Search NASASearch

Engineering topics

Gardner, C. S.

Publications and source records attributed to Gardner, C. S..

At least 37 records · Page 2

Multicolor laser altimeter for barometric measurements over the ocean - Theoretical

It is noted that the optical path length from a satellite to the earth's surface strongly depends on the atmospheric pressure along the propagation path. The theoretical basis of a surface pressure measurement technique, which uses a two-color laser altimeter to observe the change with wavelength in the optical path length from a satellite to the ocean surface, is evaluated. The statistical characteristics of the ocean-reflected pulses and the expected measurement accuracy are analyzed in terms of the altitude parameters. The results show that it is feasible to obtain a pressure accuracy of a few millibars.

Gardner, C. S.

Analysis of short pulse laser altimetry data obtained over horizontal path

Recent pulsed measurements of atmospheric delay obtained by ranging to the more realistic targets including a simulated ocean target and an extended plate target are discussed. These measurements are used to estimate the expected timing accuracy of a correlation receiver system. The experimental work was conducted using a pulsed two color laser altimeter.

Im, K. E.

Remote sensing of atmospheric pressure and sea state from satellites using short-pulse multicolor laser altimeters

Short pulse multicolor laser ranging systems are currently being developed for satellite ranging applications. These systems use Q-switched pulsed lasers and streak tube cameras to provide timing accuracies approaching a few picoseconds. Satellite laser ranging systems was used to evaluate many important geophysical phenomena such as fault motion, polar motion and solid earth tides, by measuring the orbital perturbations of retroreflector equipped satellites. Some existing operational systems provide range resolution approaching a few millimeters. There is currently considerable interest in adapting these highly accurate systems for use as airborne and satellite based altimeters. Potential applications include the measurement of sea state, ground topography and atmospheric pressure. This paper reviews recent progress in the development of multicolor laser altimeters for use in monitoring sea state and atmospheric pressure.

Gardner, C. S.

High-resolution lidar system for measuring the spatial and temporal structure of the mesospheric sodium layer

The design of a high-resolution tunable-dye laser-based lidar system for the study of the mesospheric sodium layer is presented and results of sodium measurements are indicated. The lidar system comprises a tunable flashlamp-pumped dye laser operating at the sodium D2 resonance line at 589.0 nm with a pulse width of 2 microsec FWHM and pulse frequency of 10 Hz and a telescope with a 1.22=m diameter Fresnel lens. Sodium profiles are obtained from the integration of 100 to 250 laser shots, with spatial and temporal resolution enhanced by two-dimensional filtering techniques. Measurements obtained over a 9-hour nighttime period illustrate the highly dynamic nature of the sodium layer, which was observed with a spatial resolution of 2 km and temporal resolution of 30 min. Observations made with a steerable apparatus have confirmed a presunrise enhancement of over 100 percent in sodium column abundance.

Gardner, C. S.

Atmospheric refraction effects on baseline error in satellite laser ranging systems

Because of the mathematical complexities involved in exact analyses of baseline errors, it is not easy to isolate atmospheric refraction effects; however, by making certain simplifying assumptions about the ranging system geometry, relatively simple expressions can be derived which relate the baseline errors directly to the refraction errors. The results indicate that even in the absence of other errors, the baseline error for intercontinental baselines can be more than an order of magnitude larger than the refraction error.

Im, K. E.

Remote sensing of sea state by laser altimeters

The reflection of short laser pulses from the ocean surface was analyzed based on the specular point theory of scattering. The expressions for the averaged received signal, shot noise and speckle induced noise were derived for a direct detection system. It is found that the reflected laser pulses have an average shape closely related to the probability density function associated with the surface profile. This result is applied to estimate the mean sea level and significant wave height from the receiver output of the laser altimeter.

Tsai, B.

Theoretical and lidar studies of the density response of the mesospheric sodium layer to gravity wave perturbations

The density response of atmospheric layers to gravity waves is developed in two forms, an exact solution and a perturbation series solution. The degree of nonlinearity in the layer density response is described by the series solution whereas the exact solution gives insight into the nature of the responses. Density perturbation in an atmospheric layer are shown to be substantially greater than the atmospheric density perturbation associated with the propagation of a gravity wave. Because of the density gradients present in atmospheric layers, interesting effects were observed such as a phase reversal in the linear layer response which occurs near the layer peak. Once the layer response is understood, the sodium layer can be used as a tracer of atmospheric wave motions. A two dimensional digital signal processing technique was developed. Both spatial and temporal filtering are utilized to enhance the resolution by decreasing shot noise by more han 10 dB. Many of the features associated with a layer density response to gravity waves were observed in high resolution density profiles of the mesospheric sodium layer. These include nonlinearities as well as the phase reversal in the linear layer response.

Shelton, J. D.

