Search NASA⌕ Search

Engineering topics

Galvin, Janine E.

Publications and source records attributed to Galvin, Janine E..

Multiphase flow studies for microscale hydrodynamics in the structured packed column

Post combustion carbon capture by solvent absorption in a structured packed column is a promising technology for mitigating greenhouse gas emissions. Computational fluid dynamic (CFD) modelling of such a column is a challenging multiscale problem due to the range in length and time scales. The microscale hydrodynamics play a key role in the overall column efficiency with the interfacial area significantly influencing the mass transfer between the gas and liquid phases. In this context, multiphase flow simulations using the volume of fluid (VOF) method in a representative elementary unit (REU) of the packed column can provide fundamental insights into the microscale hydrodynamics, such as, interfacial area and liquid holdup. The present paper systematically examines the impact of various factors (e.g., physical properties and contact angle) on the interfacial area. The results are compared with existing correlations and a scaling analysis is also performed. The solvent physical properties are characterized by the Kapitza number (Ka), a dimensionless number that depends only on fluid properties. So that the Ka number decreases with increasing viscosity. At a fixed liquid load, the interfacial area and liquid holdup are observed to increase with decreasing Ka number. The impact of contact angle (i.e., solid surface characteristics) is effectively investigated by modifying the wall boundary conditions. The interfacial area and liquid holdup are found to decrease with increasing contact angle. Subsequently, a phenomenological correlation for interfacial area is proposed that includes the impact of these parameters. Finally, this correlation may be used to predict the interfacial area for gas-liquid flow in a structured packing for rivulet to fully wetted flow regimes.

42 ENGINEERING↗

Modeling and simulation of CO 2 capture using semipermeable elastic microcapsules

Very high rates of CO2 absorption have been demonstrated using semipermeable microcapsules filled with environmentally benign sodium carbonate solutions (Vericella et al., Nature communications 6, 2015). However, such capsules have also exhibited several traits, including water loss/uptake, elastic swelling and buckling, and precipitation of solids, which make them more complicated to engineer as a carbon capture material. To address this, a mechanistic model for mass transfer and chemical reaction has been developed, which accounts for these behaviors, and can be used as a predictive tool to explore capsule performance under different CO2 capture scenarios. The model uses a modified film theory to describe CO2 and H2O mass transfer rates, a concentration based description of vapor-liquid-solid equilibrium inside the capsule, and an elastic description of the capsule shell. Model predictions compare favorably to literature data for precipitating carbonates, as well as recent data for microcapsule CO2 absorption. The model was used to assess practical issues of capsule water transfer during a temperature swing CO2 absorption/desorption cycle. Model predictions indicate that capsules filled with high weight percent, precipitating sodium carbonate solution could be significantly or completely dehydrated during CO2 absorption. Subsequent rehydration of lean capsules at elevated temperature showed strong sensitivity to both gas humidity, and capsule shell elasticity.

97 MATHEMATICS AND COMPUTING↗

Breakup of a liquid rivulet falling over an inclined plate: Identification of a critical Weber number

Here, we have numerically investigated the breakup of a rivulet falling over a smooth inclined plate using the volume of fluid method. The breakup the rivulet is a complex phenomenon that is dictated by many factors, such as solvent properties, contact angle, inertia, plate inclination, etc. An extensive simulation campaign was conducted wherein these factors were systematically investigated. Regimes for a stable rivulet and an unstable rivulet that leads to the breakup and formation of a droplet are examined in terms of a critical value of the Weber number (We cr ) that delineates these regimes. The effect of plate inclination on the breakup of the rivulet shows that the critical Weber number decreases with increased inclination angle (θ) owing to higher liquid velocity. However, the effect is negligible beyond θ > 60°. The impact of solvent properties is characterized using the Kapitza number (Ka). Variation of We cr with Ka shows two trends depending on the Ka value of the solvent. Solvents with lower Ka values, corresponding to high viscosities and/or low surface tensions, show smaller values of the critical Weber number and the variation is linear. While solvents with higher Ka values exhibit higher values of the We cr and the variation in We cr is steep. This behavior is more pronounced with increasing contact angle. Higher contact angles promote rivulet breakup so that inertia must be higher to the breakup. As a result, a phenomenological scaling for a critical Weber number with the Kapitza number and contact angle is presented that can offer insight into rivulet breakup.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Kinetic-theory predictions of clustering instabilities in granular flows: beyond the small-Knudsen-number regime

In this work we quantitatively assess, via instabilities, a Navier–Stokes-order (small- Knudsen-number) continuum model based on the kinetic theory analogy and applied to inelastic spheres in a homogeneous cooling system. Dissipative collisions are known to give rise to instabilities, namely velocity vortices and particle clusters, for sufficiently large domains. We compare predictions for the critical length scales required for particle clustering obtained from transient simulations using the continuum model with molecular dynamics (MD) simulations. The agreement between continuum simulations and MD simulations is excellent, particularly given the presence of well-developed velocity vortices at the onset of clustering. More specifically, spatial mapping of the local velocity-field Knudsen numbers (Knu) at the time of cluster detection reveals Knu » 1 due to the presence of large velocity gradients associated with vortices. Although kinetic-theory-based continuum models are based on a small- Kn (i.e. small-gradient) assumption, our findings suggest that, similar to molecular gases, Navier–Stokes-order (small-Kn) theories are surprisingly accurate outside their expected range of validity.

42 ENGINEERING↗