Demonstration of enhanced quantum efficiency from optical interference in alkali antimonide photocathodes
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Galdi, A..
Explore the source record for details and available documents.
Ultrafast-optical-pump — structural-probe measurements, including ultrafast electron and x-ray scattering, provide direct experimental access to the fundamental timescales of atomic motion, and are thus foundational techniques for studying matter out of equilibrium. High-performance detectors are needed in scattering experiments to obtain maximum scientific value from every probe particle. Here we deploy a hybrid pixel array direct electron detector to perform ultrafast electron diffraction experiments on a WSe 2 /MoSe 2 2D heterobilayer, resolving the weak features of diffuse scattering and moiré superlattice structure without saturating the zero order peak. Enabled by the detector’s high frame rate, we show that a chopping technique provides diffraction difference images with signal-to-noise at the shot noise limit. Finally, we demonstrate that a fast detector frame rate coupled with a high repetition rate probe can provide continuous time resolution from femtoseconds to seconds, enabling us to perform a scanning ultrafast electron diffraction experiment that maps thermal transport in WSe 2 /MoSe 2 and resolves distinct diffusion mechanisms in space and time.
We report on the progress towards an all epitaxial oxide layer technology on silicon substrates for epitaxial piezoelectric microelectromechanical systems. (101)-oriented epitaxial tetragonal BaTiO{sub 3} (BTO) thin films were deposited at two different oxygen pressures, 5.10{sup −2} mbar and 5.10{sup −3} mbar, on SrRuO{sub 3}/Yttria-stabilized zirconia (YSZ) buffered silicon substrates by pulsed laser deposition. The YSZ layer full (001) orientation allowed the further growth of a fully (110)-oriented conductive SrRuO{sub 3} electrode as shown by X-ray diffraction. The tetragonal structure of the BTO films, which is a prerequisite for the piezoelectric effect, was identified by Raman spectroscopy. In the BTO film deposited at 5.10{sup −2} mbar strain was mostly localized inside the BTO grains whereas at 5.10{sup −3} mbar, it was localized at the grain boundaries. The BTO/SRO/YSZ layers were finally deposited on Si microcantilevers at an O{sub 2} pressure of 5.10{sup −3} mbar. The strain level was low enough to evaluate the BTO Young modulus. Transmission electron microscopy (TEM) was used to investigate the epitaxial quality of the layers and their epitaxial relationship on plain silicon wafers as well as on released microcantilevers, thanks to Focused-Ion-Beam TEM lamella preparation.
Superconducting Sr{sub 1-x}La{sub x}CuO{sub 2} thin films have been grown on GdScO{sub 3} substrates by reflection high-energy electron diffraction calibrated layer-by-layer molecular-beam epitaxy. X-ray diffraction analysis has confirmed the infinite layer structure after an in situ vacuum annealing step. In situ photoemission spectroscopy indicates that the vacuum annealing step employed immediately after film growth to achieve superconducting films results in oxygen loss from the films. The superconducting critical temperature depends on the La content x, with the highest value obtained for x{approx}0.10. Resistivity as a function of temperature {rho}(T) curves of optimally doped samples show a T{sup 2} temperature dependence characteristic of a scattering process where electron-electron interactions dominate.