 kV, a low ON-resistance (R ON ) of 0.45 mQ · cm 2 (or 0.70 mQ · cm 2 with current spreading considered) and a high Baliga's figure-of-merit (V $2\atop{bd}$/R ON ) of 5.5 GW/cm 2 (or 3.6 GW/cm 2 ) without passivation or field plate, which are close to the theoretical limit of GaN. This technique enabled a significant reduction in leakage current (~10 6 times at -300 V) and a huge enhancement in V bd (from ~300 V to 1.57 kV). Furthermore, the device showed good forward characteristics with a turn-ON voltage of 3.5 V, an ON-current of ~2 kA/cm 2 (or 1.3 kA/cm 2 ), an ON/OFF ratio of -10 9 , and an ideality factor of 1.4. This work shows the HPET can serve as an effective, low cost, and easy-to-implement edge termination technique for high voltage and high power GaN p-n power diodes.

36 MATERIALS SCIENCE↗

AlGaN/GaN metal-insulator-semiconductor high electron mobility transistors with reduced leakage current and enhanced breakdown voltage using aluminum ion implantation

This letter has studied the performance of AlGaN/GaN metal-insulator-semiconductor high electron mobility transistors on silicon substrate with GaN buffer treated by aluminum ion implantation for insulating followed by a channel regrown by metal–organic chemical vapor deposition. For samples with Al ion implantation of multiple energies of 140 keV (dose: 1.4 × 10{sup 14} cm{sup −2}) and 90 keV (dose: 1 × 10{sup 14} cm{sup −2}), the OFF-state leakage current is decreased by more than 3 orders and the breakdown voltage is enhanced by nearly 6 times compared to the samples without Al ion implantation. Besides, little degradation of electrical properties of the 2D electron gas channel is observed where the maximum drain current I{sub DSmax} at a gate voltage of 3 V was 701 mA/mm and the maximum transconductance g{sub mmax} was 83 mS/mm.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Quantitative Proteomic Analysis of Mouse Embryonic Fibroblasts and Induced Pluripotent Stem Cells Using 16O /18O labeling

Induced pluripotent stem cells (iPSC) hold great promise for regenerative medicine as well as for investigations into the pathogenesis and treatment of various diseases. Understanding of key intracellular signaling pathways and protein targets that control development of iPSC from somatic cells is essential for designing new approaches to improve reprogramming efficiency. Here we report the development and application of an integrated quantitative proteomics platform for investigating differences in protein expressions between mouse embryonic fibroblasts (MEF) and MEF-derived iPSC. This platform consists of 16O/18O labeling, multidimensional peptide separation coupled with tandem mass spectrometry, and data analysis with UNiquant software. Using this platform a total of 2,481 proteins were identified and quantified from the 16O/18O-labeled MEF-iPSC proteome mixtures with a false discovery rate of 0.01. Among them, 218 proteins were significantly upregulated, while 247 proteins were significantly downregulated in iPSC compared to MEF. Many nuclear proteins, including Hdac1, Dnmt1, Pcna, Ccnd1, Smarcc1, and subunits in DNA replication and RNA polymerase II complex were found to be enhanced in iPSC. Protein network analysis revealed that Pcna functions as a hub orchestrating complicated mechanisms including DNA replication, epigenetic inheritance (Dnmt1) and chromatin remodeling (Smarcc1) to reprogram MEF and maintain stemness of iPSC.

16O/18O labeling↗

UNiquant, a Program for Quantitative Proteomics Analysis Using Stable Isotope Labeling

We present UNiquant, a new software program for analyzing stable isotope labeling (SIL) based quantitative proteomics data. UNiquant surpassed the performance of two other platforms, MaxQuant and Mascot Distiller, using complex proteome mixtures having either known or unknown heavy/light ratios. UNiquant is compatible with a broad spectrum of search engines and SIL methods, providing outstanding peptide pair identification and accurate measurement of the relative peptide/protein abundance.

99 GENERAL AND MISCELLANEOUS↗

Site-Specific Proteomics Approach for Study Protein S-Nitrosylation

Here we present a novel and robust method for the identification of protein S-nitrosylation sites in complex protein mixtures. The approach utilizes the cysteinyl affinity resin to selectively enrich S-nitrosylated peptides reduced by ascorbate followed by nanoscale liquid chromatography tandem mass spectrometry. Two alkylation agents with different added masses were employed to differentiate the S-nitrosylation sites from the non-Snitrosylation sites. We applied this approach to MDA-MB-231 cells treated with Angeli’s salt, a nitric oxide donor that has been shown to inhibit breast tumor growth and angiogenesis. A total of 162 S-nitrosylation sites were identified and an S-nitrosylation motif was revealed in our study. The 162 sites are significantly more than the number reported by previous methods, demonstrating the efficiency of our approach. Our approach will further facilitate the functional study of protein S-nitrosylation in cellular processes and may reveal new therapeutic targets.

59 BASIC BIOLOGICAL SCIENCES↗