Search NASA⌕ Search

Engineering topics

Fu, Shilu

Publications and source records attributed to Fu, Shilu.

Carbon Capture utilizing Hybrids: Membrane and Liquefaction

Air Liquide is developing a next generation polyimide membrane material (PI-2) for application in our cold membrane hybrid process for CO 2 capture. Combining the PI-2 membrane operation with an integrated CO 2 compression and purification unit significantly reduces the overall cost of CO 2 capture. The current work is aimed at developing the PI-2 material to a commercial scale, then validating its performance under real flue gas conditions. Previous work showed promising results for the cold membrane hybrid process utilizing the commercially available Air Liquide PI-1 membrane bundles. The cold membrane technology was demonstrated at the National Carbon Capture Center (NCCC) with a 0.3 MWe field-test unit incorporating 12” diameter PI-1 commercial bundle. The cost of 90% CO 2 capture from a 550 MWe net coal power plant was estimated to be between 40 and $45/tonne. The novel PI-2 membrane was tested at a smaller scale (1” modules) and exhibited up to 10 times the CO 2 permeance and similar CO 2 /N 2 selectivity as the PI-1 membrane. This corresponds to a potential cost reduction of $3/tonne for CO 2 capture. The current project seeks to develop this next generation PI-2 material to a technology readiness level of 5 via manufacturing scale-up and testing with 600 - 1,000 Nm3/h of real flue gas, 0.2 - 0.3 MWe equivalents. 6” diameter commercial membrane bundles have been fabricated and tested at NCCC. These bundles met the project success criteria with a productivity of over 640 Nm3/hr and permeate purity in excess of 60%, at 90% CO 2 recovery. An advanced bundle formation technique, which further lowers the bundle cost and CO 2 capture cost, is also being developed under the scope of this project. Further manufacturing scale-up is underway to verify the technique. A final techno-economic analysis (TEA) for a 550 MWe net power plant has been initiated.

Hasse, Dave↗

Bench scale Testing of Next Generation Hollow Fiber Membrane Modules at subambient conditions at the National Carbon Capture Center

Air Liquide is developing a hybrid CO2 capture process based on sub-ambient temperature hollow-fiber membrane operation in combination with cryogenic distillation (Ref 1, 2, 3). Prior work has shown extremely attractive membrane performance. The current work seeks to demonstrate performance of the novel membrane fiber, in commercial form, with flue gas from a coal fired power plant.

Hasse, Dave↗

6FDA-DETDA: DABE polyimide-derived carbon molecular sieve hollow fiber membranes: Circumventing unusual aging phenomena

Transport properties are discussed for asymmetric carbon molecular sieve (CMS) hollow fiber membranes based on polyimide precursors derived from a butanol esterified diamino benzoic acid (DABA) based polyimide, 6FDA-DETDA:DABE. Precursor fiber pretreatment with 10% Ethenyl(trimethoxy)silane [vinyltrimethoxysilane (VTMS)] solution in hexane followed by pyrolysis at 550 °C in ultra-high purity argon created asymmetric CMS fibers with CO 2 permeance above 1000 GPU and CO 2 /CH 4 selectivities > 25. Storage of the as-made modules for 72 days in 7 bar CO 2 suppressed undesirable aging typically seen under vacuum or atmospheric pressure air and provided CO 2 permeance and CO 2 /CH 4 selectivity of 780 GPU and 48 respectively. These results are in contrast to significant losses in CO 2 permeance and CO 2 /CH 4 selectivity for CMS created under equivalent pyrolysis conditions from non-esterified 6FDA-DETDA: DABA variant, even under CO 2 storage. The 6FDA-DETDA: DABA-derived CMS results were surprising, since dense film CMS samples from the same precursors did not show the undesirable permeance and selectivity changes. Moreover, other non-DABA containing precursors in dense film and asymmetric fiber forms can be effectively stabilized under CO 2 storage. Such findings suggest that high residual stress in the freshly formed thin selective layers of asymmetric structures in DABA-derived CMS causes undesirable micro-scale rearrangements. In dense films and even asymmetric skins of non-DABA derived CMS membranes, evidence of such undesirable rearrangements are not apparent. DABA-derived cross-links are presumably the cause of these effects. Mono-esterification of 6FDA-DETDA: DABA to form 6FDA-DETDA: DABE controls such crosslinking-derived stresses and resultant instabilities in the CMS fibers, thereby providing stable high performance gas separation properties under CO 2 storage or use in mixed gas feeds.

03 NATURAL GAS↗

CO2 Capture by Cold Membrane Operation

Air Liquide is developing a hybrid CO2 capture process based on sub-ambient temperature hollow-fiber membrane operation in combination with cryogenic distillation (Ref 1, 2, 3). Prior work has shown extremely attractive membrane performance. The current work seeks to demonstrate performance of the novel membrane fiber, in commercial form, with flue gas from a coal fired power plant.

Augustine, Alex↗