Spatial and temporal filtering technique for processing lidar photocount data

Shot noise places a practical limit on the spatial and temporal resolution of lidar photocount data. A 2-D signal-processing technique that utilizes spatial and temporal filtering to reduce shot noise and increase resolution is described. The technique is applied to sodium lidar data collected during the fall of 1979 over Urbana, Illinois. Temporal filtering is shown to enhance the spatial resolution of the sodium profiles significantly by reducing shot noise by more than 10 dB. The signal-processing technique is applicable to a wide variety of lidar data.

Gardner, C. S.

Lidar observation of the mesospheric sodium layer over Urbana, Illinois

Atmospheric sodium has been observed over Urbana (40 deg 10 min N, 88 deg 10 min W) using a monostatic lidar tuned to 589.0 nm. The photocount data are processed using ditital smoothing filters to obtain continuous estimates of the sodium density versus altitude. The filter cutoff frequency is related to the height resolution and accuracy of the estimated profile. Wavelike structures in the sodium layer have been observed with typical wavelengths of 3-15 km and phase velocities of 1-3 m/s. The layer is characterized by a sharp falloff on the bottomside and often an undulatory motion of the bottomside of the layer accompanies the wave motion. The topside gradient of the layer is frequently observed to decrease through the night.

Richter, E. S.

Density response of the mesospheric sodium layer to gravity wave perturbations

Lidar observations of the mesospheric sodium layer often reveal wavelike features moving through the layer. It is often assumed that these features are a layer density response to gravity waves. Chiu and Ching (1978) described the approximate form of the linear response of atmospheric layers to gravity waves. In this paper, their results are used to predict the response of the sodium layer to gravity waves. These simulations are compared with experimental observations and a good correlation is found between the two. Because of the thickness of the sodium layer and the density gradients found in it, a linear model of the layer response is not always adequate to describe gravity wave-sodium layer interactions. Inclusion of nonlinearities in the layer response is briefly discussed. Experimental data is seen to contain features consistent with the predicted nonlinearities.

Shelton, J. D.

Technique for remotely measuring surface pressure from a satellite using a multicolor laser ranging system

The optical path length from a satellite to the earth's surface is strongly dependent on the atmospheric pressure along the propagation path. It is shown that surface pressures can be measured by the use of a multicolor laser ranging system to observe the change with wavelength in the optical path length from the satellite to a ground target. Equations are derived which relate surface pressure to the differential path lengths. In addition, the accuracy of the pressure measurement is evaluated in terms of the ranging system parameters. It is concluded that the results indicate that pressure accuracies of a few millibars appear feasible.

Gardner, C. S.

Operating manual for the RRL 8 channel data logger

A data collection device which takes measurements from external sensors at user specified time intervals is described. Three sensor ports are dedicated to temperature, air pressure, and dew point. Five general purpose sensor ports are provided. The user specifies when the measurements are recorded as well as when the information is read or stored in a minicomputer or a paper tape.

Paluch, E. J.

A technique for remotely measuring surface pressure from a satellite using a multicolor laser ranging system

The optical path length from a satellite to the earth's surface is strongly dependent on the atmospheric pressure along the propagation path. Surface pressure can be measured by using a multicolor laser ranging system to observe the change with wavelength in the optical path length from the satellite to a ground target. The equations which relate surface pressure to the differential path lengths are derived and the accuracy of the pressure measurement is evaluated in terms of the ranging system parameters. The results indicate that pressure accuracies of a few millibars appear feasible.

Gardner, C. S.

Ray tracing evaluation of a technique for correcting the refraction errors in satellite tracking data

Errors may be introduced in satellite laser ranging data by atmospheric refractivity. Ray tracing data have indicated that horizontal refractivity gradients may introduce nearly 3-cm rms error when satellites are near 10-degree elevation. A correction formula to compensate for the horizontal gradients has been developed. Its accuracy is evaluated by comparing it to refractivity profiles. It is found that if both spherical and gradient correction formulas are employed in conjunction with meteorological measurements, a range resolution of one cm or less is feasible for satellite elevation angles above 10 degrees.

Gardner, C. S.

Lidar observations of wave-like structure in the atmospheric sodium layer

The University of Illinois (Urbana) lidar system has been developed to study the atmospheric sodium layer near 90 km altitude through the mechanism of resonance scattering. The photocount data are processed using digital smoothing filters to obtain continuous estimates of the sodium density versus altitude. The filter cutoff frequency is related to the height resolution and accuracy of the estimated profile. Lidar photocount data processed using this filtering technique show wave-like structures in the sodium layer which move downward with time. The waves have typical wavelengths of 3-15 km and phase velocities of less than 1 m/sec. The movement of these structures seems to be independent of the motion of the bottomside of the layer, which also has been observed to move up or down by as much as 2 km over a period of a few hours.

Rowlett, J. R.