Search NASA⌕ Search

Engineering topics

Gall, P. D.

Publications and source records attributed to Gall, P. D..

Liquid crystals for high-altitude in-flight boundary layer flow visualization

A novel method for visualization of laminar to turbulent boundary layer transition in flight is presented, in which liquid crystal coatings are used to indicate the transition by a change of color (in response to the changes in the wall shear and the temperature). The liquid crystals applied to the wing surfaces were either cholesteric crystals formulated to be active between temperatures of 30 and 100 F or a sample of chiral nematic liquid crystals formulated to be active between -18 and -22 F. Liquid crystal coatings were shown to provide visualization data at flight altitudes and temperatures at which data could not be obtained previously. Flight evaluations were successfully conducted on a T-34C and a Learjet research aircraft at Mach numbers of up to 0.8 and altitudes of up to 50,000 ft. The time response during oscillating sideslip tests was very rapid. In wind tunnel tests, a hysteresislike behavior was observed in the liquid crystal coatings, possibly because of the lower dynamic pressures in wind tunnels as compared to flight.

Gall, P. D.↗

Study of an efficient long-range Mach 2.7 supersonic transport configuration concept

A long range Mach 2.7 supersonic transport configuration concept was studied utilizing linear theory methods. The configuration was sized to carry 290 passengers 6,000 nautical miles nonstop. The final configuration has a maximum takeoff gross weight of 687,200 pounds, a wing loading of 69.8 lbf/sq.ft. and a thrust weight ratio of .278. The most significant result is that a significantly improved trimmed maximum lift drag ratio of 11.04 can be obtained for a supersonic transport at Mach 2.62 and 55,000 feet.

Gall, P. D.↗

Study of winglets applied to biplanes

The possibility of improving the aerodynamic characteristics of a biplane configuration by adding winglets is examined both theoretically and experimentally. Theoretical calculations show good agreement with experiment in predicting inviscid drag due to lift. Theoretical and experimental results indicate that the addition of winglets to an optimized biplane configuration can increase the ideal efficiency factor by up to 13 percent, as well as increasing the lift curve slope and maximum lift coefficient.

Gall, P. D.↗

Study of winglets applied to biplanes

This paper examines, both theoretically and experimentally, the possibility of improving the aerodynamic characteristics of a biplane configuration by adding winglets. Theoretical calculations show good agreement with experiment in predicting inviscid drag due to lift. Theoretical and experimental results indicate that the addition of winglets to an optimized biplane configuration can increase the ideal efficiency factor by up to 13 percent, as well as increasing the lift-curve slope and maximum lift coefficient. A theoretical analysis comparing the biplane with an optimized winglet to an equivalent monoplane indicates that the biplane has the potential for a 6.4-percent increase in L/D(max), and 13-percent increase in C(L) to the 3/2-power/C(D), the classical endurance parameter.

Gall, P. D.↗

An experimental and theoretical analysis of the aerodynamic characteristics of a biplane-winglet configuration

Improving the aerodynamic characteristics of an airplane with respect to maximizing lift and minimizing induced and parasite drag are of primary importance in designing lighter, faster, and more efficient aircraft. Previous research has shown that a properly designed biplane wing system can perform superiorly to an equivalent monoplane system with regard to maximizing the lift-to-drag ratio and efficiency factor. Biplanes offer several potential advantages over equivalent monoplanes, such as a 60-percent reduction in weight, greater structural integrity, and increased roll response. The purpose of this research is to examine, both theoretically and experimentally, the possibility of further improving the aerodynamic characteristics of the biplanes configuration by adding winglets. Theoretical predictions were carried out utilizing vortex-lattice theory, which is a numerical method based on potential flow theory. Experimental data were obtained by testing a model in the Pennsylvania State University's subsonic wind tunnel at a Reynolds number of 510,000. The results showed that the addition of winglets improved the performance of the biplane with respect to increasing the lift-curve slope, increasing the maximum lift coefficient, increasing the efficiency factor, and decreasing the induced drag. A listing of the program is included in the Appendix.

Gall, P. D.↗