Engineering topics
Gaier, Todd
Publications and source records attributed to Gaier, Todd.
New Observing Capabilities Enabled by Small Satellite Passive Microwave Radiometers
UNKNOWN
Toward Resolving the Temporal Evolution of Precipitation Processes over the Ocean: On-Orbit Evaluation of the TEMPEST-D Microwave Radiometer
UNKNOWN
A Status of U-Class Earth Science Instruments at JPL
With advancements in CubeSat technologies and low-cost launch opportunities, CubeSats could play a role in meeting NASA’s key Earth science measurement objectives, especially in extreme weather and ecosystem processes. In this paper, we discuss the development of “science grade” hyperspectral imager, microwave spectrometer, IR sounder, and Ka-band radar instruments at JPL. They are scheduled to launch in early to late 2018 while the hyperspectral imager is being developed for airborne flights and for space in the future. The limitations in power, mass, and volume imposed by the CubeSat platform required the identification of new technologies in order to miniaturize instruments into a specific form factor. In conclusion, we will summarize strategies to implement small and low-cost instruments and suggest an architecture for enabling a constellation of U-class instruments.
Cryogenic Low Noise MMIC Amplifiers for U-Band (40-60 GHz)
In this work, we describe monolithic millimeter-wave integrated circuit (MMIC) Low Noise Amplifier (LNA) and mixer designs for U-Band, also known as the WR19 waveguide band (40-60 GHz). The LNAs were fabricated in NGC’s 35 nm InP HEMT MMIC process. The MMICs were packaged in WR19 waveguide housings and tested for noise, both at room temperature and cryogenically. We present the results, including a comparison to the state-of-the-art, and discuss applications for amplifiers in this frequency range. To date, these are the first cryogenic 35 nm InP MMIC results covering the 40-60 GHz range. We achieved a noise temperature less than 30 K over the 40-60 GHz range, when the amplifiers were cryogenically cooled. These results are comparable with other results in the literature, and we believe are the lowest reported for MMICs in the 50-60 GHz range.
A Physicist's Adventures from Medford to NASA by Way of the South Pole
No abstract available
The Correlation Radiometer - A New Application in MM-Wave Total Power Radiometry
We describe the design and performance of a 180 GHz correlation radiometer suitable for remote sensing. The radiometer provides continuous comparisons between a the observed signal and a reference load to provide stable radiometric baselines. The radiometer was assembled and tested using parts from the GeoSTAR-II instrument and is fully compatible with operation in a synthetic aperture radiometer or as a standalone technology for use in microwave sounding and imaging. This new radiometer was tested over several days easily demonstrating the required 6 hour stability requirement for observations of mean brightness temperature for a geostationary instrument.
A 75-116-Ghz LNA with 23-K Noise Temperature at 108 Ghz
In this paper we present the design and measurement results, both on-wafer and in package, of an ultra-low-noise and wideband monolithic microwave integrated circuit (MMIC) amplifier in the frequency range of 75 to 116 GHz. The three-stage amplifier packaged in a WR10 waveguide housing and fabricated using a 35-nm InP HEMT technology achieves a record noise temperature of 23 K at 108 GHz when cryogenically cooled to 27 K. The measured gain is 22 to 27 dB for frequency range of 75 to 116 GHz. Furthermore, the amplifier utilizes four finger devices with total gate width of 60 um resulting for improved linearity.
Initial Results from the GeoSTAR-II Laboratory Demonstration
The Geostationary Synthetic Thinned Aperture Radiometer (GeoSTAR) team recently concluded its second Earth Science Technology Office (ESTO) IIP-07, "GeoSTAR technology development and risk reduction for PATH". The major accomplishments during this project at JPL were:1) Demonstrate performance and scalability of the 183 GHz receivers 2) Local oscillator phasing architecture and technology 3) Subarray design validation including feedhorns, manifolds and alignment 4) System demonstration of signal distribution topology and measurements. Significant progress has been made to retiring risk of the various subsystems.
Low Noise Amplifier Receivers from Millimeter Wave Atmospheric Remote Sensing
We currently achieve 3.4 dB noise figure at 183GHz and 2.1 dB noise figure at 90 GHz with our MMIC low noise amplifiers (LNAs) in room temperature. These amplifiers and the receivers we have built using them made it possible to conduct highly accurate airborne measurement campaigns from the Global Hawk unmanned aerial vehicle, develop millimeter wave internally calibrated radiometers for altimeter radar path delay correction, and build prototypes of large arrays of millimeter receivers for a geostationary interferometric sounder. We use the developed millimeter wave receivers to measure temperature and humidity profiles in the atmosphere and in hurricanes as well as to characterize the path delay error in ocean topography altimetry.
Recent Developments of the Geostationary Synthetic Thinned Array Radiometer (GEOSTAR)
GeoSTAR is an instrument concept to provide high resolution microwave images of the earth from GEO.
Low Noise Amplifiers and Receivers for Remote Sensing
The study of atmospheric dynamics and climatology depend on accurate and frequent measurements of temperature and humidity profiles of the atmosphere. These measurements furthermore enable highly accurate measurements of ocean topography by providing total column water vapour data for radar path delay correction. The atmospheric temperature profile is characterized at the oxygen molecule absorption frequencies (60 and 118 GHz) and the humidity profile at the water molecule absorption frequencies (23 and 183 GHz). Total column measurements can be achieved by comparing measured radiometric temperatures at atmospheric window channels, such as 90, 130, and 166 GHz. The standard receiver technology for these frequencies was diode mixers with MMIC LNAs being applied at the lower frequencies. The sensitivity of millimeter wave receivers improved significantly with the introduction of the low noise 35 nm gate length InP MMIC amplifiers. We currently achieve 3 dB noise figure at 180 GHz and 2 dB noise figure at 90 GHz with our MMIC low noise amplifiers (LNAs) in room temperature. These amplifiers and the receivers we have built using them made it possible to conduct highly accurate airborne measurements campaigns from the Global Hawk unmanned aerial vehicle, develop millimeter wave internally calibrated radiometers for altimeter radar path delay correction, and build prototypes of large arrays of millimeter receivers for a geostationary interferometric sounder. We use the developed millimeter wave receivers to measure temperature and humidity profiles in the atmosphere and in hurricanes as well as to characterize the path delay error in ocean topography alitmetery.