Search NASA⌕ Search

Engineering topics

Fultz, B.

Publications and source records attributed to Fultz, B..

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Pressure induced Invar effect in Fe 55 ⁢Ni 45 : An experimental study with nuclear resonant scattering

Pressure-dependent synchrotron x-ray diffraction (XRD), nuclear resonant inelastic x-ray scattering (NRIXS), and nuclear forward scattering (NFS) measurements were made on 57 Fe 55 Ni 45 . XRD measurements were at 298 and 392 K at pressures up to 20 GPa, confirming a pressure-induced Invar effect between 7 and 13 GPa. A decrease of the 57 Fe magnetic moment was found in NFS measurements under pressure, showing an increase in magnetic entropy. The 57 Fe phonon density of states (DOS) was obtained from NRIXS measurements. The low thermal expansion in the high-pressure Invar region originates from a competition between the thermal expansion from spins and phonons as calculated from Maxwell relations. Finally, the longitudinal phonon modes changed their pressure dependence near the Curie transition, which is evidence for a spin-phonon interaction.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2023

Nonharmonic contributions to the high-temperature phonon thermodynamics of Cr

Here, phonon densities of states (DOSs) of body-centered cubic chromium were measured by time-of-flight inelastic neutron scattering at temperatures up to 1493 K. Density functional theory calculations with both quasiharmonic (QH) and anharmonic (AH) methods were performed at temperatures above the Néel temperature. Features in the phonon DOSs decrease in energy (soften) substantially with temperature. A Born–von Kármán analysis using fits to the experimental DOSs reveals a softening of almost 17% of the high-transverse phonon branch between 330 and 1493 K. The low-transverse branch changes by approximately half this amount. The AH calculations capture the observed behavior of the two transverse phonon branches, but the QH calculations give some inverted trends. Vibrational entropies from phonons and electrons are obtained, and their sum is in excellent agreement with the entropy of chromium obtained by calorimetry, indicating that above 330 K, no explicit temperature-dependent magnetic contributions are necessary.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2023

Vibrational dynamics in the undercooled liquid of ultra-fragile metallic glasses

Here, the lattice vibrational dynamics in ultra-fragile Pt 57 Cu 23 P 20 and Pt 60 Cu 20 P 20 glasses were investigated using in situ inelastic neutron scattering to measure the evolution of the phonon density of states (DOS) through the glass transition, into the undercooled liquid phase, and through crystallization. The phonon DOS curves are remarkably similar for the undercooled liquids and the amorphous solids. The vibrational entropy was obtained with these phonon DOS curves, and changes in vibrational entropy caused by the glass transition are less than 0.05 k B /atom. For these highly fragile metal/metalloid glasses, the excess vibrational entropy of the undercooled liquid is about 0.5–1.5 Jmol -1 K -1 , compared to 0.1 Jmol -1 K -1 reported earlier for stronger Cu–Zr glasses. Our work suggests that, consistent with our previous report for less fragile metallic glasses, the fraction of the total excess entropy that is vibrational is small, and the discontinuity in excess entropy at the glass transition is mainly due to configurational entropy.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Thermal expansion and phonon anharmonicity of cuprite studied by inelastic neutron scattering and ab initio calculations

Inelastic neutron scattering measurements were performed with a time-of-flight chopper spectrometer to observe phonons in all parts of the Brillouin zone of a single crystal of cuprite Cu 2 O. We reduced the experimental data to phonon dispersions in the high-symmetry directions, and changes between 10 and 300 K are reported. In this paper, we show ab initio quasiharmonic (QH) and anharmonic (AH) calculations of phonon dispersions. We performed all AH calculations with a temperature-dependent effective potential method. Both QH and AH calculations account for the small negative thermal expansion of cuprite at low temperatures. However, the measured temperature-dependent phonon behavior was predicted more accurately with the AH calculations than the QH ones. Nevertheless, at 300 K, the cubic AH used in this paper did not entirely account for the experimental phonon dispersions in cuprite.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2020

Temperature-dependent phonon lifetimes and thermal conductivity of silicon by inelastic neutron scattering and ab initio calculations

In this paper, inelastic neutron scattering on a single crystal of silicon was performed at temperatures from 100 to 1500 K. These experimental data were reduced to obtain phonon spectral intensity at all wave vectors $\overset{→}{Q}$ and frequencies ω in the first Brillouin zone. Thermal broadenings of the phonon peaks were obtained by fitting and by calculating with an iterative ab initio method that uses thermal atom displacements on an ensemble of superlattices. Agreement between the calculated and experimental broadenings was good, with possible discrepancies at the highest temperatures. Distributions of phonon widths versus phonon energy had similar shapes for computation and experiment. These distributions grew with temperature but maintained similar shapes. Parameters from the ab initio calculations were used to obtain the thermal conductivity from the Boltzmann transport equation, which was in good agreement with experimental data. Despite the high group velocities of longitudinal acoustic phonons, their shorter lifetimes reduced their contribution to the thermal conductivity, which was dominated by transverse acoustic modes.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2020

Temperature dependence of electron-phonon interactions in vanadium

First-principles calculations were used to study the Fermi surface of body-centered cubic vanadium at elevated temperatures. Supercell calculations accounted for effects of thermal atom displacements on band energies, and band unfolding was used to project the spectral weight of the electron states into the Brillouin zone of a standard bcc unit cell. An electronic topological transition (ETT, or Lifshitz transition) occurred near the Γ point with increasing temperature, but the large thermal smearings from the atomic disorder and the Fermi-Dirac distribution reduced the effect of this ETT on the electron-phonon interactions. The phonon dispersions showed thermal stiffening of their Kohn anomalies near the Γ point and of the longitudinal N phonon mode. Finally, in general the effects of the ETT were overcome by the thermal smearing of the Fermi surface that reduces the spanning vector densities for anomalous phonon modes.

36 MATERIALS SCIENCE↗
NASA NTRS2002

Magnetomechanical damping in cryogenic TbDy

Vibration damping in polycrystalline TbDy alloys was studied at cryogenic temperatures. The material was prepared by cold-rolling to induce crystallographic texture, and was then heat-treated to relieve internal stress. Mechanical hysteretic losses were measured at various strains, frequencies, and loading configurations at 77 K. Some textured TbDy materials demonstrated 22.6% energy dissipation in mechanical measurements at low frequency (0.01 Hz) and a mean logarithmic decrement of 0.23 at a higher frequency (25 kHz). Ultrasonic velocities of longitudinal and shear elastic waves were measured on single and polycrystalline TbDy; little variation in ultrasonic velocities was found evenfor samples with large variation in crystallographic texture and magnetomechanical properties.

magnetomechanical TbDy↗
NASA NTRS1998

Hydrogen Desorption and Adsorption Measurements on Graphite Nanofibers

Graphite nanofibers were synthesized and their hydrogen desorption and adsorption properties are reported for 77 and 300 K. Catalysts were made by several different methods including chemical routes, mechanical alloying and gas condensation.

graphite nanofibers hydrogen desorption adsorption↗
NASA NTRS1998

Cryogenic Magnetostrictive Actuators: Materials and Applications

Magnetostrictive actuators based on TbDy alloys show promise for use as actuators on cryogenic devices. They can be made to deliver large forces and useful displacements below liquid nitrogen temperatures, with many advantages over piezoelectric actuators or motion feedthroughs from higher temperature actuators.

Magnetostrictive↗