Engineering topics

Gartrell, L. R.

Publications and source records attributed to Gartrell, L. R..

10 records

NASA NTRS1987

Designing transonic wind-tunnel test sections for flow diagnostics and laser velocimeter applications

The design, fabrication, and validation of the Basic Aerodynamic Facility (BARF), developed for the direct comparison of three-dimensional laser velocimetry (LV) and hot-wire techniques at transonic speeds, are discussed. To accommodate the installation of the three-dimensional orthogonal LV system in the BARF, the transonic slots were redesigned to house windows, and the test section mounting was redesigned to facilitate LV transversing. Two-dimensional and three-dimensional code validation tests of the LV test section showed uniform mean flow through the test section to sonic speeds, and fluctuating pressure measurements at subsonic speeds which are consistent with facilities with good flow quality.

Jones, G. S.↗

NASA NTRS1983

Application of laser anemometry to cryogenic wind tunnels

The installation and tests conducted with the laser Doppler and transit anemometer in the 0.3-Meter Transonic Cryogenic Tunnel are described. Using residual particulates in the flow field, a series of free stream velocity measurements were conducted which agreed to within 1-percent of predicted values for a range of Mach numbers, 0.2 to 0.85, and temperatures, 100 to 250 K. Measurements about a shock wave provided an estimate of scattering particulate size of 4 microns or less. The particle concentration is approximately 3 x 10 to the 5th to 1.6 x 10 to the 6th/cu m. Necessary isolation of the plenum wall windows from ambient air with slightly positive pressure of dry nitrogen gas to prevent condensation on the window surface was achieved. This was accomplished through the use of large enclosures fixed to the tunnel wall. A second method used an additional sheet of thin plate glass to create the dry gas pocket next to the plenum window. The installation of a laser anemometer in the National Transonic Facility is examined. The laser transit anemometer has been tentatively selected for the initial entry because of its compact laser-optics package.

Hunter, W. W., Jr.↗

NASA NTRS1982

Laser Doppler velocimetry application in the Langley 0.3-meter Transonic Cryogenic Tunnel

The problems and the potential use of a nonintrusive flow velocity measuring technique in the Langley 0.3 meter transonic cryogenic tunnel (TCT) were investigated. A laser velocimeter (LV) was used. It was concluded that free-stream velocity measurements can be successfully made in the Langley 0.3-m TCT using a low-power (15-mW) LV system. The measured and calculated mean velocities typically agreed within one percent. The overall normalized standard deviation was less than one percent. Tunnel vibration and temperature had no detrimental effects on the optical system. It is recommended that the LV work should be further investigated for future use in the Langley 0.3-m TCT.

Gartrell, L. R.↗

NASA NTRS1982

Some NTF laser velocimeter installation and operation considerations

Two velocimeter techniques were considered as potential candidates for achieving the flow field angularity measurements. The first was the fringe laser Doppler velocimeter, (LDV). A great deal of experience was obtained with this approach at Langley and the literature is rich with papers describing many experimental applications and system performance details. That is, many velocity flow field measurements were conducted with the LDV but not with high resolution precise angularity measurements. The second candidate considered was the two-spot laser transit anemometer, (LTA). This approach was not as extensively used as the LDV technique, but literature does contain experimental applications and system performance details. Again, a lack of high resolution, high precision angularity measurements is noted for the LTA. The results of the study suggested that the LDV and LTA tests and other efforts did not reveal any fundamental problems that would suggest that laser velocimetry is not a viable diagnostic technique for the National Transonic Facility. However, there are a number of engineering problems that need to be solved.

Hunter, W. W., Jr.↗

NASA NTRS1981

Laser velocimetry technique applied to the Langley 0.3 meter transonic cryogenic tunnel

A low power laser velocimeter operating in the forward scatter mode was used to measure free stream mean velocities in the Langley 0.3 Meter Transonic Cryogenic Tunnel. Velocity ranging from 51 to 235 m/s was measured. Measurements were obtained for a variety of nominal tunnel conditions: Mach numbers from 0.20 to 0.77, total temperatures from 100 to 250 K, and pressures from 101 to 152 kPa. Particles were not injected to augment the existing Mie scattering materials. Liquid nitrogen droplets were the existing liqht scattering material. Tunnel vibrations and thermal effects had no detrimental effects on the optical system.

Gartrell, L. R.↗

NASA NTRS1981

Noise suppression in forward-scattering optical instruments

Apertures and stops located at conjugate points in receiver optics reduce noise caused by scattered light. They are placed as real, inverse images of each other, so only light from sample volume reaches detector. Noise suppression technique increases signal to noise ratio on order of 15 dB.

Franke, J. M.↗

NASA NTRS1980

A Scanning laser-velocimeter technique for measuring two-dimensional wake-vortex velocity distributions

A rapid scanning two dimensional laser velocimeter (LV) has been used to measure simultaneously the vortex vertical and axial velocity distributions in the Langley Vortex Research Facility. This system utilized a two dimensional Bragg cell for removing flow direction ambiguity by translating the optical frequency for each velocity component, which was separated by band-pass filters. A rotational scan mechanism provided an incremental rapid scan to compensate for the large displacement of the vortex with time. The data were processed with a digital counter and an on-line minicomputer. Vaporized kerosene (0.5 micron to 5 micron particle sizes) was used for flow visualization and LV scattering centers. The overall measured mean-velocity uncertainity is less than 2 percent. These measurements were obtained from ensemble averaging of individual realizations.

Gartrell, L. R.↗

NASA NTRS1978

Laser velocimeter application to oscillatory liquid flows

A laser velocimeter technique was used to measure the mean velocity and the frequency characteristics of an oscillatory flow component generated with a rotating flapper in liquid flow system at Reynolds numbers approximating 93,000. The velocity information was processed in the frequency domain using a tracker whose output was used to determine the flow spectrum. This was accomplished with the use of an autocorrelator/Fourier transform analyzer and a spectrum averaging analyzer where induced flow oscillations up to 40 Hz were detected. Tests were conducted at a mean flow velocity of approximately 2 m/s. The experimental results show that the laser velocimeter can provide quantitative information such as liquid flow velocity and frequency spectrum with a possible application to cryogenic fluid flows.

Gartrell, L. R.↗

NASA NTRS1977

Demonstration of rapid-scan two-dimensional laser velocimetry in the Langley Vortex Research Facility for research in aerial applications

Tests were conducted to demonstrate a rapid scan two dimensional laser velocimeter (LV) measurement technique for aerial applications research. The LV system is capable of simultaneously measuring both vertical and axial flow velocity components in a near or far field vortex system. Velocity profiles were successfully measured in the wake vortex of a representative agricultural aircraft model, with the vortex system rapidly transporting in ground effect. Results indicate that the laser velocimetry technique can provide quantitative information of wake vortex characteristics in ground effect.

Gartrell, L. R.↗

NASA NTRS1973

A technique for measuring hypersonic flow velocity profiles

A technique for measuring hypersonic flow velocity profiles is described. This technique utilizes an arc-discharge-electron-beam system to produce a luminous disturbance in the flow. The time of flight of this disturbance was measured. Experimental tests were conducted in the Langley pilot model expansion tube. The measured velocities were of the order of 6000 m/sec over a free-stream density range from 0.000196 to 0.00186 kg/cu m. The fractional error in the velocity measurements was less than 5 percent. Long arc discharge columns (0.356 m) were generated under hypersonic flow conditions in the expansion-tube modified to operate as an expansion tunnel.

Gartrell, L. R.↗